Question about 2002 Chevrolet Camaro

1 Answer

2002 camaro won't start...

No prior indications of problem of any kind... drove my car home yesterday and shortly after had to run back out. went to start the car (2002 camaro w/ 3.8L v6). radio and dashlights worked fuine, no dead battery ticking, no turnover. just nothing when i turned the key. ended up rolling downhill and dumping clutch (key was on) and it started but still wanted to cut off. i think it may be a security system problem, though pass-2 key chip is intact and clean... any ideas? Thanks!

Posted by on

  • 3 more comments 
  • willi9k Jul 11, 2008

    My car does the same thing. Could this be just the ignition?

  • b2fnbad Oct 31, 2008

    my son has the same problem with his 2001 camaro v6 . the car wont start and the security light will be on. he waits about 15 min. and tries it again,and most times then it will start the security light will be off. he does this every time he goes to drive the car. dealer wants big $$$$ to look at the car...?????????

  • camaro35 Mar 23, 2009

    I went out to my car and it would not start the security light stays on and by the way my camaro is a 2002 6 cylinder but could it be the relay fuse or could it be the key i am going to have the key tested

  • Anonymous Mar 20, 2014

    I have iinstaiied a new switch. The key that came with the new switch does not have the chip in it. Do I need to just get the key re-cut with tte chip in it or does the car have to be re-programmed?

  • Anonymous Mar 31, 2014

    An aftermarket radio was installed in car and now security key locks car from starting for about five minutes. I believe key wire was disconnected from radio hook up but do not know if it goes to power side or ground side on 97 Camaro rs

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 126 Answers

Hi there it seems that your ignition switch is no good try to replace ignition it relativity a cheap part good luck

Posted on Jul 11, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

01 durango 5.9 no bus message but if I wiggle the black connector at the pcm the car starts but shuts down after a minute or so,meaning the fuel will not prime without me doing that ,prior to the no b


Remove the black connector to pcm . Check for corrosion pins . Then inspect the plug end for corrosion. I found moisture seep by the weather pack seal and wire on older vehicles.

Feb 11, 2015 | 2001 Dodge Durango

1 Answer

Plug code reader


Your car went into back up mode. this is usually a serious engine problem or just bad gas.

Apr 20, 2014 | 2006 Chevrolet Corvette

1 Answer

What would cause the door ajar indicator light to remain on when car is off and doors are closed? This is also draining the battery.


Sounds like the wires to the door switch are shorted or the switch is damaged. You may have to remove a kick panel to access the wires.

May 11, 2017 | Hyundai Cars & Trucks

1 Answer

2003 jeep liberty won't start...


have the fault codes read as that will indicate the problem area

Oct 29, 2017 | 2003 Jeep Liberty

1 Answer

2011 v6 camaro engine suddenly missing.


I think you got hold of a batch of stale gasoline, have seen it many times. This happens this time of year because they are using up all the winter blend gas so they can switch to the summer blend..

Apr 23, 2017 | 2011 Chevrolet Camaro

2 Answers

2011 Camaro engine miss-firing


Very hard to diagnose without trouble codes, but sounds like a fuel problem - bad gas, fuel filter plugging, fuel pressure regulator acting up, etc. I would certainly check fuel pressure at the engine with key on but not started, and then while trying to start.

Apr 18, 2017 | 2011 Chevrolet Camaro

1 Answer

2002 grand am won't start


2002 car needs maintenance;tune up,fuel filter,coils,module,battery and connection.

Apr 11, 2013 | 2002 Pontiac Grand Am

Not finding what you are looking for?
2002 Chevrolet Camaro Logo

1,426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...