Question about Toyota Supra

2 Answers

How to connect kenwood radio to Toyota antenna relay

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 37 Answers

If the blue wire doesnt work go to wal mart and get an antenna connector it looks like a spider kind of, with different connections all over it this is what is typically used to connect antennas.... it should say antenna connector on it......sorry for the horrible description i just cant think of any other way of wording it.....to connect it you simply plug it in to the socket that ur probably wondering "what the hell is this for"..............its very easy to do and very cheap.

Posted on Jul 17, 2008

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 20 Answers

Most aftermarket car stereos have a blue wire for power antenna control. Connect the blue wire to your car's power antenna control wire. Also, Crutchfield has nocut connector kits to install most car stereos in most cars, with instructions. You can either buy these kits or Crutchfield gives them to you, free, when you buy a stereo from them.

Posted on Jul 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Radio frequently just stops broadcasting and eventually comes back on


Peggy, Is the radio actually switching off or do you just loose the radio station. If radio is shutting off, there must be a bad wire/ plug connection, loose plug, or maybe bad ground.
If loosing station, have Arial/antenna connections checked, maybe upgrade to better antenna. Some stations just do not send out a strong signal which can also cause loss of station.

Mar 29, 2016 | 2009 Toyota Highlander

1 Answer

Radio and antenna stopped working


The antenna relay is controlled by the radio. The 15A ACC fuse in the driver side J/B and the 15A DOME fuse in the engine room R/B control application of power. If the fuses are OK, the power loss could be occuring elsewhere.

Apr 16, 2014 | 1997 Toyota 4Runner

1 Answer

Avalon radio


I would check the connections on the grid, if they are ok you have to live with yagi effect.

Mar 25, 2014 | 2000 Toyota Avalon

1 Answer

Radio on toyota avensis verso 2001 not catching the stations, just noise and hissing, cd works fine. Cannot find where antenna's entry, to begin with. Could any one help? Had a similar problem?


The antenna connection is most likely on the rear of the radio. If the antenna is not connected, you will not be able to hear any stations. The first thing to do is locate the antenna connection and make sure it is completely connected, then try to find stations

May 24, 2013 | Cars & Trucks

1 Answer

What does fuse called radio-b do?


If your unit has digital display as most do now, RADIO-B will supply constant power to power the units memory so it can remember the preset channels, starting volume etc. The power antenna is usually controlled by a separate wire from the unit (normally blue) this wire supplies a low voltage signal to the antenna, The antenna will also have its own power supply and earth at the base of the antenna, the problem could be there. depending on the antenna, some have a controlling relay that is separate, again another possible source. there will also be a fuse in the main fuse box. These will all need to be checked, along with connecting a power source to the antenna to ensure the antenna does actually work.

Feb 23, 2013 | Cars & Trucks

1 Answer

How to connect the antenna to the radio 2010 Toyota highlander


On the front wind screen glass.inside just above RV mirror,paste the antenna and connect to the radio via roof hood,RH pillar to the dashboard where the radio is fixed.

Feb 27, 2012 | 2010 Toyota Highlander

2 Answers

The radio antenna doesn't go up or down. I can's even hear the motor making a noise.


possible fuse, if not unplug wire at antenna and put test light on....turn on key, if power there then antenna is done

Jun 16, 2010 | 1998 Toyota 4Runner

1 Answer

Need to know how to remove a regular antenna from a 1996 Toyota Tacoma. It is not a power antenna.


Toyota Pick-ups/Land Cruiser/4Runner 1989-1996
Antenna - REMOVAL & INSTALLATION

If your antenna mast is the type where you can unscrew the mast from the fender, simply do so with a pair of pliers. Most damaged antennas are simply the result of a truck wash or similar mishap, in which the mast is bent.

Manual Antenna
  1. Disconnect the antenna cable at the radio by pulling it straight out of the set. Depending on access, this may require loosening the radio and pulling it out of the dash.
  2. Working under the instrument panel, disengage the cable from its retainers.
On some models, it may be necessary to remove the instrument panel pad to get at the cable.
  1. Outside, unsnap the cap from the antenna base.
  2. Remove the screw(s) and lift off the antenna, pulling the cable with it, carefully.
To install:
  1. When reinstalling, make certain the antenna mount area is clean and free of rust and dirt. The antenna must make a proper ground contact through its base to work properly.
  2. Install the screws and route the cable into the cab. Make certain the cable is retained in the clips, etc.
  3. Connect the cable to the radio; reinstall the radio if it was removed.

Power Antenna Mast
The power antenna system contains a relay. If the power antenna is inoperative, the relay is the first place to look. The actual motor rarely fails.
The power antenna mast is replaceable on the Pick-Up and 4Runners. If the mast is damaged or broken, proceed as follows:
  1. Perform this repair with the battery cables connected. Turn the ignition switch to the LOCK position.
  2. Remove the antenna nut.
  3. If equipped with a CD player, press the AM and FM buttons on the receiver and simultaneously turn the ignition switch to ACC .
  4. For non-CD player units, press the AM button and simultaneously turn the ignition switch to ACC .
  5. The antenna motor will run, unwinding the mast from the spool. have an assistant guide the mast so it doesn't fall and damage the bodywork. When fully extended, the mast will be released. Remove it, and leave the ignition in the ACC position.
To install:
  1. Insert the new cable so that the teeth face the rear of the vehicle. Feed the cable into the motor until the cable reaches the bottom, about 12 in. (30cm).
  2. Have an assistant ready and prepared to guide the cable. Turn the ignition switch to LOCK . The motor will run, winding the cable onto the spool and drawing the antenna down into the mount.
  3. If the cable does not wind, twist the cable at the top of the housing; the part at the bottom may have turned while being pushed down the hole.
  4. Once wound onto the spool, install the antenna nut even if the antenna is not fully retracted. Test the antenna elevation and retraction; the mast will eventually retract fully.
Hope helped with this (remember rated this post).

Feb 26, 2010 | 1996 Toyota Tacoma

1 Answer

Power antenna


Actually, there are 5 power feeds going into the power antenna control relay. If I am to assume that you just no longer want it to run, just remove the radio and disconnect the BLACK with a WHITE trace wire at the plug going into the back of the radio unit.

Oct 01, 2008 | 2001 Toyota 4Runner

1 Answer

Radio Wiring Help


Never heard of that, Just saw a switch like that on a Honda accord. Raised it and lower whenever you wanted. If you got an aftermarket radio, connect a switch between the Antenna power wire and the receiver antenna power of the radio, you can get the switch at radio shack. A 3-way jump switch should be your option.

Aug 06, 2008 | 1995 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...