Question about Mitsubishi Eclipse

1 Answer

Name of sencors that go into block of engine - Eclipse Mitsubishi Cars & Trucks

Posted by on

  • barb_y_2000 Jul 25, 2008

    the back of the block under the intake. there are 2 screwin sensors that go in these spots but i dont know what they are called to ask for them.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 702 Answers

It could be the oil pressure sending unit, the temp. sensor. Where on the block are you referring?

Posted on Jul 20, 2008

  • Lee Quiroz
    Lee Quiroz Jul 25, 2008

    One of them is the ECT (engine coolant temp.) sensor and the other is the coolant temp sending unit.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is a knock sencor. can show me an image inside the engin?


A knock sensor detects pre-ignition (ping). It is an engine protection device which retards ignition timing when pre-ignition is detected. Normally located on the engine block behind the exhaust manifold

Aug 13, 2015 | Cars & Trucks

1 Answer

1991 TOYOTA CRESSIDA FAILED CO AND NO ON EMISSION TEST WHY?


Most likeley is that your cat is broken /burnt out or old or simple thing being is that you o2 sencor is shot easy fix just buy new one and watch a video on how to replace o2 sencor

May 02, 2014 | 1991 Toyota Cressida

1 Answer

Where is the crank sencor on a 01 pt cruzer


the crank sensor is located in the transmission bell housing where the trans bolts to the engine block.its held in by one bolt and is a 2 wire round plug connector i believe.

Jul 30, 2011 | 2001 Chrysler PT Cruiser

1 Answer

How do i replace the crank shaft position sencor on a 92 olds cutlass 2.3


CRANKSHAFT SENSOR LOCATED ON THE SIDE ENGINE BLOCK NEAR THE OIL PAN.JUST DISCONNECT ELECTRICAL CONNECTOR GOING TO SENSOR . AND REMOVE SMALL BOLT HOLDING IT IN PLACE THEN REMOVE SENSOR.

Jun 10, 2011 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

Were is the crank shaft position sencor located on a 1992 licoln town car


The crankshaft sensor shoul or is located at front of engine bolted to the block . It senses the crank position so it is mounted where it can ,in close proximity of the pulley. Ned

Apr 22, 2011 | 1992 Lincoln Town Car

1 Answer

Oil pressure sencor unit where is it at on the motor


oil pressure switch is usually located near the oil filter. its a single wire connection. if not there look towards the rer on the side of the engine block

Sep 30, 2010 | 1997 Pontiac Sunfire

1 Answer

I need to know where the crank sencor in located at on a 2.0 motor for a 98 ford contour


Hi, the crank sensor is located on the radiator side of the engine in front of the transmission about half way down the block. good luck its s tight fit.

Aug 25, 2010 | 1998 Ford Contour

2 Answers

1998 corvette water temp get up to 225 to 230 befor fan come on. where are the cooling fan control sencors located, not the relays


Fan wires go to relay, than after relay, they go to engine temperature sensor located on the side of the block. There is another sensor usually attached to thermostat housing. This would be coolant temp sensor. You can test both sensors with an ohmmeter or multi-meter

Jun 03, 2009 | 1998 Chevrolet Corvette

1 Answer

Car will not turn over. commputer says correlation sencor A bk 1


your crank sensor is on the lower firewall side of the engine. It goes directly into the block and has one small bolt reataining it. I take that back. I thought car was an 02. 03 sensor is still on the lower side of the block but is at the front kinda above and behind the starter. 03 was more of a pain to get to. Hope this helps

Mar 26, 2009 | 2003 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...