Question about 1994 Pontiac Grand Prix

1 Answer

The car actls like it is going to stall when putting on the gas. To go at least 50

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 77 Answers

The probable solution(s) to your problem could be fouled spark plugs, bad spark plug wires, dirty fuel filter, I would suggest a basic tune-up of changing what was mentioned and treating your fuel system with a fuel system treatment.

Good Luck

Posted on Jan 04, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 dodge ram 1500 with 5.7 hemi intermittently stalls when I get about 2 blocks from gas station. I stop at first click. I have ran seafoam and used throttle body cleaner.


Lol is it because you only put 50 cents of fuel in... in all seriousness it could be any number of things... bad fuel, ( water in tank) bad fuel pump, bad ignition ( especially if you have a lot of crap on the key chain as the extra weight can short out the ignition switch after a while), over heating, bad wires... so you can see this one is hard to diagnose. However if you are going to use sea foams then put is straight into the gas tank. Just read bk to see if it is able to be added to gas tank... going straight into throttle body isn't a great idea as it doesn't get mixed with enough fuel.

May 03, 2015 | Dodge Cars & Trucks

2 Answers

What would cause a 2006 suzuki to die when stepping on gas


Not too sure, sounds like your vechicle isn't getting any gas. Could be anthing from a hose to a gas pump.

Jun 14, 2014 | 2006 Suzuki Verona

1 Answer

Stuttering acceleration


Has the engine light come on yet?

Mar 28, 2014 | Chevrolet Cars & Trucks

1 Answer

After a full tank of gas car would stall out, after restarting and driving for 2 miles car was hesitant and then would stall out again, I was told it was the catalytic converter and then the o2 sensor and...


50/50...
tries to fill the tank and don't mount filler cap into gas tank. don't leave immediately the gas station but go after 5 minutes and see if the problem appear more than 2 miles.
deactivates the carbon filter before filling the tank completely
If the problem recurs with fuel cap without being mounted, IT IS NOT charcoal filter

Sep 15, 2013 | Pontiac G6 Cars & Trucks

1 Answer

Car stalls when engine is warm


Your TPS switch is bad. It is caled Throudle Pision Sencer. It is on the side of the throdle body and has two wires going to it. It is not reading where the throdle is so therefor it stalls.

Dec 01, 2012 | 1988 Chevrolet Cavalier Z24

1 Answer

When I first try to start the car, ignition only, no gas pedal, the car will run then stall. This will happen multiple times until I apply full gas pedal and race the engine. Radio will get louder and...


Problem with idle control valve, is located underneath throttle body, you can clean the valve, but there is 50 50 chances that is going to help also may get worst, I would recommend replacement.

Jan 11, 2011 | 1999 Toyota Avalon

1 Answer

88 wrangler stalling 5 speed 4 cyl


Was there any water in the tank? Has anyone changed the fuel filter? Has anyone checked the ceramic ballast resistor on the drivers fender near the master cylinder?
Has anyone checked the crank sensor output? Did anyone see if it will run if you spray carb cleaner into the throttle body after starting? Are there pulses present at injector? You need to verify these things to get some idea what is going on there.

Dec 21, 2009 | 1988 Jeep Wrangler

2 Answers

Loses the power and starts stalling


The IAC valve requires resetting .
First locate the IAC valve located on the side of the throttle body and has 4 wires going to it .Procedure is as follows
Ignition key on ,unplug the IAC ,turn key off ,reconnect the IAC .do this 3-4 times .restart the car and hold the rpm at 2000 rpm and slowly lower until it idles by it self .

Jan 17, 2009 | 2000 Daewoo Nubira

1 Answer

Engine cuts out


it sounds like you may have inadequate fuel pressure or restricted catalyc converter.

Sep 21, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
1994 Pontiac Grand Prix Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...