Question about 1999 Plymouth Grand Voyager

1 Answer

1998 plymouth voyager battery cable was lose and lost all power. now that it is running fine all the leghts for my a/c and wipers are blinking... i know there is a button or buttons that i can push but can not figure out which one it is. can you please help?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 137 Answers

Yes start van..turn blower on high.. set mode to vent .. set temp to coldest.. you have three buttons on the panel for rear wiper press the top one and bottom one at same time hold them until all the panel lights up then release when its done you will have 2 light flashing only if it was successful.. then turn off engihe and restat.. should be back to normal.. but you must have functioning a/c system for it to work

Posted on Feb 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 plymouth grand voyager windshiield wipers come on and work fine but can't shut off


Turn the key off then engage your e brake one click. Then turn your key on and you will have no lights!--------------------------------------------------------------------------
vas 5054a

Dec 03, 2012 | 1998 Plymouth Voyager

1 Answer

Accessory lights blinking


Try disconnecting battery for a few minutes and then reconnecting.This should take care of problem....best of luck.....

Aug 16, 2012 | 1998 Plymouth Grand Voyager

1 Answer

I have a 1997 plymouth grand voyager. Everything was working fine until my battery died. Replaced battery & now my rear window wiper lights on the dash blink constantly. The wipers work fine when I cut...


What has most likely happened is that the Heater-a/c unit needs to be recalibrated and here are the steps to do so.
With the engine running and fully warmed up, A/C has to be turned off for at least 5 minutes [don't turn it on at all] and transmission in Park do the following
1. Set the temp control all the way to cold
2. Set the mode selector to Vent so air blows out of the dash panel outlets.
3. Hold down the rear washer button and the rear wiper buttons simultaineously for about 5 seconds until most all of the heater and ac panel lights blink and then release both buttons
6. At this point the system should go into a self calibration test which can take up to 60 seconds. While it is calibrating various control panel switch lights will blink as it goes through it's tests.
7. When the system is done calibrating then just the rear wiper light should be flashing and you can exit the test by turning off the vehicle. Wait about 10 seconds and restart the engine and it should be fine. If both the rear wiper and intermittent light are both still flashing after the calibration then there is most likely a problem with the system that will need more diagnosing. I see this fairly often with battery replacements so I think you'll be ok. It sometimes takes a couple of tries to calibrate so don't give up if it doesn't work the first time. Good luck, hope this helps!

Jul 14, 2010 | 1997 Plymouth Grand Voyager

2 Answers

Blinking panel lights


To Calibrate , start and warm engine to normal operating temp. with engine idling turn blower switch to high, turn mode switch to panel, open all outlets, move temp lever to full cold.
press and hold rear wash and rear wiper buttons simultaneously for 5 seconds (untill all leds illuminate.) all leds should light up for 5 seconds, rear wiper and intermittent rear wiper button leds will flash alternatly during calibration... after 60 seconds if only rear wiper button led is flashing, cal. is complete

Jun 18, 2009 | 1998 Plymouth Voyager

1 Answer

1998 plymouth voyager lights on dash concerning a/c controls


have a look at this link, may sure you go far enough to read alternative # 3 solution.

http://www.allpar.com/fix/codes-climate.html

Mar 13, 2009 | 1999 Plymouth Grand Voyager

2 Answers

99 voyager no crank, wipers, radio and power windows. bcm?


Check power distribution panel near battery for blown fuses.

Feb 08, 2009 | 1999 Plymouth Grand Voyager

1 Answer

Blinking lights


reset your computer, do this by removing thepositive battery cable for 10 mins.......

if this doe snot work, then some thing went bad when the van was jumped.

Oct 01, 2008 | 1998 Plymouth Grand Voyager

Not finding what you are looking for?
1999 Plymouth Grand Voyager Logo

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6869 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...