Question about 2000 Toyota Land Cruiser

1 Answer

Rear Tilt Panel Window Not Working

I have a 2000 Toyota LC. The right rear tilt panel window (power tilt) is not working. The left window works just fine. I looked for a fuse to check, but was unable to identify if it has a fuse and/or if it needed replaced. Any ideas as to what the problem is?

Posted by on

1 Answer

Prise

Posted on Jul 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are window lift fuses for chaser


should'nt have individual fuses,brushes in motors may be stuck,tap on door panel while trying to operate window may get them working,if does'nt work may have to get to power motor.check for power to doors with test light first

Mar 04, 2013 | 1998 Toyota Chaser

1 Answer

Can't find fuse for heated rear window, or relay for same. Also want to know where to find fuse for interior lights


The window defogger is often powered through a circuit breaker, which should be located at the driver's side fuse panel. If you have power at the window connector, likely the window grid may need repair. Toyotas have relays everywhere, but fuses are usually only under the hood in the Power Distribution Box, and at the driver's side fuse panel.

Feb 20, 2013 | Toyota Avensis Cars & Trucks

1 Answer

I need to remove a rear door gllass on a lexus Gs


Remove rear door panel, reconnect power window switch, looking at bottom edge of glas you should see two 10mm bolts roll down window until bolts are accessible. Remove bolts and tilt window around 10 degrees top edge out/in. if still to tight to slide out put glass in lowest position and remove window frame weather stripping and it should slide right out the top, careful not to scratch tint.

Aug 19, 2010 | 2009 Lexus LS 460

2 Answers

Which fuse is for the rear window wiper and rear window defogger on 2003 Toyota 4Runner (V6)?


You Have one fuse for the wipers in the car. Left side of steering wheel and the back cover should list the fuses and location. The other box is located in the engine compartment above the battery. They should list the fuse locations under the compartment covering the fuses. Hope that helps

Jun 14, 2010 | 2003 Toyota 4Runner

1 Answer

2000 toyota camry rear window


This isn't so much of a solution as it is an understanding. My rear passenger window just started doing the exact same thing a few weeks ago. I finally had to get black duct tape that matches the color of my car to keep it up. Sorry I couldn't help you more, but would love to find a solution myself.

Aug 03, 2009 | 2000 Toyota Camry

1 Answer

I have 2002 toyota camry xle window switch not working right


You have the wires connected to the wrong switches. Just reverse the wires with the door panel off until the correct switch operates the correct window. Also, the entire switch for each window on the driver's side could have been put in the wrong place on the switch pad even if they are correctly wired.

May 28, 2009 | 2002 Toyota Camry Solara

1 Answer

Removal of rear door panel to access power window motor


SECTION 501-05: Interior Trim and Ornamentation 2000 Taurus/Sable Workshop Manual REMOVAL AND INSTALLATION Rear Door Trim Panel Removal and Installation
  1. Remove the rear door trim panel screws.
  1. NOTE: The rear door trim panel has eight two-part pin-type retainers. The male part of the retainer will remain with the trim panel and the female part will remain with the door.
    NOTE: To release the door trim panel pin-type retainers, first pull outward on the bottom of the door trim panel.
    Remove the rear door trim panel.
    • Disconnect the window regulator control switch electrical connector.
  1. To install, reverse the removal procedure.

Apr 07, 2009 | 2000 Ford Taurus

1 Answer

'00 Ford Explorer - Master window switch won't work rear windows


Without proper electrical diagnostic equipment and based on the very through description that you gave I would suggest getting a new switch. I say a new switch because on the drivers side the switch is one giant junction block. I have the same vehicle and had my door panel off for some locking issues.

I have attached a link to Ford Direct. The part that you are looking for is Window switch, explorer, 4 door, right

http://www.forddirectonline.com/partlocator/index.cfm?action=getLocator&siteid=214462&chapter=DP2028&appSectionid=3&groupid=10005&subgroupid=20061&componentid=62141&make=10&model=Explorer&year=2000&catalogid=1

Jan 19, 2009 | 1996 Ford Taurus

2 Answers

Rear power windows will go down not up


its the problem of control switch module in the drivers side and needs replacement to make it proper.

Jan 05, 2009 | 2000 Toyota Land Cruiser

1 Answer

2005 Camry rear right Power window not working


Like I said you need a new window lift motor.

Aug 27, 2008 | 1997 Toyota Camry

Not finding what you are looking for?
2000 Toyota Land Cruiser Logo

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...