Question about 2000 Ford Focus

1 Answer

Winstar 2001 missfire no 6 cyl under load intermitent

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Get spark plugs and leads checked or replaced

Posted on Jul 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

09 accent cyl 4 missfire, plug injetor coil all ok cyl comp test all within spec. changed pcm old one stopped workin alltogether. all no change,intermittent missfire


SWAP COIL LIKE FROM CYL NUMBER 1 TO 4 AND ROAD TEST UNDER LOADS IF CHANGE THE MISS TO CYL NUMBER 1 NEED A COIL OR BAD PLUG AT CYL NUMBER 4

Sep 02, 2014 | Cars & Trucks

1 Answer

2005 forf tauras missfire


Professional Scan Tool in Mode $06 ?

On a 2005 Ford I would say ALL of the ignition
coils are bad,they don't last more than 6 to 7 years

Not all coils show up as an OBD PO 300 Code or Mode $06
Misfire,some just spike the PCM at will & drive you crazy

All you can do is walk a new coil or replace them all

Mar 28, 2014 | Ford Taurus Cars & Trucks

1 Answer

My 2006 chevy malibu Maxx runs great, but about once a week starts hard.


The first test will be to see which cyl the missfire is coming from. When you have isolated the cyl first rem the plug and swop it out with a new one.If the problem is still there the inj of that cyl must be removed and tested for over fueling. If the missfire cant be isolated to a specific cyl you can check the water temp sensor which if faulty will cause the injection system to over fuel under certain conditions.

Aug 19, 2012 | 2006 Chevrolet Malibu Maxx

1 Answer

Why is scanner showing DTC P01365 Ingnition Coil #5 Control Circuit Low Voltage and have Missfire on #1 cyl


because you have a bad #5 coil, and a bad plug in the number one cylinder.
Or because your wires are leaking would do it too.

Oct 28, 2011 | 2001 Oldsmobile Aurora

1 Answer

How do i fix the code i got PO302.


change spark plugs. cyl #2 missfire

Jul 20, 2010 | 2001 Kia Sephia

1 Answer

2001 Sebing 2.7 intermitent missfire no engine light and two code scaners both read '' no conection to Vehicle found''.


Check your battery negative cable connection. Check your chassis and engine grounds. Unplug your cam sensor and see if your misfire goes away. If it does, replace it.

Mar 28, 2010 | 2001 Chrysler Sebring

2 Answers

I have 1999 318 4x4 dakota with fault coads


These are misfire codes.This means that your vehicle is missing.The 300 is a random misfire and the 305 is for cylinder 5,and the 306 is for cylinder number 6.Check the plugs if they are good then you could have bad coils.They are top of the plugs.Hope this helps.Good luck.

Feb 25, 2010 | 1999 Dodge Dakota

1 Answer

Hi all, my 99 sub.350,300k,missfire #2


Have you checked the distr cap for cracks??

If plug is oily looking on brand new plug I would suspect worn rings, which would also explain the high PSI. (Motor job in the wind) Especially for 300K.



Dec 03, 2009 | 1999 GMC Suburban

1 Answer

I have an Audi A4 2001 2.0 lt. the engin management system keeps flashing. i did a full service at Audi but did not solve the problem, the cars runs fine and starts fine. when the car is still i could feel...


when the eml lght flashes it is normally detecting a missfire but could be an intermitant missfire as vw's also do this

you need to have the car read with a diagnostic computer

hope this helps

svs
07923 479640

Jun 13, 2009 | 2001 Audi A4

1 Answer

2002 grand am 3400. # 5 cyl missfire


It sounds like the problem is isolated to that one cylider if that is the case you may want to check the compression on that cylinder if it is not electrical and no fuel problems it has to be lost of compression

Mar 15, 2009 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...