The 1992 Caprice I'm working on has no Spark to the Coil I've changed the coil and the electronic spark control module. What else besides the Fuel pump or something else could cause the problem of no start problem?

Hi, Spark is controlled by the computer. Where and when(timing). You can not change that. Each cylinder has 1 coil and spark plug. That module is built in to the computer. There are sensors around the engine that send info to the computer. Air, spark, timing, and fuel. When these things work properly the engine will run.

Ignition control module in distributor cap

needs a tune-up, spark plugs, wires , distributor cap & rotor, fuel filter, air filter, might need coil also, put some drygas in fuel tank, check all vacumn lines, change oil & filter. DO ALL THIS , IT NEEDS IT i'M SURE, THEN YOU'LL BE GOOD TO GOOOOOOO!!!!!!!!!!!!!!!

Ok then.

What size engine?

if you changed the coil and get no spark i would go with the module

Change the ignition control module.

Check your ignition control module (ICM)

There isn't a camshaft sensor. The distributor has a control module and a pick up coil inside of it, 1 or both could be bad, it's usually best to replace both. Some parts stores can test them. The is also an Electronic Spark Control Module. I would check the pick up coil and control module.

change coil pickup which is in the bottom of the distrubuter