Question about 2002 Audi TT

1 Answer

Clutch hard to get into any gear and pedal sticks coming back up often needing help to get it back up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,586 Answers

First, try bleeding the clutch system - it's possible that a pinhole leak somewhere has allowed air into the system. If that doesn't fix it, you're looking at a clutch slave or clutch master cylinder, as a failure of either one will cause the symptoms you have. The slave is less expensive and less involved to change, so I'd start there simply for those reasons. If a bleed doesn't fix it, and the slave cylinder isn't the cause, then you need a master cylinder most likely.

Posted on Aug 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Clutch pedal is tight, stick shifter is tight. however it will not go into gear, with or without clutch pedal, and stays running, doesnt stall. new clutch three months ago


If your car wont go into gear when the engine is NOT started then you have a gearbox problem not clutch.you should still be able to get all gears without using the clutch pedal.The clutch is only there to stop you stalling when standing still,Its possible (but not nice)to drive and change gear without a clutch.Hope this helps.

Sep 17, 2013 | Mitsubishi Eclipse Spyder Cars & Trucks

1 Answer

My Nissan 95 sentra clutch had crunched and pedal would not spring back, found that clutch cable had snapped, replaced this and now my clutch pedal is still not 100% springing back, it springs back en


Check the spring to see if it has snapped anywhere within it's coil.

Remove the cable and check operation of the pedal and spring mechanism.
If all is well, then with a lever, check that the clutch release arm on the gearbox is operational. If that is also sticking, then you will have to remove the gearbox to investigate further.
If not sticking, then also remove the clutch cable outer sleeve, and replace.

Nov 10, 2012 | Cars & Trucks

1 Answer

Started off with cluth sticking to floor.would have to pull clutch pedal back up with foot. truck would stick in gear. even with clutch fully depressed. seemed like spring had disconnected from clutch...


your clutch uses a hydraulic master and slave cylinder to disengage. It is likely that the slave has been leaking and the reservoir gone dry, thus allowing air into the system and reducing effectiveness. Check the clutch master cylinder reservoir (near the brake reservoir) fluid level. If low, also check the slave cylinder at the clutch for leakage. If leaking, replace the slave and bleed the system. If you need procedures or have more questions, please let us know.

Sep 25, 2010 | 1994 Nissan Pickup

1 Answer

Hard to engage 4th gear.shift stick needs to be "slammed" into place. Help!


is it only 4th gear,are all other gears ok,is the shift loose or does the clutch pedal feel funny ,come back to me and i will get to the bottom of this for you.adrian,,,,,,

Aug 19, 2010 | 1994 Toyota Corolla

1 Answer

1998 Saturn SC1 manuel stick is hard to shift into 1st & 2nd gear


Try to double clutch the clutch pedal. How to double clutch; push the clutch in moving the stick to neutral, then release the clutch and then push it back in and shift into first or second gear. If it works then it is not the shift linkage and could be a clutch adjustment. First how far do you have to release the clutch pedal until the clutch plate starts to engage? If only an inch or so the clutch pedal needs to be adjusted, which is an easy fix (this is more common). The other possible problems could be the clutch plate, throwout bearing of syncros could be bad. If it is one of the previous problems double clutching should buy you some time.

Jul 01, 2010 | 1998 Saturn SC

1 Answer

Clutch Dodge SX2.0 2004


Just to be sure recheck the fluid level of the mastercylinder again. If it is a little low refill with proper fluid, and work the clutch several times with parking brake set. Also check the clutch pedal bushings at the top of clutch pedal to make sure there is no sticking or excessive wear. If you find anything unusal about the bushings, they need to be replaced. Hope this will help you.

May 16, 2010 | 2004 Dodge Neon

1 Answer

I just got a new used 1995 honda accord and already i'm really unhappy. The gears stick terribly and the breaks... you have to push down really hard and they don't break fast. What can i do about the gears...


the gears are sticking? is the shifter just really tight and hard to move from one gear to the next, or even just wiggle around in neutral? if so, you may need new bushings for it. which are not very expensive. IF the shifter wiggles around easily in neutral, but hangs in a gear when you press the clutch in all the way, you could need a clutch, OR hopefully you can just try bleeding the clutch line. at the master cylinder on the transmission. the breaks.... do you have to push the pedal down really hard, or really soft and far? if you're putting a lot of pressure on the pedal but you don't have to push the brake pedal all the way to the floor, that would indicate to me that your pads and rotors are glazed over. you should replace the rotors, pads and have the calipers checked, and have the brakes bled. if you've got to push the pedal all the way to the floor, there's a good chance all you'll need is to have the brakes bled.

Feb 07, 2010 | 1995 Honda Accord

2 Answers

My 2004 stick shift Saturn Ion has a problem getting into gear. I step on the clutch and the car turns on fine, but when I step on the clutch and try to shift it inot first gear it doesn't let me. Some...


you have a clutch hydraulic problem. have the clutch master cylinder replaced and the linkage adjusted if neccessary. you will be money ahead to have them replace the slave cylinder at the same time.

Sep 23, 2009 | 2004 Saturn ION

1 Answer

2003 Nissan Sentra SE-R Spec-V clutch sticking and hard shifting


I am dealing with a very similar issue on my 03 Spec V , So far i noticed the clevis pin was loose and the locking hitch pin that slips thru it had fallen out . this caused the gears to not wanna engage due to the bolt behind the clevis which runs to the master cylinder was not getting pressed in when i pushed the clutch pedal in because the clevis pin was slippin on n off giving me no pressure up top .. I had to remove my lower dash panel in order to get visual n hand access to this pin , it is a tight spot to work in as well . May be easist to remove the 4 14mm bolts that hold yur driver seat in to give ya more room to work n stretch out ur arms

Sep 19, 2009 | 2003 Nissan Sentra

1 Answer

Clutch pedal suddenly goes to the floor, no longer [dis]engaging the clutch


I found that having a wood stick on the clutch pedal down to the floor all night (the other end of the stick held by the seat. oh yeah !!! ) would help to ease shifting for the first hour the next morning, then it would come back stiff and hard to engage in gear.

Aug 07, 2008 | 2007 Mazda B4000

Not finding what you are looking for?
2002 Audi TT Logo

277 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70346 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13527 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...