Question about 1985 Chevrolet S-10

2 Answers

93 s-10, will not start until i prime t.b. then will run until i idle down then stalls and will not start w/o prime? I replaced the fuel pump, pump relay, oil sender and still does the same thing. Scan shows code 54 Any help will be greatly appreciated!

Posted by on

2 Answers

Mine had same problem open the hood look straight back on fire wall 2 relays disconnect both blow them out and reconect i bet u the truck wil start right up

Posted on Jul 18, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Have you checked the EGR, and IAC? The IAC can cause all kinds of odd starting and idle problems if it is bad.

Posted on Jul 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 dodge 2500 ram diesel


I'm not familiar with that particular vehicle, but most diesel systems have a primer under the hood. You will need to pump that slowly until you feel some resistance. That will push fuel to the engine. The other pump may not be able to push fuel through until the system is primed.

If that doesn't get you running I would suspect a clogged fuel filter. Most Dodge vehicles have one on the frame. Just follow the fuel lines until you find it. There may also be one attached to the pump primer.

Changing that filter would my next action. Whether the pump is in the tank or added on outside the tank, you may still need to prime the system after the filter is replaced. Air in the line may cause it to stall, just reprime and start again.

Good luck.

May 05, 2014 | 2000 Dodge Ram Maxi

1 Answer

1989 mercedes 560 sel, gas, w126/ Car cold starts every morning and idles for 10 min. then stalls


the idle control motor probly worn-on the throttlbody--also the tps sensor - get intake area inspectd--a haynes manual will xplain complete car-partstore hazit--------starter fluid is used for low compression or weak spark

Dec 25, 2013 | Cars & Trucks

1 Answer

Starts but stalls right away


Have you checked your fuel pressure? Could be the fuel pressure regulator. Hard to say without a year and model of the jeep.

Nov 24, 2012 | Cars & Trucks

1 Answer

The car is fine till it warms up then the idle starts to go down and sometimes it stalls when i stop


Sounds like a weak fuel pump.Check your fuel pressure it should be 50-60 psi.You will need to pull the fuel relay then start the engine and let it run until it cuts off by itself then put the relay back in and hook up a scan tool and energize the pump and read the pressure.If its not within these specs replace fuel pump and filter.

Jan 31, 2012 | 1999 Dodge Intrepid

1 Answer

Engine stalled out,would not start, pour gas in carb,cranks,keeps running,until idle falls below 12to1500rpm,than stalls out again and will not crank,repeat gas or starting fluid in carb,cranks runs and...


This truck is fuel injected, the problem sounds like a weak fuelpump, it runs when you pour gas into it until that gas runs out, the first thing is to test the fuel preasure, if the pump is weak it may run with gas poured into it but wont idle, also a common problem is the coolant temp sensor and the ground wires to thermostat housing bolt but i wont bet its the pump inside the fuel tank, if you put a fuel gauge on it there should be at least 55-61 psi if its a few pounds lower it can cause problems, you have everything else and it runs with gas poured so its a fuel problem check the preasure, theres a valve up top on the fuel line to connect a fuel gauge to it, start there hope this is helpful.

Dec 27, 2010 | 1993 Chevrolet C1500

1 Answer

Car starts fine..Idle is fast...stalls after car warms up


Check for vacuum leaks. Also try cleaning the ISV.


If that doesnt work go to vwvortex.com and post your issue there

Jul 08, 2009 | 1989 Volkswagen Golf

3 Answers

How do you bleed a peugeot 206 1.9 diesel fuel system


The diesels I've worked on are bleed at the injectors. You need to loosen each injector in turn and pump up fuel pressure until only fuel comes out, no air, than tighten the fitting up before it back feeds. Repeat this process for each injector.

May 09, 2009 | 2006 Peugeot 505

1 Answer

1994 sonoma stops running when it warms up


Replace you fuel Injector pump and check for any bad or clogged injectors. make sure idle adjustment screw is properly set 1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Apr 24, 2009 | 1992 GMC Sonoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63291 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...