At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Ford pu F250 1993 turbo diesel - wipers are not working. I have replaced the switch and the fuse is good.
Any suggestions of where else I can look?
Thx
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It was a dark and stormy night . . . . actually it was. I had been experiencing someproblems with the intermittent wipers on my '88 F 150 the past week and that ...
Need to remember that air rises. When replacing slave cylinder first hook everything up and bleed using the nut on the connecting line at the slave, then slowly depress and release pedal making sure to keep plenty of fluid in the reservoir, then after sitting a bit, tap on slave cylinder, line from bottom all the way up to the master, then loosen the nut connecting the line to the master and allow any air there to escape. Repeat whole process if needed.
With a vault meter check that there is 12 volts at the wiper motor with ignition and wiper switches on . If no voltage wiper switch or fuse faulty. If 12 volts motor at fault.
There is a junction block about 6 inches in front of the battery on the fender, there should be battery voltage on the big wires. The small wire is the starter solenoid. Front the junction block, the power goes to the light switch then to the ignition switch.
Sounds like a loose connection, Clean the fuse contacts. Sometimes lubricant and dirt gets on the contacts within the switch itself and this will interfere with power supply. Have you checked the wiper relay corrosion and wear on the relay contacts impair electrical connection. Brighten up contacts with fine sand paper and if the relay contacts are suspect, remove the cover and draw folded sand paper between the contacts until clean.
Click the large item that says "DOWLOAD LINK". That will give you a 570 megabyte ZIP file containing the official Land Rover service manual. It's free.
When downloaded, extracting the files, leave all files in the "rave" folder. Go to the "pdf" directory, go to "library", click on "libld", that's the Defender manual.
You can find the Electrical Manual from there. Best of luck,
×