Question about 2005 Dodge Magnum

2 Answers

Car wont start but will turnover

No fire from plug wires

Posted by on

  • 6 more comments 
  • Anonymous Aug 01, 2008

    There is a cam sensor and a crankshaft sensor that could be bad. The motor will spin over fine, but these 2 sensors could keep the motor from getting gas to start.

  • bmoore65 Oct 25, 2008

    I have a 1990 Dodge Ramcharger and it ran great until one day heading down the road it just quit. I got it towed home and found that I have no spark. I had the coil checked at Auto Zone and it was OK. People tell me it could be a ballast resistor, but I can't find that it has one. Any ideas?

  • Anonymous Nov 10, 2008

    car wont start but will turnover problem, and notify you when a new solution is offered.

  • Anonymous Nov 16, 2008

    I have the same problem HELP

  • William Booher Nov 25, 2008

    I have a 2001 Dodge Stratus 2.4L DOHC that is having the same problem the car ran fine then quit running the engine cranks ove but I get no spark from the plugs. what could be the problem???

  • Anonymous Dec 26, 2008

    2004 dodge stratus wiil turn over but wont start

  • tee bible Jan 22, 2009

    96 dodge stratis turns over wont start. changed dis.cap and rotor. cap was cracked. checked timing belt.

  • tee bible Jan 22, 2009

    96 stratis 6cyl. no fire from plugs distributor cap was cracked change cap and rotor. checked timing beltits good.

    still no fire. help

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 126 Answers

Ya hi there do you know motor size and year ? can you locate the ignition coil ? if so check to see 12 volts is present when you turn ignition to start position? check all fuses and also check relay's take each relay out and wiggle back in might be a bad connection .

Posted on Jul 12, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

2005 doge magnum wont start??? lights windows and horn works but the car wont start??

Posted on Sep 19, 2009

3 Suggested Answers

  • 4 Answers

SOURCE: car died while running and wont start

crank sensor

Posted on Apr 19, 2009

junkman1249
  • 552 Answers

SOURCE: no spark

check the relay on the distributor

Posted on Aug 20, 2009

  • 20 Answers

SOURCE: replaced iac car wont start if it does turnover

the iac valve adjusts your idle if you somehow left a vacuum hose off or the air intake hose lose your engine wont run or if it does it will run very rough other wise check you maf sensor located near the air box

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1994 CONCORD NO POWER TO FUEL PUMP, NOT FIRING AND DOES TURNOVER, REPLACED CRANK SENSOR AND CAM SENSOR, TRIED DIFFERENT RELAY FOR FUEL PUMP-STILL WON'T START?


NO POWER TO FUEL PUMP......CHECK ALL IN LINE WIRING
NOT FIRING... START WITH COIL PACK, DIST CAP ETC...PLUGS/WIRES??????
"HOT WIRE" (DIRECT W/ FUSED JUMPER) TO FUEL .PUMP....NO - GO,,,BAD PUMP

Oct 09, 2011 | 1994 Chrysler Concorde

1 Answer

I have a 68 chevelle and my car will not turnover, its not the battery and i just recently put new spark plugs,wires,rotor,distributor cap, ignition module and coil and my car doesnt turn over it cranks...


If the battery is fully charged and you have good connetions, sounds like an ignition timing problem. If the timing is too advanced, teh plugs will fire before the piston is high enough in the travel and when it fires will try to turn the engine over backwards. Check to be sure the firing order is correct and you didn't mix up any plug wires since having some firing at the wrong time will do the same thing. Stock engines will have the firing order cast into the intake manifold for easy reference.

Oct 16, 2010 | Chevrolet Classic Cars & Trucks

1 Answer

I'm trying to remove my 02 lancer ls car alarm. I've removed the box and all the wires that was connected to the box but my car still will not start. I've even replaced the starter and it still won't...


The alarm had a wire to not let the car turnover/crank, is that what you mean, or the car turnsover/cranks, but wont run. If it wont turnover, usually its a larger wire that was cut and the alarm wired in, you will need to get this wire reconnected again. I dont have a diagram here to tell you the wire color, but usually its a 10-12 gauge wire. So if you have a 2 wires the same color, and its cut, connect them back again.

Sep 05, 2010 | Mitsubishi Lancer Cars & Trucks

1 Answer

The truck was sitting for about 10 years, everything electrical works, i replaced the spark plugs, wires and rotor before even trying to turn it over, the engine wants to turnover and the spark plugs are...


if its carberated, u need to clean that out. if its fuel injected, replace the fuel filter. if it stil dont work. then u have a fuel injector problem

Mar 05, 2010 | 1986 Toyota 4Runner

1 Answer

Car will not start,the car will turnover but will not crank...fuel pump is 1 yr old...please advise


Try spraying starter fluid in the breather to see if the problem is fuel related or electrical.If the car starts and dies it is fuel related. Check the fuel pump relay .if its good the problem will be the fuel pump..Next electrical remove a spark plug wire to see if it is firing at the spark plug . Let me know how it comes out.. GOOD LUCK!

Feb 28, 2010 | 2003 Pontiac Grand Am

1 Answer

95 mx6 4cyl


May have scored the cylinder walls and lost the ring tension. Can you give it a compression test??

Feb 15, 2010 | 1995 Mazda MX-6

Not finding what you are looking for?
2005 Dodge Magnum Logo

959 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...