Question about 2006 Saab 9-7X

1 Answer

How to change rear brake pads on 1991 saab 900 Hatchback

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I need to change front and rear brake pads on my Saab 9-7x. Any hot tips or suggestions

Posted on Dec 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On a 1997 Saab 900 S the rear brake pads have a pin through the pad from one side of the calapir to the other. Will these pins come out when the calpir is seperated from it's housing?


these pins are there to keep the pads in the calipers
they will have to be removed to replace the pads
if you undo the caliper mount bolts then the pins will stay in place to keep the pads in place when the caliper is off the disc.

Sep 08, 2015 | Saab Cars & Trucks

1 Answer

Fix emergency brake stuck


On 88-93 models the brake goes to the rear calipers. First you should release the brake and look at the little arms the cable attaches on each caliper. If the cable is moving but the arms are not, you need to replace the caliper(s). More likely you will see the cable is not moving, in which case the cable(s) need to be replaced. Swapping in parts, or trying to free up and lubricate existing parts will depend upon your skill set, time, and budget.

Apr 01, 2014 | 1990 Saab 900 Hatchback

1 Answer

Saab Ng 900 1995 difference of 50% on rear brakes


The low pads side indicate that the pads are dragging probably from the caliper not being free to move on the mounting pins. Possibly also that the piston in the other side is seized and there is no braking action on that side.

Feb 22, 2014 | Saab 900 Cars & Trucks

1 Answer

1995 saab 900 convertible turn signals and brake lights not working


Check your fuses, even fuses not associated with lighting. If all ok it is probably the muti-funtion switch on the steering column, It is the switch that your turn signal lever connects to.

Oct 03, 2012 | 1995 Saab 900

1 Answer

How do i change the brake light '01 saab 9-3


You will need to remove the interior panel on the hatchback door to access the light.

Dec 12, 2009 | 2001 Saab 9-3

2 Answers

How much should it cost to replace rear brake pads on a 2007 Saab 93?


I had just 35000 KM's on my 2007 9-3 Aero when the brake pads were gone - dealer wanted... wait for it.... $900 to replace just the rear pads and rotors. Dealer also said that Rotors MUST be changed every time the pads are on this car. Purchased new OEM pads and rotors from autopartsway.ca and did the install myself. Took just over an hour, and I am not that mechanically inclined. Dealer will tell you that you need a special compression tool to push the pistons in... I used a C-Clamp and a pair of vice grips (tighten the C-clamp a bit, and rotate the piston with the vice grips... takes quite a while, but is cheap and effective).

Oct 10, 2009 | 2000 Dodge Stratus

5 Answers

1990 SAAB 900S REAR BRAKE CALIPERS


Sorry, gentlemen; NO 'C' clamps should be used on the rear callipers of 1988 to 1993 and 1994 convertible SAABs! Unless you want to replace the callipers, that is...

There is a calliper adjusting screw, at the rear of the calliper, hidden behind the parking cable. Unhook and remove the parking cable from the back of the calliper. You'll see a hex head located on the back of the calliper, between the hook to attach the end of the parking cable, and the hole through the bracket where the cable passes to the front of the car. The hex head is most easily seen if you hoist the car; it's not the most obvious until you've found at it a couple of times, then you can do it by touch with the car on a jack stand and without getting underneath!

Remove the hex head bolt, about a 12 mm or so wrench/socket, and you can then get at the calliper adjusting screw to tighten or release it as appropriate; the adjusting screw has an internal hex head socket, use a 4 mm Allen key. Likely the adjusting screw will be a bit stiff; spray into the hole with penetrating spray and let stand a few minutes before trying the Allen key.

Good luck!

Jul 10, 2009 | 1990 Saab 900 Hatchback

1 Answer

How to replace the rear break pads in my 1997 Saab 900SE Convertible


Jack up the car and remove the rear wheels. Remove the Caliper pins/spring by pushing them toward the inside of the caliper with a drift.
Remove the brake pads by sliding them out. Push the caliper pistons back in with a large pair of channel lock pliers or a large C-clamp.
Refit in Reverse. Be sure to tighten the Alloy wheels to 86.6 ft lb and if steel wheels then to 67-78 ft lb.

Mar 29, 2009 | 1997 Saab 900

2 Answers

Brake lights on saab 900 2.3 95 model year


If there is no brake lite switch on the arm of the brake pedal then look to see if there are two wires hanging down with a plug on them, as perhaps the previous owner removed the brake lite switch with the intentions of replacing it and just never got around to it.

Oct 25, 2008 | 1995 Saab 900

Not finding what you are looking for?
2006 Saab 9-7X Logo

Related Topics:

417 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61037 Answers

rgbypoet

Level 2 Expert

161 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...