Question about 2001 Chevrolet Monte Carlo

1 Answer

Oil pan i have 01 monte that has stripped oil pan drain plug. Does the engine have to be lifted change pan

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 640 Answers

You dont need to change the oil pan.Goto an auto parts store and ask for a universal drain plug.They come in a red package and the word 'HELP' on them.

Posted on Jul 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change my oil?


Remove filler cap,
lift car
then from under the car remove oil pan drain plug.
Allow oil to drain into an oil waste pan.
Change oil filter also ..located under skid plate..use filter wrench to remove filter. Be careful as filter is full of oil ..drain in waste pan
wipe filter mounting plate clean..put a thin coating of oil on new filter gasket before spinning it on to the mounting plate..hand tighten and then tighten about 3/4 more turn.. reinstall drain plug. do not over tighten or you can strip the threads. Install correct viscosity and amount of oil start engine. let run to get pressure up. shut off engine, check level with dipstick and close cap....you are done.

Feb 12, 2015 | 2010 Nissan Frontier

1 Answer

How do i replace oil pump on 01 monte carlo ss


If the oil pan will clear the steering components without jacking up the engine then drop the pan and unbolt the oil pump. You'll need to get a new pan gasket for the oil pan too.

Sep 25, 2014 | 2001 Chevrolet Monte Carlo

1 Answer

How do iremove oil pan 01 montecarlo


OIL PAN
Removal & Installation
1. Disconnect negative battery cable. Remove engine torque strut. Raise and support vehicle. Drain
crankcase. Disconnect oil level sensor electrical connector. Remove oil level sensor and oil filter.
Disconnect front exhaust pipe from manifold. Remove right front wheel and splash shield.
2. Disconnect oil cooler pipes. Disconnect A/C compressor electrical connector. Remove A/C compressor,
and position aside. Disconnect engine mounts from frame.
3. Remove flexplate access cover. Use transmission jack at transaxle to raise engine. Remove oil pan bolts
and oil pan. To install, reverse removal procedure. Install oil level sensor after oil pan is installed. Tighten
retaining bolts to specification. See TORQUE SPECIFICATIONS.

Sep 25, 2014 | 2001 Chevrolet Monte Carlo

1 Answer

How much to change the oil pan on 2006 dodge charger sxt


You can purchase universal drain plugs at about any parts store that are designed to repair stripped out pans. They have a bar with a nut that fits into your drain hole and a plug seal that fit around the drain hole. This is the cheapest way to permanantly fix your problem.

Aug 27, 2014 | 2006 Dodge Charger

1 Answer

Oil pan


Hi Gerti ,
It is very easy , First lift the vehicle through jack or hydraulic lift and drain the engine oil in a pan and arrange a new engine oil filter and oil as it is better to replace( u can use the same if it is not very old). U can drain the oil by removing the drain plug ( keep it for around 1 hour so that oil from the gallerias also drain out).
After 1 hour remove the oil pan by removing all the bolts from engine and replace with the new one.
Top up the engine oil by removing the dip stick and your car must be fine.
Thanks

Apr 27, 2014 | Chrysler Pacifica Cars & Trucks

1 Answer

Hi. I have 2007 Mercedes GL450 , Can you help me with oil change and oil filter change.Please tell me How to do it properly? The nearest Mercedes service is over 500 km. thanks alot, A


BEST TO LET DEALERSHIP CHANGE ENGINE OIL.YOU NEED A DEALERSHIP OIL FILTER.YOUR OIL FILTER INSIDE A HOUSING ON FRONT SIDE OF THE ENGINE. CHANGING YOUR OWN OIL NOT HARD.YOU NEED 9 QUARTS OF OIL LOOK INSIDE GLOVECOMPARTMENT FOR OWNERS MANUAL TO SEE WHAT TYPE OF ENGINE OIL YOU NEED TO USE AND HOW MANY QUARTS.IF YOU DONT CHECK READ MANUAL TO SEE WHAT OIL TYPE AND QUARTS YOU NEED. IF YOU BLOW OR DAMAGE THE ENGINE WARRANTY WILL NOT COVER THE ENGINE.FIRST OF ALL TO CHANGE ENGINE OIL YOU CRANK VECHICLE UP LET IDLE FEW MINUTES TO THIN OUT OIL THEN YOU TURN OFF ENGINE. YOU NEED TO RAISE VECHICLE USING THE FACTORY JACK.USE JACK STANDS. LOOK IN OWNERS FOR CAR JACK LIFTING LOCATIONS TO KEEP FROM DAMAGING ROCKER PANELS. AND PLACE A DRAIN PAN UNDER THE OIL PAN. UNDER THE VECHICLE.YOU NEED A WRENCH TO REMOVE OIL PAN DRAIN PLUG.WHEN ALL THE OLD OIL DRAIN OUT IN THE DRAIN PAN.SCREW BACK IN THE DRAIN PLUG TIGHTEN IT DONT OVER TIGHTEN STRIP THREADS.THEN YOU NEED SOCKET TYPE OIL WRENCH YOU USE WITH A 3/8 RATCHET WRENCH REMOVE OIL FILTER HOUSING.PLACE RAGS AROUND THE OIL FILTER HOUSING TO CATCH OIL SPILL. YOU WILL NEED TO GO TO THE DEALERSHIP FOR THE OIL FILTER AND FILTER HOUSING O RINGS. ONCE YOU GET NEW OIL FILTER AND O - RINGS INSTALL THEM IN THE OIL FILTER HOUSING.LOCATED OIL FILLER CAP ON VALVE COVER UNDER THE HOOD.REMOVE OIL FILLER CAP.POUR OIL IN ENGINE USING A FUNNEL.ENGINE HOLDS ABOUT 8.5 TO 9.0 QUARTS OIL. BUT LOOK IN THE OWNERS MANUAL CHECK HOW MANY QUARTS ENGINE NEED.CHECK OIL DIP STICK OIL LEVEL SHOULD BE ON THE FULL MARK ON THE ENGINE OIL DIP STICK.TO BE ON THE SAFE SIDE BUY 10 QUARTS OF OIL FOR A EXTRA.DONT OVER FILL MAKE SURE YOUR OIL LEVEL CORRECT.OIL DRAIN PLUG AND OIL FILTER TIGHT BEFORE CRANKING THE ENGINE.LOOK IN THE OWNERS MANUAL FOR OIL DIP STICK AND LOCATION.

Nov 05, 2010 | 2007 Mercedes-Benz Mercedes Benz Gl 450

1 Answer

How to change oil in my 2005 chevy monte carlo


If you jack the car up dead center on the oil pan is the drain plug. The filter is visible soon as you pop the hood in front of the engine(even though its side ways)

Jul 10, 2010 | 2005 Chevrolet Monte Carlo

2 Answers

I want to change my own oil. what side is the oil pan on?


If you do not know where the oil pan Is I would really consider getting help with your first oil change. The pan is on the bottom of the motor and has a plug on the bottom of it which is used to drain. The key is not to over tighten/strip the plug when putting back on. Make sure the oil filter is changed and tightened properly. It is def not a bad idea to have a 2nd person so assist for your first oil change!!

Feb 28, 2010 | 1995 Chevrolet Tahoe

3 Answers

I got an 01 concorde LXi 3.5 L need oil pan


they make oil drain plug repair kits for this problem, contact NAPA or Carquest for detailes, no need to replace the oil pan.

Jul 16, 2009 | 2001 Chrysler Concorde

Not finding what you are looking for?
2001 Chevrolet Monte Carlo Logo

Related Topics:

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...