Question about 1983 Ford Fairmont

2 Answers

1993 eb ford falcon

On starting fuel gauge goes to full then sudenly drops to empty and stays there

Posted by on

  • Anonymous Mar 29, 2014

    fuel gauge dropped to empty after filling the tank

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Had same prob.
Remedy, spray lots of crc into and onto terminals on sender unit, blow off with air hose, see what happens,moisture and build up of dirt creates a bad earth.
iparish
Palmerston North
NZ

Posted on Sep 28, 2008

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You have a bad earth problem. Reccomend check sender unit in tank. Guage wire is Yellow with a green trace.

Posted on Sep 01, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Gas gauge indicator goes to empty when full


sounds like you may have a bad fuel level sender problem. as for the check engine light coming on and storing a fault code that is a separate issue.

Aug 29, 2014 | 2005 Chevrolet Malibu

1 Answer

1998 ford explorer fuel gauge stuck on empty-Not the typical suspects causing it?!?!?!


One of the wires to the sensor is touching a ground. It may be getting pinched

Mar 04, 2017 | 1998 Ford Explorer

1 Answer

I have a 2004 pontiac montana. for about two years the fuel guage would fold over and read 125 degrees when the tank is full. it woulld stay there until tank was empty and the needle would drop to empty,...


It could be a bad fuel gauge in the dash unit, but....
Usually it's "The bad".
The fuel level sending wipe arm and windings on the fuel sender wear and send erratic readings.The only cure is a replacement fuel gauge sender.
The check engine light should not be related to the erratic fuel readings.
"The good".
If you have over 200,000kms or 120,000 miles on your van you need a new fuel pump anyway,so have a complete assembly put in which will have a new fuel sender on it.

May 21, 2017 | 2004 Pontiac Montana

2 Answers

Fuel gauge stuck on full


pos lead is used to measure ground...that means that the power goes through the fuel level sending unit and the ground lowers the power out from the unit....I would replace the fuel level sending unit.

Jul 28, 2009 | 2000 Ford Mustang

1 Answer

Gas gauge/tank


I am very familiar with this problem, u will need to replace the gas gauge sending unit in the fuel tank.

Jun 17, 2009 | 1996 Ford Ranger SuperCab

1 Answer

1993 Jeep Grand Cherokee gas gauge reads empty but tank is full.


Fuel level sending units are known to go bad on these.

Jun 13, 2009 | 1999 Jeep Grand Cherokee

1 Answer

Fuel gauge not working on alfa gtv 1998


Sounds as though the tank sensor is faulty. Access through top of petrol tank, note the wiring colours and position. Lift out and check condition of float and the rheostat wiring and slider. Get a replacement from EB spares

Nov 13, 2008 | 2000 Alfa Romeo GTV

Not finding what you are looking for?
Cars & Trucks Logo

484 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...