Question about Mitsubishi Outlander

Open Question

I have a1993 mitsubishi pajero the abs light always goes on and the brakes seems perform well what would have cost the abs light goes on???

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: abs brake light always on

Sounds like this could be a front or rear wheel sensor. You need to check the trouble code by placing a wire short across the test connector located under the dash near the radio center console. This is a blue, two pin connector plugged into a holder. placing a short wire across the two termnals and turning the key on to the II On Position will start the ABS light flashing. Do nt start the engine, just turn the key switch on.

Count the number of flashes. The first group of flashes followed by the next group of flashes. For example, four (4) flashes followed by the next group of eight (8) flashes points to the left driver side rear wheel speed sensor. check the resistance (continuity) with a meter. It should read about 1240 ohms. A resistance of 0 -100 ohms is a bad sensor. Cost of a sensor is about $126 but it is not easy to install since the old one usually is hard to remove.

Bottom line is that the ABS system probably does not work properly because the light is on. The regular brakes are OK.

Posted on Oct 17, 2008

Ad
mechanicm639
  • 253 Answers

SOURCE: my abs light is always on and now my brake warning light is on but brakes seem to be working fine

The ABS light is a warning that you have an issue with the ABS system. The red brake warning lamp is serious. It is telling you that there is an issue with the base brakes. Your car will be ok with an ABS light, but the red warning lamp could be really dangerous. You should have them checked ASAP. It could be from many causes. A park brake switch, low fluid, the causes are too numerous to list. Please for your safty have it checked. Good Luck

Posted on May 29, 2009

  • 64 Answers

SOURCE: My abs light and brake light are always on.

Low brake fluid or hand brake could be stuck on.

Posted on Jul 01, 2009

carlsbiz
  • 1124 Answers

SOURCE: brake lights always on pajero 91

Sounds very tipical of the break light switch..

Usually located at the break pedal lever just above the foot peddle..
Shouldnt cost to much ;o)

Hope this helps !!
Please rate me good ;o)

Posted on Jul 11, 2009

  • 456 Answers

SOURCE: MITSUBISHI PAJERO abs brake light

hi.
it could be as simple as cleaning a sensor, or it could be as expensive as replacing the abs unit.

the most likely is a faulty sensor which would not be to expensive, but there is no way for me to even guess prices.
the only way you can know is to get the car plugged into a diagnostic unit and see what it says.

sorry i cannot be any more help, but it would be unfair of me to give any ideas of cost as it would be pure guesswork on my part until a diagnostic test tells you where the problem actually is.

Posted on Feb 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replaced the front bumbler of my Mitsubishi Pajero 2002 and end up with abs warning light and brake faulty light on together with the buzzer on. Why was that happened?


probably you fouled the wires going to the ABS sensor at the front wheel hub. it has a connector, maybe it got separated. hope this helps

Mar 25, 2017 | 2002 Mitsubishi Pajero

1 Answer

I was driving my Mitsubishi Pajero to work and suddenly shows the ABS warning light and the alarm buzzer also coming together.


Pls check ABS sensors and cabling of sensors to ABS control unit. Sensor visible damage or cable/connector problem?
If none of these, the MUT II tester will tell you where to look
Regards Winfried

Mar 23, 2017 | Mitsubishi Pajero Cars & Trucks

1 Answer

Abs brakes ******* 2001 mitsabishi pajero replace two sensor with second hand told do i need to reset something


if the abs light is still on after changing the parts
then yes need to clear the lights with code reader.

some time if the car left with battery disconnected for 30 mins
it some time resets the computer and clear the fault

Sep 18, 2016 | 2001 Mitsubishi Pajero

1 Answer

Can you buy replacement cencser for Brake booster


yes you can buy what is required
....
is this an ABS warning light ?
or brake failure light

....

Jul 14, 2016 | Mitsubishi Cars & Trucks

1 Answer

Mitsubishi 2008 did not work and get ABS light


Check the fuses and connections on brakes for abs.

My answers are short and sweet. Common sense mostly. If you are trying to get something for nothing...Don't waste my time! Remember if something sounds to good to be true that it usually is. I've spent many years of my life trying to cheat the system and was pretty good at it. This all changed when I discovered that people were doing the same thing to me. What comes around, goes around. Karma! Now I assist people in making win-win deals...that are legit!

Dec 31, 2014 | 2008 Mitsubishi Pajero 3.2

1 Answer

Mitsubishi shogun pajero 1994, does bleeding of brakes have to have special tools to do the job ?


If it has ABS brakes then yes it requires a special tool to bleed the ABS control valve.

Jun 18, 2012 | Cars & Trucks

1 Answer

ABS light comes on after 20 miles on Montero Sport 2000. It goes off when car is turned off and then on again after 20 or so miles.  Breaks seem to work fine.


ABS light is turned on when there is an anomoly in the Wheel Speed Sensor data coming to the ABS Brake module.

Have the car scanned by a brake specialist who will have an OBD-II ABS Brake Scan Tool.

If you want to diagnose it yourself, Actron makes a very good one that costs about $99 plus shipping depending on where you get it from.

I bought one with shipping included for $116 off of Amazon.com for my car.

Good luck.

Jul 11, 2010 | 2000 Mitsubishi Montero Sport

3 Answers

How can i deactivate the ABS in my Mitsubishi Pajero 1999.


I have a 1999 mitsubushi pajero GDI 3.5. The ABS and brake lights went on while at a trafic sign. l then lost the brakes after about 100m. l tried switching the car on and off but the lights still appear and no brakes. Please help.

Feb 17, 2010 | 2002 Mitsubishi Montero

2 Answers

Brake lights always on pajero 91


Sounds very tipical of the break light switch..

Usually located at the break pedal lever just above the foot peddle..
Shouldnt cost to much ;o)

Hope this helps !!
Please rate me good ;o)

Jul 11, 2009 | 2002 Mitsubishi Montero

1 Answer

Mitsubishi Pajero, 1999, DiD, Abs and brake light on, no brakes!!


2002 Montero has high pitch sound from dash and brakes are hard

Nov 12, 2008 | 2002 Mitsubishi Montero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8560 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...