Question about 1993 Ford Aerostar Extended

1 Answer

Engine won't turn over

I can jump solenoid and crank engine. replaced it- still won't crank

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Hi monkfreak... I had the same problem once only to discover that my ignition switch was faulty..
Are your battery terminal connections loose? Check for broken, loose or disconnected wiring in the starting circuit. Maybe the starter motor. On vehicles equipped with a 2.3 litre engine, built between 8/6/86 and 9/1/86, a no start condition may be caused by a damaged engine control wire harness....I hope this helps...Adios

Posted on Oct 15, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 Monte carlo z34 won't crank over unless I jump


Sounds like a problem with the key switch, probably the security system. You may only have power to the fuel pump when the engine is cranking.
Is the security light on or flashing ?

Jun 29, 2013 | Cars & Trucks

2 Answers

2005 Altima won't start, hear clicking sound coming from fuse box,key stuck in ingintion,won;t turn over,tried to jump start.


the clicking that you hear is coming from the starter relay. sounds like your ignition starter switch or ignition lock cylinder is bad.

May 30, 2012 | 2005 Nissan Altima

1 Answer

Lost key for igntion can i crank with swrewdriver


Yes, you can crank the engine by jumping from the battery connection at starter to the starter solenoid terminal, but car won't start without the ignition being on.

Mar 30, 2012 | 1999 Kia Sportage

2 Answers

Car wont start,seems like battery went dead


If the car doesn't start with a jump you might have a bad alternator. The alternator supplies voltage to the car once the engine is running. If the battery is dead, and the alternator isn't putting out sufficient voltage, the engine cannot run. Then again sometimes a car with an extremely dead or internally shorted battery WON'T start with a jump. Replace the battery and try again.

Dec 22, 2011 | 2002 Hyundai Accent

1 Answer

Won;t crank


Hi, if the car engine fails to crank, there is a fault in one of the components in the battery/ignition/starter circuit. Low battery (Check battery voltage, recharge if low, or jump start with another vehicle or battery charger). Bad starter relay/solenoid (Check for voltage at relay, if relay has voltage but there is no "click" when key is turned to start, replace relay). Bad ignition switch (Check to see if voltage reaches starter relay/solenoid when turn to start. If not, check for open P/N switch and brake or clutch pedal switch. Replace ignition switch if defective).

May 26, 2011 | 1994 Dodge Stealth

1 Answer

Have a 98 ford explorer and it won't start tryed to jump it nothen. Put a starter in and still won't click ove it sounds like it dead but if I play with the power distreber box I'm dash lights...


it could very well be the starter solinoid mounted on fender under hood. most fords are setup this way. to test it -- You could use jumper cable to jump the two large studs on the solenoid together, which should make the starter crank the engine, assuming the engine can rotate freely. If jumping the solenoid works, then the solinoid is probably bad. have a good day !!

May 06, 2011 | Ford Explorer Cars & Trucks

1 Answer

I have a 96 Dodge Intrepid and it wil not start. it clicks when you try to start it. All of the lights in the car are on. the battery has been charged. it cut off on me a few days ago and i thought i...


solenoid clicking, troubleshooting steps: Run 3 tests to troubleshoot.

1. try to jump start at battery terminals
2. unhook the jumpers and try to jump the solenoid following procedures at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over (see picture there--make sure car is in park or neutral)
3. Only if #1 and #2 fail to crank the engine, smack the starter motor (not the solenoid) with a hammer and then try to start.

Based on results of above tests, here are solution options:

If smacking the starter is the only test that worked, you have a dead spot on the starter commutator--replace the starter.

If it will jump start but will not crank by jumping the solenoid, check to make sure the battery terminals are clean and tight.

If it will not jump start and will not crank even by jumping the solenoid, the problem is either the cable to the starter or the starter/solenoid itself.
check the big red wire that goes from the battery to the starter and make sure it is strong and tight at both ends. If that is good, replace the starter/solenoid.

If it will not jump start but will crank when the solenoid is jumped, the problem is with the start circuit not getting sufficient current to the solenoid. This usually only happens when there is a separate starter relay (in the engine compartment relay box) that is worn out. Replace the starter relay.

Please let me know if you have questions.

Oct 17, 2010 | 1996 Dodge Intrepid

2 Answers

95 jeep cherokee country 6 cyl auto. wont crank all the time


Bad solenoid i would guess. Not making a connection there. Any basic wiring and ignition switch problems should be alleviated by jumping the starter with a screwdriver. I would check the solenoid and starter brushes

Dec 30, 2009 | 1994 Jeep Cherokee Country

2 Answers

Turn the key on and the starter will not engage.


check fuel pressure.if not above recomended spec. replace fuel pump. for starting have solenoid 0n starter checked.

Jan 26, 2009 | 1994 Cadillac Fleetwood

Not finding what you are looking for?
1993 Ford Aerostar Extended Logo

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...