Question about BMW 528

1 Answer

Fuel lines/hoses are bursting. - 528 BMW Cars & Trucks

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

  • Contributor
  • 4 Answers

Did you recently replace the fuel filter and is it correct?

Posted on Jul 15, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Burned up while engine turned off. Understand GM had over 297 fires like this. Repareable?

fire damages all aluminium parts and rubbers and wiring harness and connections
fires were mainly from rubber fuel lines and fuel pressure in those lines blowing the hose of the fuel manifold or bursting at that point
it should be covered in the vehicle insurance but the damage will be extensive
check to see if there was a recall or a service bulletin on the problem that the service failed to deal with
the question for you , will insurance cover the cost of repair , will you spend time on the vehicle because of the age and condition or will you take the insurance for a write off and upgrade

Nov 08, 2015 | Cars & Trucks

1 Answer

My hilux 1kd-ftv wont start 3.0 d4d return fuel line full pressure

if it is a common rail diesel then the pressure in the return line would burst it as the line is not capable of 25.000 psi
so the return line will have low pressure if it is blocked some where

have the injectors tested as there may be a tip seat problem that prevents it from starting and the compression pressure is making the pressure in the return line past the needle

Sep 16, 2015 | Cars & Trucks

1 Answer

Power steering hose burst

There is little pressure on the return hose

Are you using power steering hose or vacuum
tubing or regular gas hose?

Take the pump off & apart or look for blockage
going into it

Mar 02, 2013 | 2006 Dodge Grand Caravan

1 Answer

My a/c hose burst, why?

Something could've got caught in the A/C line and caused it, the 2005 Chevorlet Colorado had that issue when they were released to the public.

May 22, 2012 | 2005 Chevrolet Colorado

1 Answer

I have a 96 olds delta, start it up and it wont stay started. could it be the fuel pump?

Yes, it could be... Remove the air cleaner hose and spray WD40 or starting fluid in the hose that goes to the engine...Have someone start the vehicle.. Spray short bursts into the hose while car runs.. If it continues to run while you are spraying and then stops when you stop.. you probably do have a fuel issue.. Hope this helps..

Aug 18, 2011 | Oldsmobile 88 Cars & Trucks

1 Answer

Changing a fuel pump for a 1999 chevy malibu. is there an panel under the seat to make it easy. or do we have to drop gass tank.

if there was a panel, it would be under the trunk floor, and it is not. drop the tank and since the fuel filter is up in there too replace it while you are in there and all the old corroded fuel lines. save you some grief next year when the fuel line bursts. and the hose is high pressure so do not use cheap stuff.

Mar 14, 2011 | 1999 Chevrolet Malibu

1 Answer

Power steering pump return line hose keeps busting. why?

Was it replaced with the proper type of hose? If your using a generic hose it may not be able to handle the pressure of the pump and it could cause it to burst.

Jan 03, 2011 | 2001 Chrysler Town & Country

1 Answer

How do i change the fuel filter in my 1985 cadillac deville (gasoline)

FUEL INJECTED ENGINES The fuel filter on fuel injected vehicles may be located in one of two locations. On all 1976–79 vehicles except the Seville, the filter is mounted in the engine compartment near the fuel pump. On the 1976–79 Seville, and all 1980–85 vehicles, the fuel filter is located on the left side of the chassis just ahead of the rear axle. On 1986–89 vehicles, the filter can be found near the frame, in back of the left front wheel. There are two types of fuel filters used on the gasoline fuel injected vehicles, the one-piece disposable inline filter, used on all 1982–86 250 and 1988–89 273 V8 engines, and the replaceable element type filter used on all the other engines. CAUTION
Fuel is under high pressure: if the steps below are not followed, the fuel could spray out and result in a fire hazard and possible injury.
  1. Disconnect the negative battery terminal.
  2. Release the pressure from the fuel system:
    • Without pressure fitting: Cars without a pressure fitting in the fuel line, cover the fitting to be removed with a shop towel while loosening so that fuel will be absorbed. Dispose of gasoline properly.
    • With pressure fitting: Locate the pressure fitting in the fuel line and remove the protective cap. Loosely install a special valve depressor (G.M. tool no. J-5420) on the fitting. Wrap a towel around the fitting to block any spray and slowly tighten the tool until the pressure has been relieved.
  3. Replace the filter as follows:
    1. On the replaceable element type filter; the fuel filter element is replaced by unscrewing the bottom cover and removing the filter element. Replace the element and gasket with an AC type GF 157 or equivalent. Hand tighten the bottom cover.
    2. On the in-line disposable type filter; the fuel filter canister is replaced by loosening the fitting on the end of the filter, then use a pair of pliers to expand the clamp on the other end and slide it down past the point where the hose extends over the inlet of the filter. Gently twist and remove the hose, unscrew and remove the fitting. Remove and discard the old filter. Install the new filter into the hose and replace the clamp. Reinstall the fitting, and check for leaks with the engine idling. NOTE: A dry fuel system on cars equipped with EFI/DFI may require a substantial cranking period before starting. Be sure to crank the engine in short bursts, allowing time for the starter motor to cool between each burst. Fig. 1: Fuel filter location, disposable type — 1986–87 8-250 and 1988–89 8-273 engines 85871013.gif
      Fig. 2: Fuel filter location, sealed type — 8-250 and 8-273 engines 85871014.gif
      Fig. 3: Common fuel filter location — lower right corner 85871093.jpg Fig. 4: Removing the fuel filter hose clamp 85871094.jpg Fig. 5: Removing fuel filter lines — always use a back-up wrench 85871095.jpg Fig. 6: Removing fuel filter mounting 85871096.jpg

Jun 29, 2010 | 1985 Cadillac DeVille

1 Answer

Fuel line burst

It would be better to replace the whole line. chances are the whole thing is shot.

Jan 31, 2009 | 1989 Chevrolet S-10 Blazer

3 Answers

No fuel going to engine

check the fuel pump or for fuel line leaks

Jul 25, 2008 | 1966 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers


Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides