I have a 2005 kia rio trying to replace the crankshaft seal and am having trouble finding a crankshaft gear puller any thoughts

Kia Rio Crankshaft Position Sensor Replacement

replaced crank and cam sensor [Archive] - Sorento Nation - KIA ...

www.sorentonation.com/forum/archive/index.php/t-913.html

20 posts - ‎6 authors
replaced crank and cam sensors put back together cranked up very rough idle some tapping any ... 12-17-2012, 12:24 AM ... It's a 2006 3.5 Kia Sorrento. ... I found theproblem the SUV has a aftermarket alarm and remote start system I tripped ...

Kia Rio Crankshaft Position Sensor Replacement - YouTube

? 4:44
https://www.youtube.com/watch?v=hihQxMWuSFY
Mar 21, 2014 - Uploaded by Jason Roush
While looking for how to replace a Kia Rio crankshaft positionsensor, ... is on and i have a P0340 code, think this is theproblem? kia rio 2002.

Kia Sorrento/Sedona: 3.5 Litre Engine/Timing Belt/Crank ...

? 20:23
https://www.youtube.com/watch?v=CjaD_zYPrUA
Mar 29, 2014 - Uploaded by JamieJones TheCarMan
Repair and/or Replacement tips for timing belt, crank sensor,cam sensor, water pump and drivebelt ...

Crankshaft position sensor - 2003 Kia Sorento - RepairPal

repairpal.com > Questions > Kia > Sorento > 2003 Kia Sorento

Sounds like a heater core to me, does it smell a little like antifreeze?

Did you do a crank relearn ? Could be a wiring issue , control module problem etc... Testing electrical circuit first , video's on youtube , all you would need is a DVOM - digital volt ohm meter . P0335 Kia Crankshaft Position Sensor Circuit c Replacing Crankshaft Position Sensor Code P0335

the valves are stopping the piston from rotating,or the engine is seized up. was the belt bad? your motor could be ruined.

need to have the car scanned for the trouble code some auto stores such as auto zone / advanced auto scan for free check ur local area the trouble code will give u a start point towards solving ur problem

Check Engine light is on. Find out what DTC (diagnostic trouble code) is set and I can help you more. You can get a code puller from your local parts store.

Maybe you could try this :-

http://www.tradebit.com/filedetail.php/9001767-kia-rio-repair-service-manual-2001-2005-2001

It costs but may show you.

On 2001-2005 vehicles the crankshaft sensor is mounted on the front of the transmission case adjacent to the flywheel.

Please rate and god bless:)

you need a gear puller to pull the gear off. but to change the seal for the crankshaft, you only remove the timing gear and change the seal on the cover that you removed. there is nor need to pull the gear itself. if you pull the gear, you still can't change any other bearings or seals without removing the heads and manifold.