Question about Jeep Grand Cherokee

1 Answer

I have a loose a/c hose and I do not know where it goes

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

I'm not 2 sure if this will work,but maybe you can try searching for the vacant hole/port while the car A/C is running.

Posted on Jul 15, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 chevy express van.I have two hoses that run off of my reserve tank one of the goes to the radiator. and another hose that looks like it goes on the acumlator

From the reserve tank, one hose should go to the radiator and the other should be for overflow. Sometimes that one goes to an accumulator, sometimes its left dangling cause its just there to drain any excess fluid from expansion in a hot system. Depends on the vehicle. If its in an enclosed system or plugged you would get an excess of back pressure which would further heat up the coolant and inhibit flow. Just leave it there. If it pukes coolant when hot then its doing its job. Don't overflow your reserve tank.

Apr 26, 2016 | Cars & Trucks

1 Answer

We replaced the starter and there is hose that came loose and don't know where it goes. How do I figure out where it goes

Look for a round fitting sticking out, right about where the end of the hose should reach.

Mar 30, 2014 | 1997 Mercury Villager

1 Answer

Vacuum hose routing diagram

It goes to the Pvc system. Usually onto a valve cover

Aug 06, 2013 | 1995 Mercury Mystique

1 Answer

Goes dead when you stop gets poor gas mileage

Sounds like a vacuum leak to me, check your intake hose from the filter housing to the engine. Inspect for missing, loose or broken clamps (you'll see a dark stripe on the hose where a clamp used to be. Then check the hose itself for cracks. This is a fairly common problem on older vehicles, resulting in crappy performance due to the engine not knowing how much air is coming in.

If that's not it, try checking the smaller vacuum hoses on the engine and any rubber plugs for dry rotting or shiny fittings where something came loose.

Dec 04, 2010 | 1995 Nissan Pathfinder

1 Answer

1996 Buick Century vacuum problem

Well doesn't matter what it's called.If it is loose and soft then you can take it off and get a new piece of hose from your local parts store.Unless it is a formed hose you will have no problem getting a replacement.You may want to check all other vacume lines as over time they will either get soft and **** shut or dry crack and leak.Any vacume leek will cause problems.Well hope this helps,and good luck.

Mar 14, 2010 | 1996 Buick Century

1 Answer

Don't have any heat

Usually at the top of the hose that goes into the throttle body in that main hose is where it should be but do this when the engine has cooled down and then unscrew the clamp and the thermostat should be inside the throttle body and then just pull it out with your fingers.
PS you will loose some antifreeze doing this so this is normal. If this solution don't help you then just google what you need to do or look on you tube and there are some repair videos on there as well just type in what you are looking for.

Feb 06, 2010 | 1997 Pontiac Firebird

1 Answer

I have a 1987 honda accord, I let it run out of water and it started to overheat, so I stopped the car and let it cool down then added water, drove it home and it was fine(about a mile) Once home I noticed...

Assuming it's a hose that goes directly to the radiator and is a more or less 2" diameter. In the parts store just ask for (depending of its position) an upper or lower radiator hose for a '87 honda accord.

Jan 18, 2010 | 1987 Honda Accord

1 Answer

1991jeep vacuum hose loose on passager side near


Nov 07, 2009 | 1991 Jeep Cherokee Limited

1 Answer

Hose below the drain of radiator is cut loose

this is a service hose intended to drain coolant into a receptacle (bucket) during service. the hose attaches to a fitting on the bottom of the radiator drain valve. when not in use it is simply folded back through the hole in the splash panel, if equipped with a panel. if no panel exists then the tube simply hangs from the drain valve.

Dec 11, 2008 | 1997 Dodge Intrepid

1 Answer

2001volkswagen beetle vacuum hose

Look in the area around the vacuum pump, there is also a vacuum brake booster check valve, check to make sure the lines are plugged into it, Hope this helps.

Aug 25, 2008 | 2001 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

71856 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7036 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides