Question about 2004 GMC Envoy

1 Answer

Endine stalls on occasion after a cold start. No codes on dash, 170,000 on engine no oil burning new wires , cap and rotor air filter clean. Any tips ?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Related to a dirty throttle body. In order to clean it properly you must disconnect the battery and remove it. Not very difficult to do but it will make a big difference in the idle smoothness and fix the stalling. The PCM will reset after you disconnect the battery for 15-20 min and take a few drive cycles to re-learn everything

Posted on Aug 22, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1989 Chrysler New Yorker 3.0L V6 won't stay running in gear. I have replaced the fuel pump, filter, ignition wires, plugs, cap, rotor, coil. It will start right up and run when cold, but when it


Forgetting all you have done & why

What is or was the main issue & when did it start
& under what conditions ?

Does the thermostat open ?
Does it reach 195 or more coolant temp?
Does it go into Closed Loop? (Oxygen Sensors
in control of fuel)
Any OBD Codes in any system?
Fuel Pressure Correct as well as Volume
& under a load while driving

Sounds like you were going to say it only has a problem
AFTER it reaches operating coolant temp

SO- none of what you did appears to be related

First-- you find & resolve all problems. THEN do your
Preventative Maintenance-spark plugs,filters,etc.

Check or test the switch on the transaxle, that is for gear
selection,whatever you have there

May be the only problem you ever had or one of two problems

Only runs when cold-- in park only?
Won't run hot or cold-- in ANY gear?

Can you even drive it at all?

How about an Idle air control solenoid/valve
on or near the throttle body-got one of them?

Nov 21, 2014 | 1989 Chrysler New Yorker

1 Answer

My 97 ranger 4 cyl starts up then stalls when cold when you come to a stop,when it stallls it is very diffuclt to restart but once it warms up it will run fine. any ideas?


Tune up due? plugs, wires, cap,rotor, Clean the throttle body/ carb, replace the fuel and air filter. Check for codes.

Nov 08, 2014 | Cars & Trucks

1 Answer

Cold idle problem


Air filter,fuel filter,dirty throttle body.

May 09, 2013 | 2002 Kia Optima

1 Answer

Runs rough when cold


Hi, Check all sparkplugs and wires. also check rotor and cap for cracks.
Use throutlebody cleaner and clean out air intake and a new filter. Hope that helps
Good luck.

Dec 01, 2011 | 1991 Toyota Cressida

1 Answer

Ai have a 88 chevy s-10 blazer it stall when i drive a block like it starts to cut out does it need a fuel filter, if so is it under the truck or does it need spark plugs only or does air filter only...


I suggest a full tune up.

1. Air filter.
2. Fuel filter, carbureted engine filter is located inside the line fitting where it attaches to the carburetor. Fuel injected engine filter is located in-line under the truck near the tank.
3. Oil and filter.
4. Spark plugs and wires.
5. Distributor cap and rotor if applicable.
6. PCV valve.

Mar 17, 2011 | 1988 Chevrolet Blazer

3 Answers

Driving 60mph power drops as though out of gas. Coast 2-300 yds pump gas pedal van back to normal. Now at home it starts then stalls, will only run 5-10 seconds. New plugs&wires distributor cap and...


signs of a bad fuel pressure regulator. the vehicle runs rough, the engine will not start usually in the mornings. many times engine starts but stalls shortly after starting. a bad regulator can result in fouled plugs. black soot on plugs, blake smoke from tailpipe, running rough, stalling. you could have residue in fuel tank and need to change fuel filter again. have a very good day !!

Mar 09, 2011 | Volkswagen Eurovan Cars & Trucks

2 Answers

No problems really,stalls once in a while. Just curious what consists of a tune-up on my engine. what I should replace and so on.


This would include your spark plugs or coils, the wires, a new distributor cap, an oil change, air filter, fuel filter, and a coolant flush. A tune up can make a car run like new again. Some don't change the fuel filter on a tune up but I have always said it is best too. They can get clogged up over time.

Feb 07, 2011 | Ford F-250 Cars & Trucks

1 Answer

Engine stalls out on occasion like the key was shut off have change air flow sencer mapp sencer new vaccum lines


Check your plugs, wires, distributor cap/rotor, fuel filter, and air filter.

If I had to take a guess, I would try replacing the Distributor Cap & Rotor, as well as the Fuel Filter. Also, try running some Gumout Fuel Injector Cleaner and a tank of good gas through it.

I hope this helps! Best of luck to you :-)

Best Regards,

James

Dec 18, 2010 | 1999 Buick LeSabre

1 Answer

On starting from cold in cold weather the engine will not run smooth and run high then low then stops, runs ok when hot.


your mass airflow maybe bad. or you may just need a tune up. air filter, plugs, wires, cap , rotor, oil change

Dec 27, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
2004 GMC Envoy Logo

246 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...