Hi, I am missing a few fuses in my 2nd fuse box situated in the engine of my volvo S40
1, Auxiliary Heater fuse
2,Vacuum pump fuse
3, Alarm Horn fuse
Can anybody help? were they taken off for a reason?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
alternator belt braking would not stall the engine but your dash would of lit up like a christmas tree. you will need to have the engine on an obd reader to see what the problem is. did the belt snap or was it stripped ? alternator over load would cut the engine out check the fuse in the engine fuse box there is 2, 80 amp fuse in there check these are fine.
Hi, The fuel pump relay for your Volvo is located in the engine compartment. The fuse and relay box on the drivers side by the windshield. The fuel pump relay is in the back ron of relays and the 3rd one in from the left. If you look inside the cover for the fuse box there is most likely a listing of the fuses and relays. Good Luck
Fuses are there for a reason, if they keep blowing it stands a chance your fan motor is on the fritz and overloading the fuse so it pops. Make sure the tempreture sensor is working ok and not keeping the fan running when it should be turning off.
i have a 98 s40. The fuses can be found internal (under the dashboard near the bonnethandle). Inside it you can find the fuse clamp and extra fuses. These can also be used for the external fusebox under the bonnet. I have found the fuse that might be broken, but i can't replace it because it has some extra casing. It's for internal lights and the alarm.
Passenger compartment fuses are all behind the drivers side (left) kick panel. You should only need a #2 philips head screw driver to remove 4 or 5 screws. After you remove the screws gently pull out on the lower right corner to disengage a plastic tab. The panel then should now come out disengaging metal tabs on the upper to corners. Fuses are on the left.