Question about 1997 Ford F250 SuperCab

1 Answer

1977 Ford F-250 removing heater blower fan

Heater blower fan doesn't work. I need to find out how to remove this blower fan so I will have heat in this truck next winter.

Posted by on

  • 4 more comments 
  • hr2cafe Aug 30, 2008

    Similar situation as want to remove the heater box including blower fan so can replace my heater core. Do not have air conditioning. Mine is an early '77 in case it matters. Any one out there please advice how to proceed.

    It seems there are three nuts on the engine side of the firewall. Two by the blower and one in the center of the pickup. There are two rubber press through things I may have to push backwards with needlenose pliars or something. Possibly I can unscrew the blower box from the heater box by the passenger vent now I have the glove box loose.

    Trying to figure out what to do next before winter!


  • Anonymous Mar 20, 2014

    heat is not warm from back blower
    fan in front does not seem to be workig

  • Anonymous Mar 21, 2014

    rear blower for heat not working

  • Anonymous Mar 25, 2014

    the blower blows but no heat comes out

  • Anonymous Mar 26, 2014

    Sounds like the blower fan is seizing, screeches awful, what should I do?

  • Anonymous Apr 01, 2014

    The fan was sounding like a card on bike spokes for a while. Now you can hear the fan moving but it is like the blades came off. Heat comes out but not quickly.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 178 Answers

Hello your heater blower fan is located in your heater box pass you will see a stop sign shaped flat flared end metal piece about 6inches diameter all the way around held in with either 6 or 8 1/4bolt heads unscrew these unplug wire feed pry lightly away from box fan assembly will come right out if your blower moter doesnt come with plastic fan fins you will need to use the old one usaully held on with a clip once removed slide off the fan shaft install to new motor reintall if no gasket take black permatex apply a thin coat around outer edge of new fan tighten plug power back on done goodluck

Posted on Sep 13, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1977 Buick blower / fan comes on however NO heat blower / fan also blows very low.


Buick LeSabre Heater - RepairPal

repairpal.com > Problems > Buick > LeSabre
Buick LeSabre Heater blows only cool air...even w/ defroster on. This is a ... Heater fandoesn't come on . ... The blower works but there is no heat coming out.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
https://www.youtube.com/watch?v=2vmfxYg8LoY
Sep 27, 2009 - Uploaded by mgittelman
The blower motor is a common heater/AC repair within the skill level of ... However if the power wire is a single light purple wire and the ... for blower motor and fuel and relay good but no powercoming on both any ideas? ... my o5 seira, when i start the engine with the air switch on it blows my blower fan ...

Car Air Not Blowing, Heat & Air "How to" Test Testing ...

? 6:22
https://www.youtube.com/watch?v=hgar6Q1lV6A
Apr 5, 2013 - Uploaded by Fixbook
Here I show how to determine the problem if your air, or blowermotor is not ... Click here to check out the the "Car Runs on 2 cylinders" series: ... How to Fix Over-Heating engine & No Heat in car - Buick (2000 yr) Park Ave . ... Car fan / AC only works on high - Replacing the Blower Resistor - Duration: 4:24.

Buick Park Avenue Questions - NO HEAT!!! - CarGurus




Jan 30, 2016 | 1977 Buick Electra

1 Answer

Remove blower fan1988escort


Ford Escort Heater AC Blower Motor Removal - YouTube

? 4:49
https://www.youtube.com/watch?v=oAWn-ybZJUs
Aug 28, 2013 - Uploaded by richpin06a
Ford Escort Heater AC Blower Motor Removal. ... How To Fix Install AC Heater Fan Blower Motor 1991-03 ...

Nov 01, 2015 | 1988 Ford Escort EXP

1 Answer

My heater fan in my 2007 f-250 heater fan stopped working


Check blower motor electrical connection on back of blower and vacuum leak. Have you checked the fuses???

Jan 03, 2014 | 2007 Ford F-250 Super Duty Lariat

4 Answers

The fan heater is not working?


fusebox is under the drivers side lower dash area usually, but in some models its in the glovebox to the left side,,and some are under the hood near the drivers side shock tower(or above it)plastic box with a snap-on lid..) in the lower dash a panel cover need to be removed by taking two screws loose and removing the cover..fuses should be inside check the larger amp rated ones good luck..

Jan 17, 2013 | 1998 Ford Explorer

1 Answer

2001 ford f 250 deisel why thse the heater blower fan on my truck sometimes work and sometimes doesn`t?


sounds like a faulty switch and if it is you sould replace it before it completely goes out

Dec 25, 2010 | 2001 Ford F250 Super Duty Super Cab

1 Answer

Fuse diagram for a 98' E-150 van specifically for heater fan


owner manual will tell you fuse layout. If you have only high speed, you have a bad resister. 4 wires.

Resistor —Heater Blower Motor Switch Removal
  1. Remove the battery (10655) ; refer to Section 414-01 .
  1. Remove the battery tray.
    1. Remove the screws.
    1. Remove the battery tray.
  1. Disconnect the heater blower motor switch resistor connector.
  1. Remove the heater blower motor switch resistor (18591).
    1. Remove the two screws.
    1. Remove the heater blower motor switch resistor.
---------------------------------

0f120f5.gif

Feb 26, 2010 | 1998 Ford Econoline

6 Answers

1998 Ford Contour. The heater blower stopped suddenly. I checked all the fuses, good. I removed the blower and hooked it to 12 volts. Whoosh! It almost spun out of my hand. I checked the plug into the...


I dont know what these other guys are saying..I think they snif the glue!!! YOUR BLOWER FAN ASSEMBLY CAN EASILY BE REMOVED !!
1. Remove the wire
2.Find the "tab on the housing and pull it down while rotating the fan housing counter clockwise. This will remove the fan assembly. Plage 12 volts on the contacts to test the motor. If it works then the resister pack is blown. On the fan housing (near firewall ) you will see a plug going into a square looking box with a screw in it. Remove the wire then remove the screw to remove the resistor pack.. A new resistor pack is around 20 dollars at a ford dealer. Hope thie "FREE" info helps!

Feb 24, 2010 | 1998 Ford Contour

1 Answer

Heater of my 1999 ford contour is not working. is there a fuse i can replace to make it work?


There is a fuse under the steering wheel area, also there is a heater conrol under the passenger side dash on the left side of the blower motor. 1 screw holds it in the plenum(heating duct) there is a 4 wire plug going to it. You can check the actual blower motor for operation by putting 12 volts to it. To remove it there are two tabs on either side of the housing.Remove the wire first. Push the tabs up together and turn the fan housing to remove it. You now will have the whole fan in your hands. Using a wire jump from a 12v source(car battery works) to test the fan.2 wires reqd for + and-. if the fan does not function it may need replacing or just lubrication.

Jan 09, 2010 | 1999 Ford Contour

1 Answer

Blown heater core in a 1977 ford f-150 pick-up


1976-79 Without Air Conditioning
  1. Disconnect the temperature and function control Bowden cables from the heater housing. This must be done to prevent damage to the cables.
  2. Disconnect the wires from the blower resistor.
  3. Remove five screws attaching the air inlet (vent) duct to the heater housing.
  4. Disconnect the blower wires.
  5. Drain the radiator and remove the heater hoses from the heater core.
  6. Remove three heater stud retaining nuts and remove heater.
  7. Remove gasket between the heater hose ends and the dash panel at core tubes.
  8. Remove heater core cover and gasket (four screws).
  9. Pull heater core and lower support from heater.

To install:
  1. Install foam gaskets on heater core and install in heater assembly.
  2. Install the core seal and cover plate.
  3. Position heater assembly in vehicle and install three stud retaining nuts.
  4. Connect heater hoses to heater core and fill radiator.
  5. Connect blower motor wires.
  6. Place defroster nozzle on heater so that the defroster and heater openings are in the up position, and there is no air leak around the seal.
  7. Install air inlet (vent) duct to heater. Push duct firmly against seal on side cowl and tighten five attaching screws.
  8. Connect wires to blower motor resistor.
  9. Connect temperature and function control cables to heater, and adjust the cables.
  10. Reinstall gasket between the heater hose ends and the dash panel at core ends.
  11. Fill Cooling System.

  12. Hope this helps you! Please remember to rate my solution.

    Lefty64

Apr 09, 2009 | 1986 Ford F150 SuperCab

Not finding what you are looking for?
1997 Ford F250 SuperCab Logo

727 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...