CAN'T FIND THE D&@%&!M FLASHER ON MY MOTHERS CAR,SHE WON'T GO HOME TILL I REPLACE IT! DON'T GET ME WRONG GUYS I LOVE MY MOM BUT DRIVING ME NUTS! PLEASE HELP? CAR HAS SPLIT BENCH NO CUP HOLDERS TO LOOK BEHIND AND IT'S NOT UNDER HOOD THAT I CAN FIND. DESPRIT!!!!
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is weird! It seems to me that the left turn signal is getting 12v from somewhere at all times.I don't think the flasher is the problem(most GM systems use a single flasher for left and right)You probably have a crossed wire somewhere(or an add on accessory was connected to the left signal wire,allowing 12 volts to bleed through to the circuit)
check the fuse if good then turn on the hazard lights if they work then you probably need a turn signal flasher which is a separate flasher unit then the hazard one.it usually looks like the hazard one so with the hazards on and locate it then you will know what the signal flasher looks like and you will also know not to change the wrong flasher unit.the signal flasher is often located at or near the under dash fuse panel or somewhere in the dash you don`t say what type of car your talking about.
there is a flasher in this.you don`t say what year and model of truck this is so if you turn on the hazard flashers and find its location, the turn signal flasher looks like the hazards but is a different one.the signal flasher will usually be in the same area so this should help you find it,it will be under the dash somewhere or on the fuse box either front or rear of the fuse box.
No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below: Troubleshooting Procedure To start troubleshooting this problem:
Turn the key to the on position (do not start engine)
Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
You are looking for the location of the TURN SIGNAL FLASHER.
The turn Signal flasher on a 00 Chrysler Cirrus.
Is mounted inside of the Turn Signal switch.
Some model If you remove the steering cover you will have axces to the Flasher.
But In some Model you will need to replace the Multifuntion Switch ( Turn signal switch)
OK.. I hope this help on your question.
I'm Based on a AUtorepair Software. to give the answear..