Question about 1995 Toyota Land Cruiser

2 Answers

I have an 1995, 80 series Toyota Land Cruiser, multiple electrical fault/s occured @ same time, 1. When you press on brake pedal several things occur the park lights turn on, the instrument panel lights up 2. when you turn on head lights the brake lights are fully on eg as if you are pressing the brake pedal. 3. The fuel tank caution is on. can you assit?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

More than likely a brake light globe inserted around the wrong way eg 180 degrees around, or incorrect globe fitted,globes can do wonderful things when incorrect.

Posted on Sep 20, 2008

No easy one but some main wire under your dash is hook wrong did u have any thing new fit in

Posted on Sep 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

BRAKE PEDAL GETS HARD WHILE BREAKING


brake switch bad, system needs bled, rear brake circuit probably has air in fluid, fluid is no doubt contaminated, nobody addresses this maintainance problem, bleed entire brake system, replace all fluid w/ new. if fluid in the master cylinder is black, seals are bad, some brake systems have a pump as part of master cylinder, these pumps run off fuses , 25amp, etc., check what system you have. is your fluid level correct ? the switch I refer to is @ proportioning valve below master cylinder @ frame, see abs brakes use this valve to prevent skidding, rear brakes must come on first, before front brakes. if valve is not in balance a hard brake pedal occurs, as with low fluid levels. does your brake light come on ? @ dash. have a brake shop bleed your system, if there's a problem they'll find it for you, let them do it, don't wast your time.

Jan 13, 2013 | 1994 Toyota Land Cruiser

1 Answer

HOW DO YOU BLEED THE BRAKES ON 100 SERIES CRUISER


Start the engine, fill up full the brake fluid reservoir, and let someone press the brake pedal down to the floor for 3 times,, bleed the bleeder screw behind the tire.. position yourself closed to back plate of drum or caliper for easy bleeding work. when the bleeding screws is loosed brake fluid leaks with a bubbles. then close it again and tell the guy in the pedal brake to press it again until a hard press is felt and bleed the bleeder screw again, stop only the process when there is a hard pressing already on the brake pedal which is the brake system is now working properly.

Aug 16, 2011 | 2003 Toyota Land Cruiser

1 Answer

Brake lights not working


the brake pedal you depress with your foot has a plunger style switch that activates the brake lights. that switch is at fault if the brake lights do not operate upon pressing the pedal

Apr 02, 2010 | 2004 Toyota Land Cruiser

1 Answer

I own a 2006 gxl 4.2td and after braking the brakes seem to thud. it almost sounds like the brakes release suddenly and grip again. i don't believe its a gearbox problem but it may be. it seems to be more...


you probably need to isolate thi noise better. does it occur going over bumps in the road,or only when braking. maybeput the vehicle in a lower gear and see if it occurs when jabing the gas pedal up and down. if only when braking lock at the parking brake to see if it is stuck on.but feeling like the brake is releasing and reapplying semms to indicate something is rolling around.. coul be a hard one.

Feb 21, 2010 | 2006 Toyota Land Cruiser

1 Answer

Hi I am installing a trailer electric brake


I belive it would be the wire that actually sends the control signal to the controller?...correct? well the if so you would need to tap into the wire casing with a test light to see which wire is lighting the test light when the brake pedal is depressed good luck

Sep 11, 2009 | 2006 Toyota Land Cruiser

1 Answer

Loud intermittent vibration in 1997 Toyota Land Cruiser


100 series landcruiser auto 98 model 226000 km
whine from front end after 25 kmh no noise when backing off

Nov 23, 2008 | 1997 Toyota Land Cruiser

2 Answers

Toyota land cruiser 1997 80 series electrical wiring diagram


what are the colour of the wires for the unlock / lock for the central locking for a toyota landcruiser 1990 modle ?

Nov 08, 2008 | 1997 Toyota Land Cruiser

Not finding what you are looking for?
1995 Toyota Land Cruiser Logo

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...