- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
P0102 - Mass Air Flow (MAF) Circuit Low Input Basically this means that there is a problem with the Mass Air Flow (MAF) sensor or circuit. A more technical description would be that the MAF circuit had lower than expected voltage (air flow). A code P0102 may mean that one or more of the following has happened:
The MAF may be disconnected, or a wiring connection may be bad
The MAF may be dirty or otherwise contaminated (Note: if you use a reusable
oiled air filter, be careful not to apply too much oil or that can contaminate
The MAF sensor may be faulty
The vehicle computer may be faulty (very rare)
Contact us if you need additional details. Good luck.
The radio comes with a preassigned lock code that must be obtained from Pontiac. They will need you to follow these steps to retrieve two sets of numbers for them to call GM and obtain the assign lock code for your radio. STEP ONE: Press number 2 and number 3 simultaneously. Hold until the first set of numbers appear. Then press the AM/FM button on the radio for the last set of numbers to appear. Give those numbers to Pontiac, and they will call for the radio lock code. They will also provide you the steps to enter that code to unlock your radio.
go to walmart find your cd player, dash kit ,wiring kit and then this is what you do .. remove the old radio attach the wiring harnes you bought to the factory wiring harnes this will allow you to match the color code up for your new radio with out cuting wires then install the new dash kit witch will allow you to install your cd player with a factory look this should be everything ou need to know
do you have a test light?your speaker wires should be four sets of matching color,dark/light blue,dark/light green,dark/light purple and one other matching set of colors. then there should be one black wire which should be ground.with a test light you can find your power and accesory wires. your power wire will always have power with key on or off,the acc wire will only have power when key on. i hope this will help.