How do i replace my turning signal lever - 2005 Buick LeSabre

if you don't have any burnt bulbs you may have a problem with the signal lever itself, it may just be worn out.

There should be a turn signal flasher and a hazard flasher. They are two different parts. If you replaced the hazard flasher and not the turn signal flasher than I would start by replacing the turn signal flasher.

One thing you can do once you find the turn signal flasher is to unplug it and use a jumper wire between the two pins of the connector then turn the key to the run position and place the turn signal lever in the left or right position. If the turn signal lights know light up than the turn signal flasher is the problem

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

there should be a fuse for the direction light. and a direction switch can be bad and still click and operate as it suppose to

Just fit a new one the ball bearing spring loaded thingy ahd broke away

The switch is broken inside. You will have to pull the steering wheel off with a wheel puller, and replace the whole switch.

Multifunction Turn Signal Lever Replacement - On Vehicle

Removal Procedure

1. Verify that the multifunction turn signal lever is in the center of the OFF position.
2. Disconnect the negative battery cable.
3. Disable the SIR system.
4. Remove the steering wheel.
5. Remove the steering column trim cover.
6. Remove the steering column knee bolster.
7. Remove the steering column wire harness (1) from the steering column wire harness retainer (2).
8. Remove the 2 wire harness straps from the steering column wire harness (1).
9. Remove the steering column bulkhead connector from the vehicle wire harness.
10. Disconnect the connectors from the multifunction turn signal lever steering column bulkhead connector.

1. Remove the retaining bolts (1) from the multifunction turn signal lever (2).
2. Remove the multifunction turn signal lever (2) from the steering column.

Installation Procedure

1. Install the multifunction turn signal lever (2). Use a small flat-blade in order to compress the electrical contact and move the multifunction turn signal lever into position.
2. Verify that the electrical contact rests on the canceling cam.

Notice: Refer to Fastener Notice in Service Precaution.

1. Install the retaining bolts to the multifunction turn signal lever.

• Tighten the retaining bolts to 7 Nm (62 inch lbs.) .

1. Connect the gray and black connectors to the multifunction turn signal lever steering column bulkhead connector.
2. Connect the steering column bulkhead connector to the vehicle wire harness.
3. Install the two wire harness straps to the steering column wire harness (1).
4. Install the steering column wire harness (1) to the steering column wire harness retainer (2).
5. Install the steering column knee bolster.
6. Install the steering column trim cover.
7. Verify that the lever is in the center or the OFF position.
8. Install the steering wheel to the steering column.
9. Enable the SIR system.
10. Connect the negative battery cable.

I hope this helps you.

Thanks

Possibly turn signal relays do you hear the clicking when you have the blinker selector lever on?

I Think your turn signal switch is most probably faulty. So that, you will need to replace it. Please, check the video below. It shows the operations to replace the turn signal switch. I think that the operations are quite similar in most modern cars. Good luck!

How to Easily Replace a Turn Signal Switch - Clio 2 and other Renault/Dacia

http://www.youtube.com/watch?v=JKiy-F8pd6o
How to Easily Replace Turn Signal Switch Clio 2 and other Renault Dacia

I suspect you need to replace the lever unit.

There is a problem with the contacts in the switch, you will need to replace the switch to correct this issue.