Question about 1994 Cadillac DeVille

1 Answer

Starter we need to replace the starter but cannot see the bolts that are supposed to be removed to take the starter out.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

There is a plastic cover that has two 8 or 10 mm screws then you pull down ond out, then you will see two 15mm bolts.

Posted on Aug 01, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to I remove starter from 2001 2wd 2.0


180 degrees away on back of starter on top

Oct 10, 2014 | Cars & Trucks

1 Answer

Where is the starter located


The starter motor/solenoid is located to the left of the oil filter. you'll need to have the vehicle up on stands to access it. Remove two wires. Wire #1 is a clip. To release the clip, push down on the small release tab on the backside of the clip assembly and pull apart. Wire # 2 is connected to the solenoid. Pry off the protective cap with a small screwdriver and undo the nut (12mm). From there you're supposed to be able to acces the starter motor bolts from the back side of the bell housing. There are only 2 bolts, each 12mm as well. You will not be able to see the first one, as it is pretty hidden. You will need to use the 12mm socket to mark it. From under the car locate the bolt connecting the starter to the bell housing and place the socket on the other side. Now you can remove it from the hood side of the car. The other bolt will be located near a Transmission bolt. Now you can remove it from under the car. It is easier with 2 people.

Buy F150 Parts.

Jun 03, 2012 | 1996 Volvo 850

1 Answer

Removal and installation of starter of 2002 mercury mountainer


Here's the generic starter replacement directions.
Engine should be cool, parked on level surface. Remove negative cable from battery. Remove electrical connections at starter (Sometimes starter may need to be partially removed to access all electrical connections.) Remove any brackets, parts, or accessories that obstruct access to the starter motor mounting bolts. Remove mounting bolts and remove starter. Clean the mounting surface, and install new starter and tighten the mount bolts evenly. Replace wires on starter. Connect battery.
Good luck.

Nov 20, 2011 | 2002 Mercury Mountaineer

1 Answer

Remove and replace starter


Replacing starter is not a difficult job.The vehicle needs to be lifted up on jack stands.The starter needs to be accessed from under the car. --------- You need to remove the air filter housing and intake, and the battery and tray if you want to make it easy on yourself. Remove those first, then remove the top starter bolt before you go under the car.

Accessing the top starter bolt,sometimes takes time. The top bolt comes from the transmission side on top.
-----------
Click this link below to see diagram showing location of top bolt:--- http://technoanswers.blogspot.com/2011/10/how-to-replace-starter-on-2000-mazda.html --------- This will help.Thanks.Helpmech.

Oct 07, 2011 | 2000 Mazda Protege

1 Answer

Do you have a diagram of the engine of the 2002 Kia Spectra because I need to replace the starter


You don't need a diagram.Lift the car disconnect the battery and the wires to the starter solenoid remove the starter bolts and check the shims placement.Replacement starter is reverse to what is listed in removal

Sep 28, 2009 | 2002 Kia Spectra

1 Answer

Need to replace starter on a 1986 Camaro, but cannot get the old starter past the exhaust pipe.


Removing the starter
  1. Disconnect the negative battery cable.
  2. Raise and safely support the vehicle.
  3. Disconnect all wiring from the starter solenoid. Replace each nut as the connector is removed (as thread sizes differ from connector to connector). Note or tag the wiring positions for installation.
  4. Remove the bracket from the starter and the two mounting bolts. On engines with a solenoid heat shield, remove the front bracket upper bolt and detach the bracket from the starter.
  5. Remove the front bracket bolt or nut. Lower the starter front end first, and then remove the unit from the car.
These are the steps for removing the starter on the Camaro. Did you remove the bracket? Hope this helped and best wishes.

Aug 01, 2009 | 1986 Chevrolet Camaro

1 Answer

Need to replace the starter on the 97 mitsubishi Diamante, how hard is it to remove and replace ?


To replace the starter you need to;
) Note if you have an anti-thief system and now to reset it if the battery is disconnected.
) Note the radio station selections if they are not saved if the battery is disconnected.

Now
) Disconnected the GROUND connector on the battery.
) Disconnect the electrical cable on the battery.
) Remove the 2 bolts holding the starter on. Remove the harder one to reach first.
) Pull the old starter out.
) Insert the new starter.
) Replace the bolt. Insert the easier bolt first.
) Tighten the bolts.
) Replace the electrical cable.
) Reconnect the GROUND connector on the battery.
) Reset any radio, clock or anti-thief systems.
) Return old starter for a core charge refund.

May 25, 2009 | 1997 Mitsubishi Diamante

4 Answers

I need to pull and reinstall starter on '93 audi cs90


starters seem difficult, but can be accomplish relatively quickly. there friendly because you don't have to worry about belts and gaskets. My assumption here is that you know you need to replace the starter and you know where the starter is located.
first disconnect negative battery cable.
On the starter you will need to disconnect power and ground. then you can pull the bolts and remove the bad starter. Installation is reverse of course. Once installed and secure, always double check the gound connection. reconnect battery and off ya go. Time should 45ish minutes.

May 05, 2009 | 1993 Audi 90

1 Answer

Can't get the starter out of a 1991 Nissan pickup.


The second bolt is hidden way up and tucked in near the solenoid. You need to setup a ratchet with extensions/socket (14mm) combination that is just a little longer than the starter motor. If you just can't picture where the bolt is, then go down to the parts store and look at/purchase the replacement starter to see how it mounts up.
There are two bolts for the starter mount and one nut for the main starter power lead. There is one plug for the starter key switch.
Disconnect plug. Loosen lower bolt. Remover upper bolt. Remove lower bolt. Twist starter so you can remove main power cable nut (be sure to have disconnected the battery first!) Pull starter.

Apr 18, 2009 | 1991 Nissan Pickup

1 Answer

Need to replace starter im not mechanical incline. i know basic


Get a chilton manual online if you a DIYer and it will save you time and money..Basic step by step-Remove postive batt cable. locate starter, obtain new starter to see location of mounting bolts,remove starter mounting bolts,remove wires firrst if accessable if not starter will lower when mount bolts out ,then remove wires noting where they go. hookup wires and replace in reverse. note:some can be hard to get to-always handy to refer to a manual Good luck..oh replace positive cable when aal is tight and right...

Jan 20, 2009 | 1990 Nissan Pathfinder

Not finding what you are looking for?
1994 Cadillac DeVille Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...