Question about Jeep Comanche

2 Answers

I have a 1986 jeep comanche it either idles high or doesnt want to run where do i begin?

Posted by on

  • Anonymous Mar 13, 2014

    Remove on jeep comanche drive shaft 1986



2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.


    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 67 Answers

I would start off with the egr valve first,then throttle position sensor.if this helps please vote me a fix ya

Posted on Jul 18, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

A part called an idle air control valve. It should be near the throtle linkage. But one from a parts store, change it out and see what that does.

Posted on Jul 18, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my 89 jeep comanche 4.0 have a high idle upon start and sometimes while driving. t has been only doing so upon sart but now it does it randomly while driving.

Most vehicles have a high idle until the engine gets hot. As for your random problem, might want to check for any vacuum leaks that could cause this problem.

When checking, best to do with cold engine. Start your vehicle and spray short amounts of starting fluid near vacuum hoses, if idle changes, you may have a leak. Keep away from exhaust manifold if at all possible. Also spray near intake hoses and air filter housing.

Nov 19, 2016 | 1989 Jeep Comanche

2 Answers

How do i find the problem with my power steering on 1986 Jeep Comanche?

Maybe check to see if there is a cv boot it's located by the wheels on both sides if they're wet then u need to get replaced

Feb 12, 2015 | 1986 Jeep Comanche

1 Answer

My jeep Comanche will not start unless I put gas into the carburetor then it will run fine.

Check fuel pump for operation. Check for blocked fuel filter. Check for problem of tank not venting and creating a vacuum that will not let the fuel to be pumped to the carby.. Check that the needle and seat in the carby is not jammed closed or the small filter at the inlet is not blocked

Oct 13, 2013 | 1986 Jeep Comanche

1 Answer

Pulled off fuel line to carburetor and it is pumping plenty of gas on 1987 Jeep Comanche, what next?

idle speed control not working. if idle speed too low engine wont stay running.

Nov 04, 2012 | 1987 Jeep Comanche

1 Answer

1988 jeep comanche idles high. have checked vacuum hoses. what could be causing this?

You might try adjusting the idle at the throttle body, check the mass airflow sensor, and check for leaks around the plenium.- or what some people still refer to as the intake. And, check the condition of the fuel rail and injectors.

Jul 25, 2010 | 1989 Jeep Comanche

1 Answer

How long is the fan belt 1986 jeep comanche

That depends on whether you need the fan to ac belt, the fan to alternator belt, or the fan to ps belt.

Jun 19, 2010 | 1986 Jeep Comanche

1 Answer

What is the firing order of a jeep comanche 1986 v-6 engine?

if its a 2.8 the firing order is 1-2-3-4-5-6 and the distributor rotates:clockwise if you lose this look ontop of your intake manifold and it has it stamped on it by the number to intake.

Mar 21, 2009 | 1986 Jeep Comanche

3 Answers

1988 jeep comanche idleing rough

How about plug wires they are sometimes the problem if plugs arent getting proper fire they sure do look bad .. look for any burns and check them close

Jan 25, 2009 | 1988 Jeep Comanche

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides