Question about 1990 Honda Civic

1 Answer

Engine quits Eninge stops running when drivng a highway speeds (above 45mph) this is random occurance. After the engine stops I can restart the car with no problmes and continue on.?

Posted by on

  • Anonymous Jul 13, 2008

    possibly loose ignition wiring - inexpensive fix.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 2,039 Answers

Block gas filter when you drive gas pressure go truh the filter pack it up less pressure car stall some gas go back ih tank unpack the filter if it would be electrical it wouldnt start (ingniter.or coil) check it out hope it fixya our post thanks pierre

Posted on Jul 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yukon XL was first showing Reduced Engine Power, then Oil Gauge quit working, now car is running hot


Might help, disconnect negative terminal from battery for 10 minutes, if the compute is getting weird readings this will reset it and maybe help.

Dec 09, 2013 | 2005 GMC Yukon XL

1 Answer

Is it possible not to bend valves when timing slip


Its possible, but the odds are high some valve damage will occur.
If the engine is running at highway speed and the belt breaks, odds are some of the valves will hit the pistons before the engine stops.

Jun 18, 2013 | 1997 Mitsubishi Galant

2 Answers

What is the overdrive for is it to down shif or to go up a hii


overdrive is for highway driving, lowers your engine rpm's and saves gas-allows the engine to not work as hard at higher speeds. Not desirable in around town traffic, and if you can lock it out if you do most driving under 45mph, a good idea so you don't 'lug' your engine.

Apr 12, 2011 | Ford F-450 Cars & Trucks

1 Answer

I have a 2005 Ford Focus ZX4 ST. I have less than 73k miles on it. Have never had any issues with it. Perform all the regular maintenance at required intervals. About a month ago the check engine light...


I would start with plug wires rubbing on something and created a short.and is not compleatly worn through. a cheep place to start. good luck with it.

Mar 25, 2011 | 2000 Ford Focus

1 Answer

I have a 1999 Dodge Ram that quits running (randomly) at highway speeds or even at a traffic light.You never know when it will happen. The instruments quit working, fuel gage shows empty when it is full,...


My dad had the same problem with his truck, if you wiggle the harness that goes into the ecm(computer on the right firewall) it should start back up. If it does then your probably gonna have to replace the ecm

Aug 02, 2010 | 1999 Dodge Ram

1 Answer

1990 jeep wrangler 4.2liter loses speed and acceleration while driving up hills, especially at highway speeds


On an older engine, it is quite possible that the engine is just worn out. Check the compression not only for variation between cylinders but for lower than normal across the board.... should not be much lower than 120 in each cylinder. There is no timing adjustment on your engine so you pretty much are stuck with what you have unless you saw off the distributor hold down tab and use another means to lock it down and adjust it. You also need to make sure that the overdrive is releasing under load (when driving above 45mph, touch the brake and it should disengage momentarily). I'd also make sure that any "kickdown" cable or linkage from the throttle to the transmission is adjusted and working properly.
If the engine is otherwise running well, these items may help a bit. Make sure the air filter is clean and that the exhaust is flowing well. Without either the engine cannot breathe and will also have problems.
good luck

Jan 12, 2010 | 1990 Jeep Wrangler

1 Answer

1988 Beretta V6 2.8L


This might be the mass air flow sensor or egr valve.

Jan 31, 2009 | 1988 Chevrolet Beretta

1 Answer

Isuzu trooper engine stops while driving


If its the 3.0 diesel it could be the rail oil pressure sensor starting to pack up .

Jan 21, 2009 | 1999 Isuzu Trooper

Not finding what you are looking for?
1990 Honda Civic Logo

Related Topics:

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

70374 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...