Question about 2005 Chrysler Town & Country

2 Answers

Passenger power sliding door will not open, open it manually and push the button and it almost closes but falls short and stops. Works fine manually. Cleaned and lubed the tracks but no change

Posted by on

2 Answers

Does the door always stop in the same place? Can you press open and it stops in the same place as when you power close it? I would suggest that the wiring harness is broken in a spot. The track like harness shorts out when it bends at that certain spot. Mine did the same thing. Replaced harness and it works like new.

Posted on Jul 20, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 330 Answers

Either the switch or the motor, most likely the switch worn out.

Posted on Jul 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 caravan power sliding door not working


The 30A fuse J11 in the totally integrated power module (TIPM) protects the driver side power sliding door module. The 40A fuse J3 in the totally integrated power module (TIPM) protects the left rear door module. If these two fuses are good, the modules may be defective.

Sep 10, 2012 | 2008 Dodge Grand Caravan

1 Answer

2007 Kia Sedona van power sliding door


i just had to have this fixed on my 07 sedona on the bottom arm for the doors there are litle lock solinoids that go bad i would take it to a dealer to have it checked for the switch you can turn the power off to the doors and open them manualy but they are hard to open because you are pulling the cable instead of the motor doing it and this will not hurt the doors

Oct 29, 2009 | 2007 Kia Sedona LX Minivan

1 Answer

Passenger sliding door motor won't close door all the way.


I just fixed my 2005 T&C sliding door. The wire in the plastic rolling chain is broken when resides right under the step pad. It took me 30 minutes to fix.

Go to this link.
http://wiki.answers.com/Q/How_do_you_replace_the_power_sliding_door_wiring_harness_on_a_2005_Town_and_Country_chrysler

Good luck!

May 27, 2009 | 2005 Chrysler Town & Country

1 Answer

I have a sicna 03 sliding door on passenger side


DO NOT PUSH IT!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
1. turn off the power button for the power sliding doors located on the lower dash area.
(in for on out for off)
2. close the sliding doors
3. disconect the battery and wait 1 minute.
4. reconect the battery, turn on the power switch
5. use one of the door control buttons open and close the door this should reset the door.

If this fails to get it working i'm sorry but you will need to take it to a dealer.
and most likly it will need a new drive $3000 aproxmatly. it can not be serviced

May 06, 2009 | 2003 Toyota Sienna

1 Answer

Power sliding door doesn't work!


Try taking off the door, or spray some wd-40 on the rail. It sounds like its either not getting enough power or its getting caught on something.

Apr 23, 2009 | 2007 Dodge Caravan SXT Minivan New Cars

1 Answer

05 caravan passenger power sliding door will lock but not open


READ YOUR MANUAL. THERE IS A SEQUENCE INVOLVING REMOVING A FUSE WHICH RESETS THE ELECTRIC DOOR OPENER. IT IS DESCRIBED IN THE MANUAL. EASY TO DO ONE YOU HAVE THE BOOK IN HAND.

Apr 15, 2009 | 1997 Oldsmobile Silhouette

1 Answer

Chrysler T&C Power Door Problem


If it stops in roughly the same spot every time, and won't respond after it has stopped, it sounds like a broken wire. It is likely losing its electrical current to run the motor. It should be right where the track bends when the door has stopped. Check for loose or frayed wiring inside the flexible plastic track just below the door. The wires will often wear after being bent over and over again. If you find a broken bit of wire, cut out that section and splice in a new length of wire. Be sure you do a good job splicing, or you may end up with the same issue again soon. I am not a mechanic by any means, this just makes sense to me, and I'm considering buying an 01 town and country with this issue, which is why I'm on this site to begin with. Best of luck -

Jan 22, 2009 | 2008 Chrysler Town & Country

2 Answers

The power sliding passenger door will not open even manually. At first it didn't want to close, but after I slammed it shut it didn't want to open. A few days later I was trying to get the door panel off...


I think you have a latch issue or a latch release issue, pull the door panel and try and release the door latch, pull the latch and try to see what if anything is wrong with it, also make sure the linkage going to the latch from the release handle is hooked up or not otherwise damaged.

Oct 22, 2008 | 1998 Oldsmobile Silhouette

1 Answer

RH power sliding door stops half way.


you need to have it reprogramed , usually works perfec after reseting, goodluck.

Aug 02, 2008 | 2004 Dodge Grand Caravan

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

345 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...