Question about 1992 Toyota Celica

1 Answer

Engine mounts hello, i have a 1992 celica gts, 2.2, need 2 no where all the motor mounts r located....found 3,can't find the 4th,front/back under motor, pass-side top by pr-steering pump, can't find the last one....****!!!

Posted by on

  • 3 more comments 
  • kll717 Jul 17, 2008

    about the motor mounts....in Greenville S.C. , toyota dealer, Jeffrey in parts, dam things high in price, from 70$ to 120$, **** its just a motor mount...864-288-3535, found front one for 45$ on-line, need the one up by the power steering pump reservoir, can't find that one on-line yet, wish me luck, appreciate it, have vibration in hole car, all over it, bad when i start it, then it seem to level out, pass. side fender vibrate's, plus hood, best guess so far r the motor mounts..shifts find, go's to 120 with no problem,220,000 on it, 5 speed...1700$ about 2 mths ago, later

  • kll717 Jul 17, 2008

    hello again, about the mounts, there r 4 if u count the trany mount, found it 2day......

  • marty59q Jul 19, 2008

    I have the same problem with vibration in hole car, all over it, bad when i start it, then it seem to level out, pass. side fender vibrate's, plus hood, best guess so far r the motor mounts. Make ssense it would be the engine mounts any other idea's?

  • kll717 Jul 25, 2008

    6-26-08, it was the motor mounts,changed 2 of them, one in front, other on wheel-well pass. side. Solved the problem.....when i looked at the mounts they did not look real bad at first, but what was i to do.......the one on the wheel-well pass. side made all the differents...later

  • JBrecht21 Jan 16, 2009

    Same problem whole car vibrates real bad especially when I first start it, but then gets a little better as the car warms up but still vibrates.  I think it is cause of the motor mounts.  Anyone else got any ideas?  I gonna check em out this weekendm

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 726 Answers

Who told u ther was 4?
ther is only 3

Posted on Jul 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1990 toyota celica gts 2200 motor vibration when idled up


You may want to check your motor mounts. If the mounts are broken or just too old they will cause the engine to have excessive vibration your notice also when shifting to drive or reverse it will feel like the vehicle jumps. replacing the mounts will help if they are damaged or may be that the vehicle needs a tune up.

Nov 07, 2013 | 1990 Toyota Celica

1 Answer

00 celica gts timing chain problems


The timing chain should not routinely need changing, but perhaps the tensioner does.
Try first to eliminate any other causes, like the bearings in the fan, drive belt idlers, or alternator. A useful tool is a long screwdriver which you can apply to the various areas while placing your ear to the top of it while the motor idles.
Be very careful to keep clear of moving parts like fan blades.

Apr 11, 2012 | 2000 Toyota Celica

1 Answer

2000 toyota celica GTS shift mode light keeps flashing and check engine is on.


you have blown your red line check gaskets from throttlebody gasket directly to the front of the intake. while running motor spray some brake cleaner around the areas one leak and you hear the automatic change in sound of motor. replace and torge to specs. 11_21_2011_9_10_52_pm.jpg

Sep 02, 2011 | 2000 Toyota Celica

2 Answers

I can not find the fuel filter on my 1983 celica


its on passenger side, under hood, rear side of strut tower, mounted on fuel line thats if your motor is a 2.4 liter/ 2-brl 4 cyl.

Jan 04, 2011 | 1983 Toyota Celica Supra

1 Answer

I am having trouble locating the starter in a 1983 Toyota Celica GT. Any help is appreciated!


mpa16674.jpg
  • the starter is underneith the car read below.

  • Locate the negative battery cable on the negative battery terminal. Remove the retaining bolt with a wrench, then remove the cable from the battery. Isolate the cable from the battery so it cannot fall back against the battery.

  • 2

    Raise the front of your toyata with a jack and position a set of jack stands under the front suspension. Lower the Toyota onto the stands, then remove the jack. Slide under the passenger's side of the Toyota and locate the starter motor near the rear of the engine.

  • 3

    Locate the wiring harness plug on the starter solenoid and pull it straight out. Find the larger connection next to it and remove the retaining nut from the stud with a wrench. Pull the cable loose and push it aside.

  • 4

    Remove the two mounting bolts from the front of the starter motor with a socket and ratchet. Lower the starter from the engine compartment. Raise a new starter into the engine compartment and install the two mounting bolts from the transmission side of the bell housing. Tighten both bolts to 29 pound-feet with a torque wrench and socket.

  • 5

    Plug in the wiring harness connection to the connector on the starter motor. Push the two connector halves together until they lock. Install the larger cable on the "B" terminal followed by the retaining nut and tighten it with a wrench.

  • 6

    Raise the front of the Toyota off the jack stands with a jack. Remove the stands from under the Toyota and carefully lower the Toyota to the ground. Remove the jack.

  • 7

    Connect the negative battery cable to the negative post on the battery, then tighten the retaining bolt with a wrench. Close the hood and test the repair by starting the engine.

  • Dec 12, 2010 | 1983 Toyota Celica

    1 Answer

    Where is the computer located on a dodge stealth


    For 1992 Dodge Stealth 3.0L MFI DOHC 6cyl...
    * The Engine Control Computer is located: Front seating area, center, under dash, front of console, mounted on firewall
    * The Control Module-Ignition is located: Under hood, driver side, upper engine area, driver side of intake manifold, mounted in engine block

    Hope helps (remember rated this).

    Aug 10, 2010 | 1992 Dodge Stealth

    1 Answer

    Toyota Celica gts 2000 blowing cold air when heater is on.


    nothing try back flushing heater core, they clog up due to litle water preasure,you might want to flush cooling system if you already havent, hope this hleps.

    Oct 06, 2009 | 2000 Toyota Celica

    1 Answer

    Front fenders need to be removed


    take the inner fender well out, unbolt the fender from the bumper, take the 2 bolts out under the car at the fender, lastly take all the bolts along the fender out, and gently pry it loose

    Aug 07, 2009 | 2000 Toyota Celica

    1 Answer

    Need to locate fuel filter on 1985 Celica GTS 4cyl.


    From autozone.com (repair info section) for a Celica with a 2.4L engine ...Under hood, center, upper firewall, mounted in fuel line

    Mar 22, 2009 | 1985 Toyota Celica

    1 Answer

    1985 convertible celica fuse location


    Check the harness connections located inside r-rear trunk panel. You will find power top motor & wire harness there.

    Jul 12, 2008 | 1985 Toyota Celica

    Not finding what you are looking for?
    1992 Toyota Celica Logo

    Related Topics:

    251 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    60960 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    21949 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    6812 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...