Question about 2003 Mitsubishi Galant

1 Answer

Fuel gauge on 2000 GMC

Needle bounces to 3/4 full then back to empty and stays at empty and low fuel light comes on and also stays on

Posted by on

Ad

1 Answer

You need to fix this ASAP!!!!!

Posted on Jul 16, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low fuel gauge on when tank is full


need to replace the sensor

Aug 13, 2014 | Cars & Trucks

1 Answer

Fuel problems


need to unplug and ground out purple wire it should go to empty then remove from ground it should go to full if that works it will need a new fuel sending unit

Aug 17, 2013 | 1997 Dodge Intrepid

1 Answer

Fuel gauge bounces between full and empty on 2000 pontiac bonneville


Just replaced fuel pump and fuel indicator sensor on my Bonny and fixed the problem,this seems to be a very common problems with this car

Sep 27, 2012 | 2000 Pontiac Bonneville

1 Answer

I have a 2004 pontiac montana. for about two years the fuel guage would fold over and read 125 degrees when the tank is full. it woulld stay there until tank was empty and the needle would drop to empty,...


It could be a bad fuel gauge in the dash unit, but....
Usually it's "The bad".
The fuel level sending wipe arm and windings on the fuel sender wear and send erratic readings.The only cure is a replacement fuel gauge sender.
The check engine light should not be related to the erratic fuel readings.
"The good".
If you have over 200,000kms or 120,000 miles on your van you need a new fuel pump anyway,so have a complete assembly put in which will have a new fuel sender on it.

May 21, 2017 | 2004 Pontiac Montana

1 Answer

I have a 2000 GMC Sierra extended cab Z71 and my fuel gauge fluctuates.It takes it a while to register it has fuel and then it will just drop to empty then bounce back up. I was wondering what could cause...


The fuel sender is built on to the fuel pump. This happens sometimes if you run the tank low alot Try keeping the truck above 1/2 tank see if this helps otherwise you might need a new fuel pump

Dec 27, 2009 | 2000 GMC New Sierra 1500

1 Answer

GMC envoy after I filled gas tank the low fuel light came on and as I was driving it would go off than come back on after a few miles the check engine light come on stayed on and the low fuel light still...


You will need to replace the fuel level sensor which is in the fuel tank.They have a lot of problems because the metal fingers on the sensor wear off and gives you the incorrect readings.This will also cause the check engine light to come on.You will probably have a level sensor code.This will be a lot easier if the fuel level is down to about a quarter tank or less.Also you should be able to get just the level sensor and not have to get the complete fuel pump module.Good luck.

Dec 02, 2009 | 2005 GMC Envoy Xl

1 Answer

My 2000 gmc fuel gauge will sometimes go from full to empty causing the low fuel light to come on. Also it does not ever go below 1/2 tank mark.


needs the fuel pump assembly....gauge sender is incorporated in this module...pretty expensive but the only alternative is to fill it up and reset your trip odometer each time...you should be good for 250 miles or better before next fill up!! good luck!

Sep 04, 2009 | 2000 GMC Denali

2 Answers

Fuel sensor gauge


you will need to replace the fuel level sensor.(sending unit) it is in the tank and is hooked to the fuel pump. you can buy seperatly from pump. you may finf it easier to remove the bed if you have some help. it is six or eight bolts and harness unplugs then you can get right to it.

Jan 13, 2009 | 2001 Chevrolet Silverado 2500

Not finding what you are looking for?
2003 Mitsubishi Galant Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8825 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...