2000 Oldsmobile Intrigue Logo
Posted on Jan 30, 2011
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

When wipers are shut off they will come back up on vertical on the wind shield is there a park module ?

Answer This Question
  • Jeffrey Turcotte
    Jeffrey Turcotte Jan 30, 2011

    Hi, I don't have the wiring diagram, but looking at your motor, it looks like it's pretty self-contained. It has a circuit board inside, and the position feedback is usually with the motor anyway. So I'd say you need a new motor.

×

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Dec 18, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: Dec 18, 2011
Answers
2
Questions
0
Helped
568
Points
2

When you turn the motor off it goes into reverse and a cam brings the wipers down the rest of the way.
If you take your wiper arms off and the plastic cawing off, look at the wiper motor with the wipers in the intermediate stopped position. You will see a little tab that is out of place. You need to bend it back.
I use a hammer and a pry bar to tap it back.

The best place to see this is on a Chev Venture van because you do not need to pull the wiper arms off or anything hard.

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

  • Master 400 Answers
  • Posted on Jan 30, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points
All-Star:

An expert that got 10 achievements.
MVP:

An expert that got 5 achievements.
Vice President:

An expert whose answer got voted for 100 times.

Joined: Jan 25, 2011
Answers
400
Questions
1
Helped
230189
Points
1328

No the park mechanism is part of the wiper motor assembly. You will need a motor to repair.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Were is the fuse for a wind shield wiper on a 2002 ford ranger xlt
Fuse F2.16 30 amp . location inside the vehicle fuse panel . Also use's two relay's , wiper - run/park relay & high/low relay - location under hood fuse box . K-140 & K- 316 . The wiper / washer switch is an input to the GEM module , generic electronic module . The GEM module energizes the the relay's to turn on the wipers .
Read full answer
Apr 23, 2018 • Ford Cars & Trucks
0helpful
1answer

2006 Chevy silverado ,wind shield wipers do not shut off in off position ,everything worked normal except off position?.what's is the cause of that?.
If you turn off the key with wipers in mid-cycle, the wipers will stop right where they are. The wipers won't park till the next ignition cycle.
Read full answer
Feb 11, 2018 • Cars & Trucks
0helpful
1answer

I would like to know if the blower motor relay control wind shield wipers and back up lights
No, thye should all be on separate fuses.
Read full answer
Nov 07, 2013 • Chevrolet Cars & Trucks
0helpful
1answer

Wiper arms do not park correctly 1998 dodge ram.
You put the arm on the motor 180 degress out
Read full answer
Dec 17, 2012 • Dodge Dakota Cars & Trucks
0helpful
1answer

Where is the ecm located
back of the engine compartment on passenger side:

Removal & Installation

3.0L (VIN S) Engine
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Park the wiper pivot arms in the highest position on the glass.
  3. Disconnect the battery ground cable.
  4. Remove the three RH cowl panel clips and remove the RH cowl panel.
  5. Remove the clip on the water shield.
  6. Remove the three RH water shield screws and remove the RH water shield.
  7. Disconnect the powertrain control module (PCM) electrical connector and remove the gasket.
  8. Remove the retaining bolts and the PCM.
  9. To install, reverse the removal procedure.

3.0L (VIN U, 2) Engines
  1. Before servicing the vehicle, refer to the Precautions section.
  2. Park the wiper pivot arms in the highest position on the glass.
  3. Disconnect the battery ground cable.
  4. Remove the three RH cowl panel clips and remove the RH cowl panel.
  5. Remove the clip on the water shield.
  6. Remove the three RH water shield screws and remove the RH water shield.
  7. Disconnect the evaporative emission (EVAP) canister purge valve return tube at the intake manifold and position aside.
  8. Disconnect the powertrain control module (PCM) electrical connector and remove the gasket.
  9. Remove the retaining bolts and the PCM.
  10. To install, reverse the removal procedure.
Read full answer
May 13, 2011 • 2002 Ford Taurus
0helpful
1answer

Cannot get the wind shield wiper motor back in the wind shield wiper stops in the middle of the wind shield
this is normally caused by a bad wiper motor or binding of the wiper gears and linkage arms.
check to see if the linkage arms are tight and not loose. also try and lube up the pivot points.
another thing to check is to make sure you have 12 volts to the heater.

c...
Read full answer
Jan 02, 2011 • 2000 Ford Windstar
0helpful
1answer

Wind shield wipper handle wont stay in place it broke how do you fix it
Hi there,

Well you can please follow the below steps -
1. Lift the wiper arm away from the windshield. If the tension spring is damaged or broken, the arm will not show resistance. If it is functioning properly, then pull the arm back until the hinge locks in a vertical position.
2. Remove the retaining nut at the base of the windshield wiper arm and pull the wiper arm off.
3. Slide the new wiper arm assembly on.
4. Tighten the retaining nut and lower the arm back down to the windshield.
Please post comments for any other help or information......

Good Luck!!

Thanks
Read full answer
Mar 26, 2010 • 1999 Chevrolet Silverado 1500
3helpful
2answers

Wind shield wiper
Check to see if the stud that they sit on is not spinning . Make shure that they are tight. Start by parking your wipers. then loosten the wipers and put them back on where they should be parked and tighten them up this should fix the problem . If not you may need to buy new motor unfortunatel. I hope this helps. Don't forget to rate my answer. thanks.
Read full answer
Feb 11, 2009 • 2000 Buick Regal
0helpful
1answer

Wind swind shield wipers want cut off
Sounds like a stuck relay inside the windshield wiper module. It is actually called a "Cover" which is attached to the windshield wiper motor under the cowl.
Read full answer
Nov 16, 2008 • 1998 Pontiac Sunfire
0helpful
1answer

Back wind shield wiper
i hope this video help you with your problem!
Read full answer
Oct 09, 2008 • 2004 Toyota Sienna
Not finding what you are looking for?

View Most Popular

2000 Intrigue

  • Cars & Trucks

Related Question

Were is the fuse for a wind shield wiper on a 2002 ford ranger xlt

  • Ford Cars & Trucks

Related Topics

495 views

Ask a Question

Usually answered in minutes!

Popular Questions

Code to program my key fob

1999 Oldsmobile Intrigue

Remove right rear door panel

1998 Oldsmobile Intrigue

NEED 1999 olds intrigue serpentine belt diagram

1999 Oldsmobile Intrigue

Driver's side turn signal light keeps burning out

1998 Oldsmobile Intrigue

Crank position sensor location

2000 Oldsmobile Intrigue

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. 2000 Intrigue Manual

2000 Intrigue

Loading...