Will a 1996 front left door off a mitsi l200 4x4 fit on a 2wd l200 ta.

The body style was the same from 1996 to 2000 for the Honda Civic. Are both of the Civics similar in body style as in they have the same number of doors? Not sure if a wagon or hatchback would interchange with a regular 2 door coupe.

it is actually not to hard, easier if 2wd, remove the front propeller shaft, then remove starter held by three bolts and a nut, install it back tracking

2WD pickups don't have hubs. They have rotors with bearings. Once you have the brake assembly supported, remove nut from spindle. Be sure not to strip the threads on the spindle. Remove the front set of bearings and pull the rotor off. Remove the rear set of bearings. Be sure to pack greases into new bearings prior to installation. Insert new rear bearing into rotor and replace onto spindle. Insert new front bearing and washer and re-install nut. Tighten to recommended torque specs, grease fittings and replace brake assembly.

No it will not....covers that fit OVER the handle will fit but not the actual handle.

Check this for 1996 Toyota Avalon Car Stereo Radio Wiring Diagram Radio Constant 12V+ Wire: Blue/Yellow
Radio Switched 12V+ Wire: Gray
Radio Ground Wire: Brown
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Power Antenna Trigger Wire: Black/Red
Radio Amplifier Turn On Trigger Wire: N/A
Front Speakers Size: 5 1/4" Speakers
Front Speakers Location: Doors
Left Front Speaker Wire (+): Pink
Left Front Speaker Wire (-): Purple
Right Front Speaker Wire (+): Light Green
Right Front Speaker Wire (-): Blue
Rear Speakers Size: 5 1/4" Speakers
Rear Speakers Location: Rear Doors
Left Rear Speaker Wire (+): Black
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Red
Right Rear Speaker Wire (-): White

Hope helps (remember to rate and comment this free answeer).

I haven't replaced pads for your car in particular but I have done many disc brakes before. Remove the tire. Remove the front caliper being careful not to pull on the brake line hose too hard. Leave it connected. The caliper should have only two bolts or more attaching it to the hub assy. After you get the caliper off you can remove the pads paying attention to the way they are installed. Before putting the new pads in take a "C" clamp and compress the caliper piston in all the way so the new pads fit. Always only do one side at a time so you can refer to the other side if you get stuck..Hope this helps.

The LeSabre had the same body style up until 1999 in the rounded style. So it should fit just fine.

There is a relay that goes out on a lot of fords for the 4 w d .did you check that ?

If the 1996 trans is also a 2wd,yes it will bolt right in.One thing to look at though is the connector on the trans on the driver side,they should both be round,8 wire connectors.It is possible that the earlier 94 trans has a different connector in that same location,if so,no it won't work.