Question about 2002 Suzuki Aerio

3 Answers

License Plate bulbs

I have a 2002 suzuki aerio....I have no manuel and I need to change the license plate bulbs. Can anyone help

Posted by on

  • YvetteFromNJ Jul 12, 2008

    Hate to be a pain but the bulbs are not under my bumper....They are right above my licence plate. When I lift the hatchback I was thinking I should be able to access them from there but dont know how

  • YvetteFromNJ Jul 13, 2008

    Thanks.....got it

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

I turned the lens anti clock wise to remove it and removed the bulb with rent needle nose and replaced bulb with needle nose, little difficult but not impossible, for the novice it will be a little trial and error

Posted on Apr 26, 2015

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Not at all, the cover over the light bulb pops off. and with a needle nose plier, the bulb lifts out. A bigger problem is getting the new bulp in removing the back panel will NOT get you to the light unless you care to remove the entire light socket. Not needed to perform the task.

Posted on Aug 22, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 217 Answers

They should be reachable from under/behind the bumper

Posted on Jul 11, 2008

  • Mike Wright Jul 12, 2008

    Sorry, I didn't mean under the bumper literally, I was implying more that they can be reached from under the car, by reaching over the bumper. Since you have a hatchback though, the inner panel detaches fairly easily for replacement of bulbs. There may be a few plastic clips to remove that are holding the panel down around the edges/ends. There may be a few others, under the panel, that actually snap and hold the panel into place. For those, you should be able to pull the panel out with just enough force to get the clips to pull out of their holes.



    Note: The side panels may be helping to hold the center panel down. So they may need to be removed first.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear wiper, defroster and licence plate lights stopped working on my 2007 suzuki swift but when I open the rear hatch the licence plate lights come on . Any ideas what's wrong?bad ground?


[PDF]Wiring Diagram.pdf - Ken Gilbert

ken-gilbert.com/wrx/mans/99.../Wiring%20Diagram.pdf
Each connector number shown in the wiring dia- ... Rear defogger cord (Ground). Fuel tank cord,. Roof cord, ... circuit. Then check the switch, relay, fuse, ground, etc. 4. .....Rear wiper motor. Rear wiper ... License plate light RH. Tail light LH.

#? license plate light - Circuit Wiring Diagrams

circuitswiring.com/tag/license-plate-light/
2008 Volkswagen Newbeetle Main Fuse Box Diagram 2008 Volkswagen Newbeetle ...Parts: rear window defogger, shift lock, battery positive voltage, interior light, A/C clutch, ... brake light, daytime driving light, wiper and washer system, vacan, fuel pump, central ... 1997 Suzuki Geo Tracker Left Dash Fuse Box Diagram.

#? license plate light - Circuit Wiring Diagrams - Page 3

circuitswiring.com/tag/license-plate-light/page/3/
Audi A4 Engine Fuse Box Diagram Audi A4 Engine Fuse Box Map Fuse Panel ... mirror control, wiper, washer, horn, brake light, cruise control, heated rear window, ... 2003Suzuki Aerio Dash Fuse Box Diagram 2003 Suzuki Aerio Dash Fuse Box ... rear defroster, fuel injection controller, radio, A/T controller, hazard light, ...

Jan 05, 2016 | Suzuki Cars & Trucks

1 Answer

Which fuse goes to tag lights on 98 ford explorer


Which fuse belong to license plate light or which number ...

www.fixya.com/cars/t10801433-fuse_belong_license_plate_light_or
Nov 11, 2011 - The licence plate lights are in the same line as your tail light wiring assembly. I assume your ... Previous owner cut wires going to lights for license plate. ... 1996 ford explorer license plate fuse ... 09@1998 ford f150 fuse box.

1997 Ford license plate lights are not working. - Ford Explorer ...

www.explorerforum.com > ... > Performance Lighting

Mar 13, 2011 - 5 posts - ‎4 authors
can anyone tell me why my lights would not be working on my license plate, i replaced old bulbs with new bulbs and checked every fuse and ... Parking lights stay on
19 posts
Sep 5, 2012
my tail lights wont work, and im out of ideas. i need help ...
18 posts
Sep 15, 2011
License Plate Lights
11 posts
Mar 24, 2011
trailer light problem
15 posts
Apr 22, 2009
More results from www.explorerforum.com

Dec 10, 2015 | Ford Cars & Trucks

2 Answers

Change the license plate lights in my 2002 buick rendezvous cx


On most GM cars, SUV's, and light duty trucks, the license plate light bulbs are held in place by 2 screws...located on each side of the plastic lens...remove these 2 screws then wiggle the entire assembly out so you can view and replace the bulbs...Again most GM cars have 2 bulbs also...Hope this helps.

Sep 06, 2013 | 2002 Buick Rendezvous

1 Answer

How do you change the rear license plate light bulbs???


First look under when your license plate lights are and you will see 2 phllips headed screws remove those screws and the license plate light assembly will drop out of the bottom of the trunk, simply twist the blub to unlock it from the light housing pull the bulb straight out of the socket replace it with a new bulb and the installation is the reverse of the removal.

Dec 06, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I need to replace the bulbs above the license plate on my 2002 eldorado how do you replace them....get at the old bulbs


Hello: Remove the license plate, then remove the screws on the chrome piece behind the license plate and the you can access the bulbs.

Nov 24, 2010 | 1999 Cadillac Eldorado

1 Answer

Need part # for License Plate bulb.


i looked in my owners manuel it said the license plate lamp is bulb type 168 hope that helps

Nov 12, 2010 | 1998 Jeep Grand Cherokee

1 Answer

My license plate lights are out...what kind of bulbs do i need??


Check this reference guide...

2002 Hyundai Accent Car Lightbulb Size Guide
Low Beam Headlight Bulb Size: 9003/HB2
High Beam Headlamp Light Bulb Size: 9003/HB2
Parking Light Bulb Size: 2357A
Front Turn Signal Light Bulb Size: 2357A
Rear Turn Signal Light Bulb Size: 1156
Tail Light Bulb Size: 1157
Stop Light Bulb Size: 1157
High Mount Stop Light Bulb Size: 921
License Plate Light Bulb Size: 168
Back Up Light Bulb Size: 1156
Front Side Marker Light Bulb Size: 2357A
Rear Sidemarker Light Bulb Size: 168
Map Light Bulb Size: DE3175
Dome Light Bulb Size: DE3175
Step/Courtesy Light Bulb Size: DE3022
Trunk/Cargo Area Light Bulb Size: DE3022

From Sylvania Lamp Replacement Guide
License plate
168
168LL Long Life Upgrade: Up to twice the life of the standard lamp.


I hope help you with this. Good luck (remember rated this help).


Sep 09, 2009 | 2002 Hyundai Accent

1 Answer

How do I change the rear license plate light bulbs?


License Plate Lights Removal & Installation License plate lamp retainer clips
a555c7b.gif
To Remove:
Remove or disconnect the following:
  1. License plate
  2. Pin-type retainers and the luggage compartment lid trim panel
  3. License plate lamp electrical connector
  4. Lamp socket from the license plate lamp
  5. Using a suitable tool, through the access hole, release the clips and remove the license plate lamp
To Install:
  1. Install or connect the following:
  2. License plate lamp
  3. Lamp socket to the license plate lamp
  4. Electrical connector
  5. Luggage compartment lid trim panel
  6. License plate

Jun 06, 2009 | 2000 Lincoln LS

1 Answer

My license plate light is out on my 2002 Volkswagon Bug


Hi, press clip from inside and licance plate light assambly come out to you.

Mar 05, 2009 | 2001 Volkswagen Beetle

1 Answer

2002 license plate bulbs


its real simple look at the license plates then look up you will see 2 screw per lamp / unscrew them and slide remove its a 194 bulb so get some ready then replace and put back / Please rate my response thank you very much

Feb 01, 2009 | 2002 Toyota Avalon

Not finding what you are looking for?
2002 Suzuki Aerio Logo

483 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...