Question about 1994 Toyota Camry

1 Answer

Crank no start

The first problem with the car is when u turn the key to he on position it blows a fuse for AM2 which is the headlamp fuse, however the headlights come on without there being a fuse in. then after blowing the fuse the car wont start

Posted by on

  • Anonymous Aug 19, 2008

    The car was running, it idled rough for a couple of seconds then shut offf Now it cranks but will not start.. also i've had an ongoing problem with the left headlight...

  • Anonymous Mar 20, 2014

    When I turn off the ignition key and leave the car, there is no sound to tell me the headlights are still on. Where can I find the fuse?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 53 Answers

You've got an open wire in your ignition system that's making fuses blow, i had the same thing happen to me check the wire that runs from the starter to the main fuse box and the wire from the battery to the fuse box. It will only be the wires that carry voltage, none of the ground wires should do that

Posted on Aug 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Camry keep blowing am2 fuse


Dear sir

I think there is some short circuit between two contact/terminal.


Hope answer the question

Jul 19, 2016 | Cars & Trucks

2 Answers

Why does my 99 Chevy Suburban keep blowing fuses & won't start


What fuse's ? Ignition , PCM , ? Won't start how ? explain - when you turn key to the start position does any happen ? if nothing happens this is referred to as a no crank - no start , now if the engine turns over but doesn't start , this is referred to as a crank - no start condition. So which does your vehicle have ?

Oct 12, 2015 | Cars & Trucks

2 Answers

30amp AM 2 fuse blows as soon you turn on the key & car will not start


This is common about this time on these Camrys. I own three. The AM2 fuse is blowing because a coil, capacitor, or supressor has gone bad in the distributor. To test this disconnect the two wire connectors to the distributor. Replace the AM2 fuse. Turn the ignition. If the fuse doesn't blow. The distributor.

Jul 01, 2012 | 1994 Toyota Camry

2 Answers

The AM2 fuse under hood keep blowing out every time i turn the ignition key switch to on position


I would disconnect the noise filter located by the ignition coil/ignitor, have seen them short out and cause the AM2 fuse to blow. Also Disconnect coil, dist and see if short goes away

Dec 07, 2011 | 1994 Toyota Camry

2 Answers

Every time I turn the key to start the motor it blows the 30 amp fuse what is the cause and how do I fix it


if the fuse is blowing when you turn key to start position then this is where to look for the fault ,between the ignition switch and the relay then the other side of the relay to the starter motor solonoid

Mar 05, 2011 | Ford Focus Cars & Trucks

1 Answer

1993 pasco blowing am2 fuse


a wire is shorting to earth so blowing fuse or what ever is on the fuse blowing circuit is drawing excessive current

Jul 05, 2010 | 1993 Toyota Paseo

1 Answer

When key is turned to on position, keeps blowing 30 amp fuse


It sounds like you have a short in some wiresets. Check the wires directly connected to the ignition. If this persists, without any problems with wires, I suggest checking the amperage and voltage on your battery to make sure they are at operational levels. Anything over 14.8 volts and you start to fry electrical components and... blow fuses.

Mar 19, 2010 | 1995 Toyota Corolla

1 Answer

Engine cut off and cant start


If the fuse blew at once, then you have an electrical short. Try disconnecting power lead to start, cover with insulating tape/electrical tape, put new fuse in place, and attempt to "start". if fuse does not blow then the starter motor has an internal fault, replace starter and enjoy. Keep me posted as you perform these tests.

Dec 19, 2008 | 1998 Toyota Celica

1 Answer

1994 toyota corolla blowing AM2 30A fuse under the hood


On top of the cover of the fuses it will tell you what that fuse was for. Odds are whatever it is, is shorting out and will need to be replaced.

Dec 12, 2008 | 1994 Toyota Corolla

1 Answer

ECM BATT fuse keeps blowing


That fuse provides power for the fuel pump. Either your fuel pump is blowing the fuse or there is a shorted wire.

Nov 22, 2008 | 1995 GMC Jimmy

Not finding what you are looking for?
1994 Toyota Camry Logo

Related Topics:

292 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...