Question about 1995 Mitsubishi Eclipse

1 Answer

Coil overs I have a 1955 Eclipse and i was needing to know how to install the coil overs that i bought for it. If you could give me some feed back id really appreciate it.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 87 Answers

I think you mean 1995 . Anyway there should be a band that came with it it has two hole's in one at one side and one on the other. some times your kit will come with two of these "C" shaped bands because on the eclipse.there are four bolt holes in the coil itself. now it is located in the top of the motor on the 2.0 motor both turbo and non turbo. Its the black ugly thing with four wires sticking out of it . just put the coil cover over this ugly thing and c
screw it down. Good luck man.

Posted on Jul 21, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1955 olds 88 hei ignition wiring to key and ignition system

Original system has a resistor wire between coil + and ignition key, to reduce voltage and thus increase amps to give fatter spark and increase fuel mileage. For HEI system, this resistor wire must not be used, so run new primary wire straight from switch "run" to coil +. There should already be a wire from the starter solenoid to the coil + to supply full 12 volts when cranking to give higher voltage spark to plugs to help jump the gap better for use while starting. The MSD web site has much more info.

Jul 05, 2016 | Cars & Trucks

2 Answers

I bought a 98 vw jetta glx vr6 2.8 it has been parked for 2 years untouched due too previous owner installing ignition coil wrong and short circuiting it. once i bought it i installed the ignition coil...

Try depressing gas pedal halfway. If that helps it start, then check out the engine coolant temp sensor. If the sensor is off or corroded, the computer won't feed enuf gas.

Jun 29, 2017 | Volkswagen Jetta Cars & Trucks

1 Answer

I'm locked out of my Eclipse Stereo!

Go to the dealer and give them your VIN#. They will give you the code.

Apr 28, 2010 | 1998 Mitsubishi Eclipse

1 Answer

Do not know where all the marks need to be on a 91

Unfortunately my manuals do not go back beyond 1`993 so I ma not a lot of help. I saw your later posat saying you bought a Haynes manual and they did not show the timing marks. I ususllly tell folks to buy the hyanes manual but being that did not help I did some web surfing. All I found was: from but it did not really answer the question.

Tell me what engine does you truck have in it and may be I can find something on the engine rather than the vehicle.

Feb 16, 2010 | 1989 Mitsubishi Mighty Max Macrocab

1 Answer

Mitsubishi eclipse radio code

take the registration and a picture ID to a Mitsubishi dealer and they can give you the code and show you the procedure to install the code.

Feb 13, 2010 | 2000 Mitsubishi Eclipse

1 Answer

Turns over then dies right away.

check spark plug wires to make sure they"re not miss-routed... start at the coils and work towards the plugs make real sure its got correct firing order sequence... it is usually posted on a label under the hood of most cars and also make sure they have a real good snap on connection both on coil and plugs and that the terminal posts on the coils are really clean! if this doesn't fix the problem then it probably is a timing chain might not be installed correctly. good luck to you! i hope its just a miss wire.
can you give me some feed back..i'm curious..thanks! a 40k mile car shouldn't need this kind of work..its practically brand new!!

Sep 30, 2009 | 2003 Chevrolet Impala

1 Answer

Need to know how to install new radio in a 2001 mitsubishi eclipse

call 1888mitsu2001 and hit option #4, then hit * (star), give them the last 8 digits of your vin and they will provide the code for FREE.


May 09, 2009 | 2001 Mitsubishi Eclipse

Not finding what you are looking for?
1995 Mitsubishi Eclipse Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides