2001 Chevrolet S-10 Logo

Related Topics:

Posted on Jan 06, 2011

I need to change the vapor canister on my 01 s10 and do not know where it is

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Jul 13, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Jul 13, 2011
Answers
1
Questions
1
Helped
539
Points
1

I have am looking for a vapor canister ( Bracket ) for a chevy 2001 S10 i look all out and no one have one can some one help me find one.

thank you

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the vapor canister on a 2007 Chevy Impala SS?

Have you changed your fuel cap? That is usually the culprit. If that doesn't solve your issue, a simple smoke test will show you where the system is leaking.
0helpful
1answer

2000 cadillac deville Vapor Canister Vent Solenoid

vapor can. is under the hood . usually left front
1helpful
1answer

2002 Nissan Frontier showing a P01444 code

P1444 EVAP Canister Purge Volume Control Solenoid Valve
This system controls flow rate of fuel vapor from the EVAP canister. The opening of the vapor by-pass passage in the EVAP canister purge volume control solenoid valve changes to control the flow rate. The EVAP canister purge volume control solenoid valve repeats ON/OFF operation according to the signal sent from the ECM. The opening of the valve varies for optimum engine control. The optimum value stored in the ECM is determined by considering various engine conditions. When the engine is operating, the flow rate of fuel vapor from the EVAP canister is regulated as the air flow changes.
0helpful
1answer

I have a 2002 s10 pickup that only accepts fuel at a rate of 10 cents at a time before clicking off. the truck was fine until it sat for about a year. now it takes me forever to fuel up. its irritating,...

It sounds like you may have a problem with your fuel vapor canister. It stores fuel vapors and re-routes fumes back to the engine to be used for combustion. The problem may be the canisters fumes are being stored in the tank rather than being stored in the canister. Do you smell fuel vapors inside the cab?
0helpful
1answer

What does p0443 mean for 01 cadillac deville

This is generally a fault with your evaporative canister purge valve or wiring. This is the little guy that allows the engine to pull vapors from your fuel tank. If you need additional info let us know.. Best of Luck.
2helpful
1answer

1996 Ford Aerostar 3.0 L V-6 Constant check engine light ON Ran codes. Code says vacuum leak on fuel canister. I'd like to change all the vacuum lines. Don't have a good schematic. Haynes manual only...

what codes?

The vacuum lines run from the canister to the intake manifold. One is the purge hose to deliver stored fuel vapor to the intake to be burnd when engine is warm and you are crusing at part throttle. The other line is the vacuum line to operate it.

Fuel Vapor Valve, Aerostar (4.0L Engine) The evaporative emission valve (9B593) uses a small orifice, 1.83mm (0.072 inch), that allows vapors to pass into the vapor line running forward to the evaporative emissions canister (EVAP canister) (9D653). This evaporative emission valve mounts directly into the fuel tank (9002) using a fuel vapor separator seal. Fuel vapors trapped in the sealed fuel tank are vented through the orificed evaporative emission valve. The vapors from the fuel tank leave the evaporative emission valve through a single vapor line and continue to the evaporative emissions canister in the engine compartment for storage.
-----------------------------------------------------
Fuel Vapor Canister Purge Regulator Valve, Aerostar, Ranger Removal and Installation
  1. Disconnect wire harness from evaporative emission canister purge valve (EVAP canister purge valve) (9C915).
  1. Disconnect wire harness from thermistor.
  1. Disconnect evaporative emission canister purge valve assembly from fuel vapor canister and throttle body.
  1. To install, reverse removal procedure.
-----------------------------------------------------------------

snorkelbobby_48.gif
5helpful
1answer

I have a 2006 Mazda 5...evap leak...codeP0455...where do I look?

Check the EVAP canister purge solenoid valve for being stuck open. Try to blow through it by mouth. It should be closed and should not be able to blow through it by mouth with it de-energized. Can test it per TSB # 01-025/05. Potential Causes: EVAP Canister Purge Control Solenoid Valve


There is a TSB for these and other possible trouble codes to be set due to a stuck open EVAP canister purge solenoid valve - TSB # 01-025/05. A stuck open EVAP canister purge solenoid valve will also allow fuel vapors from the fuel tank to enter the engine when the fuel tank is being filled - resulting in a hard start condition. The EVAP canister purge solenoid valve is under the hood on the drivers rear of the intake manifold area
0helpful
1answer

Need to know the location of vapor canister

where is vapor canister on 2007 doge caliber located
0helpful
1answer

Need to replace vapor canister

evaporation canister is located under the trunk.
Not finding what you are looking for?

549 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...