Question about 1999 Oldsmobile Aurora

Open Question

Security system on my 99 Aurora the keys don't open the doors, key fabs dont work. whenever I open a door or turn it on the horn honks for two minutes and then it stops. Any ideas?

Posted by on

6 Suggested Answers

leethedeuce
  • 4472 Answers

SOURCE: 1998 Oldsmobile Aurora Lighting problem-car

sounds like there is a short somewhere. you need to start checking things with a multi meter, could be a bad switch. I would recommend picking up a factory service manual for your vehicle off of ebay. If you need any further assistance let me know.
Thanks,
lee

Posted on Aug 02, 2008

emissionwiz
  • 60792 Answers

SOURCE: 99 olds aurora pass key problem

There is most likely a problem with the tiny sensor in the ignition lock cylinder, it is not reading the key chip and locks u out, the problem is u can't just replace the lock cylinder u need a dealer only re-programm of the pass key system since the control module will not recognize the new lock code, catch 22 if u ask me. Do u have more than one key for the car? do both do this?

Posted on Jan 16, 2009

  • 30 Answers

SOURCE: 99 Oldsmobile Alero Door Locks

that's probably just bad spares. try going to a different store to have them cut (hardware stores are a good place to go) or you could go to a gm dealer too.

Posted on Jan 24, 2009

emissionwiz
  • 60792 Answers

SOURCE: Security System on 2002 Oldsmobile Alero

the most common cause of this is the key, to check this use another working key, if the problem persists the ignition lock cylinder sensor is defective and the lock cylinder must be replaced, the dealer will need to do this as the security system must be re-programed to accept the new key code.

Posted on Feb 09, 2009

csmock132
  • 4669 Answers

SOURCE: 97 Olds Aurora

That means it is passkey. There are 15 different resistance values that could be used to run your car. Do you have the original key that started your car with the old lock cylinder. If so take that key to a lock and key shop and the new key, the locksmith can measure the resistance of your old key, get the right key blank, then cut that key the same as the one that fits your new lock. Then you should be good to go. If you don't have the original key, it is alot harder. Let me know. I can tell you how to fix that too.

Posted on Mar 05, 2009

alicantecoli
  • 21949 Answers

SOURCE: Can I bypass the Passlock security system?

never heard of this happening before ,sounds more like the code reader behind the steering lock is playing up.If it is then its dealer only,have a funny feeling this could be an expensive repair.Sorry i couldnt be much more help but this fancy electronic stuff is designed to stop general mechanics like myself from doing repairs.

Posted on Mar 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reset key fob


Unlock all doors, foot on brake, all doors closed. Cycle key quickly but carefully on-off appr 10 times until the car honks one time.

Do not turn the key far enough to start the car, just to the 'on' position so the dashboard lights up.

When the horn honks, open and close the driver's door, press any remote button and that's it.

Program another remote? Quickly open and close the driver's door again and push a button on the 2nd remote. That's it.

When you're done, remove the key and the horn should honk 3 times. You're all set.
Sometime it takes more than 10 on-offs to set program mode. Open/close the door, lock/unlock etc, wait 10 minutes, then try again

Jul 22, 2014 | Subaru Outback Cars & Trucks

1 Answer

Expedition door lock


Replace the battery on the key fob! Also, it may need to be reprogrammed by the Dealer!
Dr. Gene n Landrum

May 19, 2013 | 1999 Ford Expedition

1 Answer

2000 tahoe horn honks when driver door is open with key. Keyless entry is not working.


(Inside the drivers door on the door latch is a switch called the door ajar micro switch, it is defective. With no signal from this switch the system triggers the alarm system. You must have this switch input checked, it can be the switch or the wiring to it that is defective.

Jun 27, 2012 | 2000 Chevrolet Tahoe

1 Answer

Please can someone tell me why my door key will not disarm my 1996 olds aurora factory alarm system


Hello! There is a "pellet" in the key...A resistive pellet...Question is, have you tried another key? If more than one key has the same fault the ignition key cylinder is defective...Or the connector plug to the cylinder has dirty or broken pins/wires...However if it is just that one key a trip to the dealer to acquire a new one is in order...That connector has two wires...Colors are...Purple/White and White/Black...Send a comment...Guru...saailer

Feb 11, 2012 | Cars & Trucks

4 Answers

How do I disable the alarm system for my 2006 Chevrolet Cobalt? Every time I unlock the doors and open them, a short honk beeps in 1 second intervals, and then after ten seconds proceeds to the full...


If you lock your doors with the remote, you have to use the remote to unlock them or it set off the alarm. I don't know why the manufacturers designed it that way(kind of stupid)but it's programmed into the on board computer. You can't disable the alarm without creating a worse problem somewhere else.

Jan 02, 2011 | 2006 Chevrolet Cobalt

1 Answer

I bought a new Keyless remote for a 2007 Forester from a Subaru Dealer to replace an original one that went bad after 2 years. I have followed the directions in the owner's manual to program it, but can't...


IMPREZA: 2005, 2006, 2007 and
FORESTER: 2005, 2006, 2007, 2008
Check for Immobilizer key on Forester XT models only.
information is always subject to change and correction imp05keylessremote1.jpg
new remote for 2005 Imprezas.
This is not the same remote as the 05 Legacy/Outback remote which also has truck/gate release on the front and a red panic button on the back.
Lock: press Lock button for 2 seconds or so to lock car, and arm optional security system. The car with chirp once and turn signals flash for locked, 5 short chirps and signal flashes if any door is not fully closed. The dome light goes on for 15 seconds and ignition key ring (if present) will light for 30 seconds when unlocked.
Unlock: press unlock one time for driver's door, press again within 5 seconds to unlock all doors inkling rear gate (wagon). The system does not open the trunk.
Panic mode: press and hold lock button for approx. 3-4 seconds to activate Panic mode. I panic model the horn honks and turn signals flash until either the lock or unlock button is pushed again.
Finder mode: Press lock button 3 times within 5 seconds to activate Vehicle Finder mode. The horn will honk once and the turn signals will flash 3 times
Distance: works within approx. 30 feet depending on battery strength, nearby concrete walls and etc.
Audible Chirp On-Off: the system will chirp when locked or unlocked. To turn OFF the chirps, unlock the door and then push both lock and unlock buttons at the exact same time for 2+ seconds. There will be 2 chirps indicating the the audible is off. To turn the chirp back on, repeat the process and the system will chirp one time when it is back on.
Battery: as the battery ages it will only work as you get closer to the car. When a battery is replaced, the transmitter must be re-synchronized with the Keyless control unit. To synchronize, press the lock or unlock button 6 times.
Programming: 4 codes may be programmed.
Sit in driver's seat and unlock all doors. Open and close the driver's door
Turn the ignition key from LOCK to ON position 10 times within 15 seconds. Be sure to stop at both lock and on. The horn will HONK once to indicate transmitter programming mode is activated. Leave key in LOCK position and don't remove it from ignition.
You now have 45 seconds to complete the programming as below.
Open and close driver's door again.
Push either lock or unlock button on the remote you want to program. The horn will honk 2 times when successful.
To continue and program other remotes at the same time: open and close the driver's door and push lock or unlock on the remote. The driver's door must be opened and closed between each remote you want to program.
Done programming? remove the key from the ignition and the horn will honk 3 times.
DELETE old codes? Reprogram 4 times, it will overwrite old codes.
Alarm Security System: optional on all models. When locked there is one chirp (can be turned off, see above), the turn signals will flash and the red 'security' light will start to flash once every 2 seconds except for STi which flashes twice every 2 seconds.
There will be 5 chirps if a door, hood, and trunk or gate is not fully closed
You can also arm the system by using the power lock button on the driver or passenger door as you get out of the car and then closing the door behind you.
Disarm the system: push unlock for 2 seconds
Lost remote, alarm activated? When you can't use a remote to turn off the system: open the door with a key or try to start the car and the horn will start to honk. Turn the key on-off 3 times within 5 seconds and the alarm will go off and you can start the car. It's simple!
VALET mode: To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds. The red 'security' light will then flash 2 times a second until the car is turned on.
System has been Tripped (except for STi): if you unlock the door with the remote and it chirps the signal light flash 4 times, the system has been triggered;
Identification mode: To find out what happened and why the system was triggered:
Open and drivers door, leave it open. Turn ignition key from LOCK to ON 2 times and then leave in LOCK position.
Tripped code: 1 security light flash: a door has been opened, 3 flashes when the impact sensor was triggered, 4 flashes when the ignition was messed with or battery disconnected

Nov 19, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

1 Answer

1995 Buick Riviera SC: traction and the security light


traction switch is located next to drivers left knee on bottom of dash....you should be able to turn off the traction light there by just turning on the traction control.....the security light is telling you that there is a problem with your security system....could just need a new key with a new computer chip....make sure the key is clean and dry when using so it can read the chip....the security light comes on whenever your start the car and stays on for approximatley 2 minutes and then should go out....it is just a reminder....try this and see if it works....lock the door using the power switch on door.....close door and see if the security light comes on....watch and it should go out after about 2 minutes...if it does then your alarm is activated and working....to disarm you need to unlock the driver door with the key...anything else will set the alarm off and the lights will start flashing and the horn honking...after you set the alarm off you will always have to use the key to unlock the drivers door to turn off the alarm and reset the security system.

Jul 30, 2009 | 1995 Buick Riviera

1 Answer

When I lock the door on my 99 dodge durango with the keyless remote the horn won't honk. But if I push the panic button the horn does honk. How can I get the horn to honk when I lock the doors?


Look in your manuel, there are steps to change the Key less remote setting to customize it the way you'ld like the car Key less system to work.
Good luck and hope this helps, if your still having problem. Just drive the Dodge dealer and ask the Service adviser to help you out, he or she would be more then happy to reprogram the key less system for you.

May 13, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Oldsmobile Aurora Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...