Question about Hyundai Accent

2 Answers

Change rear stop/tailght bulb do i have to take cover off or is there quick release somewhere

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Solution applies to 2001 Hyundai Elantra.

Open trunk, peel back cover to access area behind rear light assembly. Remove three nuts to free light assembly. The light assembly will jiggle but may resist easy removal. Mine popped free with SLIGHT pressure from 3 inch putty knife placed between edge of light assembly and fender it is attached to.. Use caution to not scratch car.

Posted on Nov 14, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 726 Answers

Need more info on year make
and sedan or wagon

Posted on Jul 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changing headlamps


Above each headlamp assembly there are two tabs that when lifted up, will release the headlamp assembly. Once released, it can be pulled out of the body panel. On the rear of the assembly are two large rubber covers, for the low beam remove the upper cover and this will expose the lamp socket. Twist the socket CCW to release the socket. Then change the bulb.

Aug 15, 2012 | 2004 GMC Envoy

1 Answer

How do I change the rear stop( Park) light? I have difficult time to remove the cover of the light?


Change the bulb from the inside of the trunk.

Invest in a Haynes or Chilton's manual for referrence, it helps.

Inside the trunk, left or right, you should see the wires going to the light. There will be a connector holding the bulb in place. Remove the buld by turning it right or left to release.

Good luck and don't forget to vote.

Oct 12, 2010 | 2006 Honda Odyssey

1 Answer

How do I change front blinker bulb on 2003 chev impala


First,
  1. Turn the engine off and open the hood. Pry up the two fasteners from the radiator air baffle with a flat head screwdriver. Move the baffle to the side to access the top of the headlight case.
  2. Step 2 Pull up the two metal rods behind the headlight case. These secure the case to the car. You may need your pliers to pull them up.
  3. Step 3 Gently pull the headlight case out to access its rear. On the rear, you will find several black dust covers. Twist off the dust cover closest to the fender (the outward dust cover) to access the turn signal bulb.
  4. Step 4 Turn the bulb module counterclockwise to release it. Unplug the electrical connector from the bulb module. Connect the new bulb to the electrical connector (don't touch the glass with your hands; hold it by the plastic piece). Insert the bulb module in the turn signal housing, turn it clockwise and screw the dust cover back on.
  5. Step 5 Insert the headlight case in the mount. Push the pins back down to secure it. Position the radiator baffle in its place and insert the fasteners.
  6. Rear Turn Signal Bulbs
  7. Step 1 Open the trunk. Remove the net from the side mounted wing nut (on the side with the faulty turn signal). Twist the wing nuts (there are two per side) counterclockwise to remove them.
  8. Step 2 Peel the carpet layer back to access the rear signal lamp wing nuts. Twist these wing nuts (two per side) counterclockwise to remove them and release the rear signal.
  9. Step 3 Carefully pull the rear signal assembly away from the Impala. The rear turn signal is the inner bulb (closest to the trunk). Press the tab on the bulb module and turn it counterclockwise to release it from the rear signal assembly.
  10. Step 4 Pull the old bulb straight off the module (don't twist). Insert the new bulb in the module. Depress the tab on the connection and insert the module back in the assembly. Twist it clockwise.
  11. Step 5 Insert the rear signal assembly. Re-attach the assembly's wing nuts and push the carpet layer back in place. Tighten the other two wing nuts to secure the carpet layer and reconnect the cargo net

May 09, 2010 | 2003 Chevrolet Impala

2 Answers

How to change a headlight bulb


The procedure is given below in step by step. Hope it helps..

Drivers side:

  1. Remove plastic cover on rear of headlamp by pushing down on long wire clip.
  2. Pull cover outwards and downwards to release the two clips on top of cover.
  3. Remove wiring connection from rear of bulb.
  4. You will now find that a mirror and torch will come in handy.
  5. Using the mirror you will see that the bulb is held in place with a spring clip that locates under a metal lug on the headlamp.
  6. Push the clip so that it releases from the lug and swing the clip away from the bulb.Remove old bulb.
  7. Insert new bulb making sure the locating tab is in the correct position.[Use the mirror to check].
  8. Replace spring clip.
  9. Reconnect electrics.
  10. Replace rear cover and long wire clip.

Passenger side:
  1. Little more difficult.Remove battery cover and follow the same instructions as for the drivers side.Not so much room to work this side though.
  2. Do not touch the glass parts of the bulbs whilst changing them and if you do clean the glass with metholated spirits before fitting.

Jan 15, 2010 | 2003 Ford Focus

2 Answers

How to change globe on headlight ford focus 2005


avatar3.jpg

brian_au no 1 solution is wrong.. globe is under a spring clip cover . remove cover, then unplug, then release retaining spring behind the globe. replacement is just process reversal

Sep 18, 2009 | 2005 Ford Focus

2 Answers

Ford festiva indicator light replacement


take cover off at lights inside the boot,there are two clips on the taillight squeeze them and the bulb unit should come off

Jul 16, 2009 | 1993 Ford Festiva

1 Answer

Removing tailght lenses cover?


drop the tail gate and there are screws where the gate was and if i remember correctly they are torx screws and u just pull straight out the whole cover cause it's clipped into place. when u have the whole tail lamp in your hands unplug the power connecter then use a phillips and unscrew the housing and replace the bulbs. The bulbs are a real pain in the *** cause they have that small little metal piece that breaks all the fricken time. well it does for me anyways. good luck

May 26, 2009 | 2005 Dodge Ram

2 Answers

1993 tail lights not working, brakelight ,work an turn sigles work. but no tailghts.


sometimes they are seperate bulbs i would check all the bulbs if there all okay then u might have a short somewhere

Oct 27, 2008 | 1993 Mazda MX-6

1 Answer

How do I change a headlight bulb in a 2003 focus?


Drivers side: Remove plastic cover on rear of headlamp by pushing down on long wire clip.Pull cover outwards and downwards to release the two clips on top of cover.
Remove wiring connection from rear of bulb.
You will now find that a mirror and torch will come in handy.Using the mirror you will see that the bulb is held in place with a spring clip that locates under a metal lug on the headlamp.Push the clip so that it releases from the lug and swing the clip away from the bulb.Remove old bulb.
Insert new bulb making sure the locating tab is in the correct position.[Use the mirror to check].
Replace spring clip.
Reconnect electrics.
Replace rear cover and long wire clip.

Passenger side:Little more difficult.Remove battery cover and follow the same instructions as for the drivers side.Not so much room to work this side though.
Do not touch the glass parts of the bulbs whilst changing them and if you do clean the glass with metholated spirits before fitting.

Oct 26, 2008 | 2003 Ford Focus

1 Answer

Corolla 2006 rear stop bulb change


It's very easy to do go to the back lens cover look on for two screws untight pull cover off pull bottom light straight out .
go to any auto part store some stores will replace if you ask.
auto Zone, Schucks all do it. and put the new bulb in.

Jul 07, 2008 | 2006 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...