Question about 1990 Ford Taurus

1 Answer

1990 ford taurus

I cant find the timing mark

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Front of engine, between the harmonic balancer and the water pump

Posted on Dec 17, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Timing chain marks 3.5 ford taurus 2008


Here's a link to your timing marks and a free manual. Ford Workshop Manuals

Jun 03, 2014 | 2008 Ford Taurus

1 Answer

1990 taurus wont start. Battery voltage is 12.5. Has spark.Cranks, but seems like its bucking the starter. Replaced the starter,same problem. Cant find the timing mark to see if the gears are bad.


Sounds like your timing is off. With out hearing it it`s hard to say if it is valve timing or spark timing. Your car has a timing belt and it is possible that it has skipped a tooth which affects valve timing or you have a bad crank sensor which will affect spark timing. It would be best if you picked up a manual to check the timing belt and marks.

Jan 30, 2011 | 1990 Ford Taurus

1 Answer

1990 ford taurus wipers quit. tried a different wiper motor tried a new relay tried a new wiper switch.. What else could it be?


Try running yoor own ground wire directly to the wiper motor or the wiper motor mount,this woks 80% of the time.

Sep 17, 2010 | 1990 Ford Taurus

2 Answers

My 1990 Ford Taurus won't shut off after you get


the starter solenoid is bad. very common in the older ford vehicles. had the same problem with my 85 Crown Vic and it was the solenoid. its like a 10 dollar fix. if it sticks after you replace it then theres something wrong with your alternator backfeeding the solenoid, which is usually because it is wired wrong.

Feb 22, 2010 | 1990 Ford Taurus

2 Answers

Adjust (aim) headlights on a 1990 Ford Taurus


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Oct 13, 2009 | 1990 Ford Taurus

1 Answer

Need to time it not sure were timing marks are can anyone help


1990 FORD ESCORT 1.9L TBI SOHC 4CYL REPAIR GUIDE

Confirm that the timing mark on the crankshaft pulley aligns with the TDC mark on the front cover (arrows)

5fac911.gif


A sticker located on the timing cover identifies the timing marks and also shows the 0 degree mark on the crankshaft pulley

6136f60.gif


Good luck (remember rated this help).

Sep 18, 2009 | 1990 Ford Escort

2 Answers

1990 taurus enginelight on


you'll have to have a diagnostic test done to know. it's cheaper to buy a haynes repair manual at an auto parts store, $18 and you can do it yourself. the problem is usually a sensor.

Dec 06, 2008 | 1990 Ford Taurus

Not finding what you are looking for?
1990 Ford Taurus Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...