Question about 2000 Oldsmobile Intrigue

4 Answers

Flasher on the front turn signal

Does anyone one know where in the car i would find the place to replace the flasher for the front turn signals..Today i went and bought the part that i was told i needed, the man at the auto parts store said that i would find the place under the hood, I looked but didnt see it so if anyone can tell me where i would find it i would appreciate it

Posted by on

  • Dee221944 Mar 30, 2009

    I have the same problem to and found out what to do. It's a very cheap part. It only cost me $8.99. So now my only problem is trying to find out exactly where it is located. Oh yea its called a flasher and it is in the dash board some where.

  • spacecase_56 May 18, 2009

    I have a 1998 intrigue and my rear turn signals and flashers work but my front ones don't, where in the heck is the flasher, i'm also guessing it's in the dash somewhere, but where?

×

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

I also have the blinker problem, but have found a temporary solution. I thought that I could press the hazard button numerous times to get the blinkers to work, but was just lucky the few times that I tried. I have actually lodged a piece of paper on the right side of the hazard switch and this has done the trick. The easiest way to replace the hazard switch is to go through the AC vent directly above the radio. There are two clips holding the vents to the dashboard. One is on the top and one is on the bottom directly in the middle. The hardest part is trying to disengage the hazard switch from its holster of sorts. The part should cost about 50-70 dollars and will fix your problem.

Posted on Sep 07, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

This is not the solution, but it may help. I have problems with my turn signals every now and then. Simpley, they just stop working. I can get them to work again by pressing the "hazard" button in and out repeatly. Then try the blinkers and they work again. Why? I guess the flasher unit just get stuck. Lastly, I tried to find this rascal too. I listen for it and it seems to be to the right of the Hazard button. How in the world I'd get in there???? So for now, I'm playing with the Hazard button to make it work.
Hope you're blinking again soon...
Marty -MI

Posted on Jul 15, 2008

The flasher is part of the hazard switch on the dash

Posted on Aug 05, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Some one suggested that the ignition switch could be worn out. I have the signal light problem and thats what I'm going to try.

Posted on Sep 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Left front turn signal was not working, and i replaced it with a new bulb but it did'nt work...please help .. ty


try changing the signal flasher. note the e-flasher looks the same. when you find a flasher turn on the e-flasher so you know you have found the signal flasher. they are usually in the same general area.

Aug 12, 2015 | 2006 Pontiac Montana SV6

1 Answer

Turn lights blink with hazards but not with turn signal..flasher replaced. is It the multifunction lever then??


There should be a turn signal flasher and a hazard flasher. They are two different parts. If you replaced the hazard flasher and not the turn signal flasher than I would start by replacing the turn signal flasher.

One thing you can do once you find the turn signal flasher is to unplug it and use a jumper wire between the two pins of the connector then turn the key to the run position and place the turn signal lever in the left or right position. If the turn signal lights know light up than the turn signal flasher is the problem

Sep 09, 2014 | 1997 Oldsmobile Cutlass Supreme

1 Answer

My turn signal flashers are all out but emergency blinkers work, I replaced the flasher relay switch but it did not help


try to test turn signal switch, which its the live wire is not sending signal to the flasher.

Mar 07, 2013 | 1990 Buick Century

2 Answers

Cadillac deville 1983 flasher


all gm cars and most others have two flahers one turn signal and one hazard check behind the fuse box for the other flasher

Dec 15, 2012 | 1983 Cadillac DeVille

1 Answer

I'm hoping someone can tell me where the flasher relay is. Not the part that's behind the hazard switch, but the actual relay that they give you at the parts place. You know the 3 prong square plug thats...


FLASHER UNIT BUILT IN THE TURN SIGNAL WIND SHIELD WIPER SWITCH YOU HAVE TO REPLACE TURN SIGNAL SWITCH TO FIX FLASHER.SINCE ALL BUILT IN ONE UNIT.

Feb 11, 2011 | 1998 Volvo S70

2 Answers

Turn signals won't flash. They do come on but no intermittant flashing. Flasher has been swapped out. All turn signal lights come on on both sides front and back.


i think you may have replaced the hazard flasher not the turn signal flasher, the turn signal flasher is located behind the dash on the right side of the steering collum support, the hazard flasher is located in the convenience center.

Jan 14, 2011 | 1995 Chevrolet Cavalier

1 Answer

95 tahoe flasher?


I have a 96 tahoe. Check to see if one of your lights are blown, most likely it is. Whichever turn signal is blinking to fast it'll be on that side, either the front ones or the back ones.

Feb 21, 2009 | 1996 Chevrolet Tahoe

3 Answers

Turn signals


replaced turn signal flashers and muti switch turn signal still won't work Why?

Nov 08, 2008 | 2000 Jeep Grand Cherokee

3 Answers

Blinkers stopped working


Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.

Oct 20, 2008 | 1996 Ford F150 Regular Cab

2 Answers

Location of flasher for turn signal


  1. Access the COMBINATION Turn Signal and Hazard INDICATOR FLASHER on the Left-Hand (drivers) side of the instrument panel in the fuse junction panel.
  1. Remove turn signal flasher/hazard indicator flasher by pulling indicator flasher straight out.
  1. To install, align the terminals of the flasher and press into place.
How about a picture--

388df46.gif

Oct 03, 2008 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
2000 Oldsmobile Intrigue Logo

661 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...