- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
My 97 Voyager has done the same thing. It was control panel programing, the following instructions is how to program your control panel: 1) SET BLOWER ON HIGH 2) SET MODE TO PANEL 3) SET TEMP TO COLD 4) PRESS WASH AND REAR WIPER TOGATHER AND HOLD FOR 5 SEC. IT WILL GO THROUGH A SERIES OF FLASHING, WHEN DONE THE REAR WIPER SHOULD BE THE ONLY ONE FLASHING PRESS REAR WIPER TO EXIT. DO THIS WITH VAN RUNNING. This worked for my 1997 Voyager. I hope it works for yours.
Sometimes they plug up or somewhere along the line it gets pinched. Take the line off of the nozzle in the back and try it out to see if you have good fluid flow with the hose removed. If you have good fluid flow your nozzle is likely plugged up.
It can be several things. Te simple one is that the connector behind the cluster is loose. The other is the circut board that makes up the cluster is going bad. Try disconnecting the cluster and re connecting. If this does not work, try replacing it with a sed one from a salvage yard or from ebay.
you have to replace the " body control module " located under dash drivers side. and most of time they have to be reprogrammend unless you buy it new from dealer and they do it before you get it. the body control mod controls all those items and go bad alot.
1. Set blower to HIGH 2. Set mode position to PANEL (AC vent air) 3. Open all AC outlets 4. Temp. on full cold 5. Start engine 6. Push WASH and REAR WIPER switches for 5 seconds until all panel lights are on solid System will then go through it's paces as it calibrates the climate controls 7. When calibration is complete only the REAR WIPER switch/light should be flashing. Press this switch to extinguish the light and all should work normally.