Question about Mitsubishi Mirage
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!
Posted on Mar 15, 2009
SOURCE: CD PLAYER CODE LOST
If it is a factory radio you will have to remove it> call your local mit dealer and give them the # on the back of the radio. They will tell you the code.
Posted on Mar 28, 2009
Might want to look for vacuum leaks. Most misfires that go away with gas are caused by manifold vacuum leaks. The cat code can also be caused by the vac leak. There are different methods to find them and not real easy-but one way is to get a can of carb cleaner spray and spritz around intake areas. When the carb cleaner finds the leak--the car will run good for just and instant. Could be a rubber line or a manifold gasket. Hope it helped. Thanks
Posted on Apr 06, 2009
Don't know how much this will help, but some factory radios have a tool that is shaped like a big staple and there is 2 of them. If you see 2 small round holes on the sides of your factory cd player, then thats where these tools go. I have seen them at Wal-Mart and at Autozone. I have mainly seen these on Ford cars, so I'm not sure about a Mirage. Hope it helps.
Posted on Dec 31, 2009
Tips for a great answer:
Jun 11, 2017 | 2000 Mitsubishi Mirage
Apr 10, 2011 | 2000 Mitsubishi Mirage
Feb 10, 2010 | 2000 Mitsubishi Mirage
Dec 31, 2009 | 2001 Mitsubishi Mirage
Jun 13, 2009 | 1999 Mitsubishi Mirage
May 26, 2009 | 2000 Mitsubishi Mirage
Oct 11, 2008 | 1997 Mitsubishi Mirage
Jan 16, 2018 | Mitsubishi Cars & Trucks
240 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: