Question about Toyota MR2

1 Answer

Heavy vibration and noise coming from r/h rear in all gears and at any speed. accel/ decel does'nt appear to change noise or vibes.

Posted by on

  • chartom93 Jul 19, 2008

    Thanks for info. I'll check it out.

  • Anonymous Jul 31, 2008

    I have a 2000 spyder I just purchased. It has 70K miles. With the top up I notice while driving a metal to metal noise in the transmission in 3rd,4th and 5th gear especially at lower RPMs... Like a growling noise. Is this normal or is the transmission going bad? When the clutch is depressed the noise goes away and you can hear the motor again.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Sounds like an axle CV joint that is bad

Posted on Jul 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2015 CRV vibration


Vibration where? Front \rear? Accel/decel?

Dec 22, 2015 | Cars & Trucks

2 Answers

2003 ford sport trac front grinding noise from drivers side when sharp left turn


go to the magicmechanic website and send him this--hes the best there is and will rply

Jan 19, 2015 | 2003 Ford Explorer Sport Trac

1 Answer

Rear end howls and vibrates, most noticeable at 50-65 mph. Noise only depends upon vehicle speed, does not change with gear or if in neutral.


Sounds liike a ring and pinion on rear differential. U can pull the cover off and check this or another thing would be to check your u-joints.

Dec 30, 2014 | 1995 Isuzu Trooper

1 Answer

Why does my 2006 Corvette rear end whine when decelerating from 68-60 and accelerating from 30-45?


noise when accel and decel means noisy gears on rear endcheck if the fluid is contaminated with metal particles meaning you need to do some diff repairs

Oct 18, 2014 | 2006 Chevrolet Corvette

1 Answer

Hello i have a 2000 chevy blazer 4x4 has a growling noise gets louder the faster you go no change when you put in four wheel drive.put new hub bearing in no change.what do i try next.when i drive it drive...


ok does noise change when turning left or right if not its not a wheel bearing next try putting in neutral at 55 does noise change what you are looking for these is pinion and carrier bearings in differential the noise can be coming from several places have you checked all your fluid levels front and rear diffs and transfer case also check fluid condition also check for metal in fluids if you stick finger or paper towel in and if you see metal you will know where your noise is coming from

Sep 19, 2014 | 2000 Chevrolet Blazer

1 Answer

2003 F350 6L Diesel, 6 speed manual transmission. Vibration/noise right front when under medium to heavy acceleration, vibration/noise becomes very prominent starting at 1900 rpm in all gears (still can...


Rob, assuming this is a 4X4? Sounds like a bearing. They can vibrate, snap, clunk, all kinds of terrible noises or vibrations.
Axle u joints will also do this. Is it all wheel drive?

Nov 02, 2013 | Ford F-350 Cars & Trucks

1 Answer

I just changed my rear end gears on my 2006 silverado had 323 when to 373 in hear a humming noise humming from thr rear but it dont do it all the time just some times could it be my tires my tires or about...


If noise was not there before the gear change I would say that the gear are not set up correctly. Have the shop or person that did the gear swap recheck the gear backlash and the pattern on the teeth.
Too much heal or toe on the gear mesh will cause a decel whine or an accel whine. May just need to reset the tolerances on the gears.May be best to have a reputable shop check and reset the gear backlash and pattern. This is not much af a DIY type project unless you are experienced at doing gear work.

Hope this helps

Apr 13, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Diff noise


I can understand on accel. and turning but decel I have never seen that I think it's possible tho. too much backlash would make sense

Sep 10, 2008 | 1996 Chevrolet Corvette

1 Answer

Rear axle noise on accel and decel


it is gear noise.The style of this car you will hear a little noise because of how the rear end sits close to the driver and it is open behind you kinda makes an echo effect. probably getting play in the carrier side bearings allowing the gear to "walk" a little causing the pitch to change. this is usually the first cause of failure.You can just replace the bearings and set back up but might still get some noise if it has created a new wear pattern on gear set. This noise will not affect performance or how long it lasts.

Sep 10, 2008 | 1996 Chevrolet Corvette

2 Answers

Loud roar or vibration


Start by inspecting your tires. Look for uneven tread ware, tire separation (a bubble) on the inside or outside. Then change the fluid in your front and rear differential. This will tell you if you have a gear problem. Change the fluid in your transfer case also for indication of a gear problem.

Jul 10, 2008 | 1999 GMC Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

393 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...