Question about 2003 Nissan Altima

1 Answer

1998 Altima My lights that shows how fast I am going with out and then came bace on and out again. So I open the pannel up and all the blubs was good . I checked all the fuses and they are good. So I tried to run a wire from the door open light to the speed light. Now they are all out.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 34 Answers

You didn't do that... at least i hope you didn't. first of all... all the dash lights are is a piece of carbon covered plastic... a plastic housing... and some light bulbs... and twith what you just said... i hope you didn't burn out the tracks where the light bulbs go... because you are going to have to go to the dealer just to get that stupid piece of carbon covered plastic... and it's going to cost you close to $40 or better... some of thore are as much as $100 or better, first check the fuses and see if you didn't pop one... i hope you did and it works againg for your sake!!!

Posted on Oct 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Flasher signal location ,for anissan altima 1998. I was advised to replace aflasher signal, when make alift signal the light flashes real fast, I bought the part,but dont know where it goes.

which bulb is flashing fast? Its the opposite of whatever bulb is flashhing. EX: if the front left is flaashing fast, the rear is out. The front are accesed under the hood. the rear are accessed thru the trunk by pulling back the carpet behind the tail lights. hope t helps

Mar 12, 2010 | 1998 Nissan Altima

1 Answer

How do you replace the interior light on a 1998 dodge 1500

for the most part you use a small screwdriver to remove the cover be sure to keep the doors close cause when you put the new one in the blub the blub gets hot fast doing it with the doors close keeps you from burning your hand wish you the best of luck Michigan Man.

Nov 27, 2009 | 1998 Dodge Ram 1500 4WD

1 Answer

My rear running lights dont come on when my head lights are on

test the sockets to make sure there is power going to the blub and to make sure the blubs are good and check all grounds and for a loose wire try these websites and wish you the best of luck Michigan Man.

Nov 02, 2009 | 1998 Ford Windstar

1 Answer

Brake lights not working

Should be from inside the trunk.. Undo the pannel molding and you will see how to get to the bulbs from there..

Good luck ;o)

Sep 09, 2009 | 2003 Nissan Altima

1 Answer

Oil light

No oil spiting out the open hole is not a good sign. Im sure you checked the oil level but check it again. Do not run the engine with no oil pressure or it will eat itself up in real fast. The problem could be in the pump itself. They seldom go bad but the some times they will have a clogged pick up screen or shear a pin on the gear.

May 08, 2009 | 1998 Toyota Camry

1 Answer

Day time running lights on a 1998 chev c1500

Ck around the emergency brake. There should be a switch that when the e brake is applied it will cause the lights to go out. Also ck all wire connections and ck that the wires havent been cut by someone who felt like they did not need/want them, and finally have you ensurred the blubs were good?

Feb 18, 2009 | 1998 Chevrolet C1500

1 Answer

How to change a front signal light?

open tail gate unscrew the lens cap and replace the blubs

Oct 13, 2008 | 1998 Jeep Cherokee

1 Answer

Replace light blub in the infromation center on dash

after disassembly of dash and unit is away from dahboard enough to see. you will see fiber optic wires that go into one cluster. the could be white or black. it has one light bulb in that cluster it will twist out for replacement.

Oct 12, 2008 | 1998 Plymouth Voyager

1 Answer

2003 nissan altima problem

is there power TO the brake light switch? adn is there power OUT OF THE BRAKE LIGHT SWITCH?

Aug 01, 2008 | 1995 Nissan Altima

Not finding what you are looking for?
2003 Nissan Altima Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

77169 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides