Question about 2002 Nissan Sentra

2 Answers

Stearing gear how to change the stearing gear on a 2002 nissan sentra 4 cyl 1.8 engine

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,066 Answers

You are talking about a new rack and pinion.  Get a rebuilt one or one from the junk yard.  Have the car aligned after you replace the R&P
Is the old one sticking?

Posted on Mar 23, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Nissan Master
  • 705 Answers

Why do you need a steering gear?? haven't replaced one.

Posted on Jul 23, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 Nissan Sentra runs fine for about 2 miles then starts losing power and dies wont start back up for about an hour


Check Engine Light/Loss of Power Due to Throttle Body Unit ...

repairpal.com > Problems > Nissan > Sentra
The electronic throttle actuator (throttle body) can fail causing a loss of power ... start it studders like it is running on 2 cyl. then switches to 3 cyl. then to 4. but ... Throttle body replaced on my 2006 Nissan Sentra 1.8 engine. ... I Was going up a hill and I tried to speed up, all of a sudden my car bogs down and completely dies.

Nov 17, 2015 | Nissan Cars & Trucks

1 Answer

HOW HARD OF A JOB IS REPLACING CRANK SENSER ON 2004 NISSON SENTRA


on a 4 cyl is very easy, Nissan recommends replacement of both the crank and cam sensor together, but the crank sensor is in the back of the engine, near the transmission bell housing under the engine mount bracket. the cam sensor is in the back of the cylinder head and both have 1 bolt each, 10mm.

Nov 06, 2014 | 2004 Nissan Sentra

1 Answer

How do I reset engine oil light on a nissan sentra 2012?


Usually requires replacement of oil sensor located on the block of the engine. Usually a round thing about size of a silver dolly with 1/4 inch pipe plug threaded into block and two wires connected to harness.

Sep 19, 2014 | 2012 Nissan Sentra 2.0 Sedan 2.0L 4-cyl....

2 Answers

Is wiring harness on 2003 nissan altima interchangable with any other nissan


As far as the crank sensor plug they are the same on those,altimas. and i think sentras too. i would take the old one or sensor with you and check other nissans,

Aug 03, 2012 | Cars & Trucks

2 Answers

2002 Nissan sentra GXE has a code p0350


call nissan give them the vin number thers a recall on the cam and crank sensors do that first
if the recall has been done and ther are no sensor codes find the missing cyl.move the coils around to see if the mis follows if not check batt volts green/white wire good ground at the black/yellow wire after that you need a lab scope to look at the wave pattern of each coil.ther should be 2-4 volt sawtooth pattern all the coils should look abought the same.

Feb 12, 2012 | 2002 Nissan Sentra

1 Answer

2002 nissan sentra gxe 1.8 bank2 sensor1 federal emission.Which sensor do I replace?Top/bottom,driver/pass side?


The 1.8 is a 4 cyl. engine . it has only 2 oxygen sensors . Nissan engine controll systems devides its EGO sensors into banks . Bank 1 is the upstream (top before the catylyctic converter) . Bank 2 is the downstream (after the cat. conv.) I recomend you change both for emissions reasons

Jan 15, 2010 | 1996 Chevrolet K1500

1 Answer

Where do you install the power stearring fluid on a 2002 nissan sentra


if you look in the engine bay the power steering fluid should have a yellow or green top it also should be marked powersteering fluid resivor

Oct 28, 2009 | 2002 Nissan Sentra

1 Answer

2001 Sentra Engine Throttle Not Responding


COULD BE ACCELORATOR CABLES LOOSE OR YOUR THROTTLE PLATE NEEDING REPAIR

Jun 17, 2009 | 2002 Nissan Sentra

Not finding what you are looking for?
2002 Nissan Sentra Logo

114 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...