Question about 2003 Pontiac Montana

2 Answers

1998 Pontiac Transport Blower resistor

I tried to locate the blower resistor by removing the glove box but could not locate it. Do you know where it is located and if I can get to it very easily?

Posted by on

  • jdmynatt Jul 13, 2008

    I mistakenly typed 2003. The vehicle is actually a 1998 transport and I removed the glove box but could not locate the blower resistor on the blower motor. Is it inside the engine on the firewall? If so is it reachable?

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

This is a fun fix.
It is under the glove box.
If I remember correctly you need a 1/4 socket for almost everything.
I also found out the hard way that it is a whole lot easier if you pull the blower motor out first.

Posted on Jun 23, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Pontiac Master
  • 2,039 Answers

On the blower motor under dash passanger side good luck pierre

Posted on Jul 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trying to locate the blower motar resistor on a 2012 nissan sentra


the resistor is below the glove box. remove glove box, and you will see the blower motor. resistor is beside the blower motor. it only has a couple of screws.if you think you can get to it without removing glove box. this is fine.the resistor has about 4 wires going to it. good-day!

Apr 14, 2014 | Nissan Sentra Cars & Trucks

1 Answer

Trying to find blower motor resister on a 98 grand am pontiac i need to replace it but dont know where to start can some one be detailed


REMOVE LOWER RIGHT DASH INSULATOR PANEL FROM BELOW THE GLOVE BOX.YOU HAVE TO SLIDE BCM MODULE ASIDE THE BLOWER MOTOR RESISTOR ON THE BLOWER MOTOR HOUSING WHERE ELECTRICAL CONNECT TO BLOWER MOTOR. TO KEEP FROM SETTING OFF THE THEFT SECURITY SYSTEM, WHEN YOU MOVE THE BCM MODULE. ASIDE FIRST TURN OFF RADIO,THEN DISCONNECT NEGATIVE BATTERY CABLE.THEN REPLACE BLOWER MOTOR RESISTOR.

Jul 31, 2011 | 1998 Pontiac Grand Am

1 Answer

For a1998 i need to know where is the relay for a grand am blower motor resistor stop blowing


RELAY SHOULD BE ON TOP OF AIR PLENUM BEHIND GLOVE BOX (MOST GM)
THE RESISTOR IS LOCATED UP STEEM FROM BLOWER MOTOR (BOTTOM PASSENGER SIDE) CHECK FOR POWER AT BLOWER MOTRO CONECTION FIRST AND FUSE ALSO
VERY RARE TO LOOSE ALL SPEED AT ONCE UNLESS FUSE OR BLOWER MOTOR OR
SWITCH

Apr 17, 2011 | 1998 Pontiac Grand Am

2 Answers

I have a 1998 ford f 150 and the blower motor only works on high


This problem is caused by a defective blower motor speed control resistor.

BLOWER MOTOR LOCATION
The blower motor resistor is located under the glove box. You can locate it by finding a 4 wire connector, directly below the glove box hinge (towards the front of the truck). There are 2 screws holding it in. A mirror is helpful in replacing this, but I managed to replace it without one. You will need a nut driver to remove the screws. My suggestion is to leave the wires connected to the resistor while removing the screws.

Nov 10, 2010 | 1998 Ford F150 Regular Cab

2 Answers

Blower motor resistor location


should be right next to the blower motor, heavy gauge wire running to it

Oct 22, 2010 | 1998 Jeep Grand Cherokee

1 Answer

How to replace blower motor resistor


The blower motor resistor is located behind the glove compartment adjacent to the blower motor.There is a access door under the dash right below the glove box, There are few screws that you will have to remove to take the door out. The blower motor resistor, is to the left of the blower motor in the air conditioning case.The blower motor resistor is held by screws,remove the screws to take the resistor out. Keep updated with any further queries.Thanks.

Oct 12, 2010 | 1998 Chrysler Town & Country

1 Answer

2001 Grand Prix: Is the blower motor resistor on a Pontiac 2001 Gra...


It is behind and underneath the glove box back by the firewall. No need to pull out the glovebox.You may need to pull the carpet back to get to one of the bolts.

May 16, 2010 | 2001 Pontiac Grand Prix

1 Answer

Remove dash to get to sensore for blower on 2002 dodge ram 1500 the blower only works on high


If the blower motor is only running on high the problem is the blower motor resistor. location for resistor is behind the glove box. Remove all items in glove box. remove glove box from dash and to the left of the blower motor you will see a electrical plug, remove the plug and the resistor mounting bolts. remove the resistor and replace it with new resistor. reinstall all items as you have taken them off. hope this will help you.

May 12, 2010 | 2004 Dodge Ram 1500

2 Answers

I'm looking for the location of the resistor on the blower motor of a 99 pontiac grand prix


If it is the same as a 2002 Grand Prix the resistor is located on the firewall behind the blower motor up under the glove box. You need to remove the blower motor to get to it.

Mar 12, 2009 | 1999 Pontiac Grand Prix

Not finding what you are looking for?
2003 Pontiac Montana Logo

386 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...