Question about 1992 Ford Explorer

1 Answer

Sorry for not very detailed but keep blowing eec fuse on 92 explorer. I tracked it to a set of wires that goes to tranny red wire gets hot when I jump circuit. I need a wiring diagram to track wire and figure out this short. Pulling hair out cause of stress Oh wire tracking my email is

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 20 questions.


    An expert that has over 10 points.

  • Expert
  • 92 Answers

Just had the same thing about a month ago. Solenoid in the trans shorted out or wiring.

Posted on Jan 04, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

92 isuzu rodeo pig tail wires touched and shorted out put new fuses brake light switch and relay still no brake lights and only half fuse panel under hood is firing

automatic or stick shift???????????????????

firing? what is or is not firing?

please post the full story.
pig tails where.?
what started all this. fiddling.?
no brake lights. got that , was this the beginning? problem
ok ill give you the schematic, (mitchells has it , 24/7 so can you)
if you short wires, fuses will blow. or far worse.
here it is, very very simple system,
fuse, switch wires and bulbs.
see that 1st red wire below switch
step on switch it goes to 12vdc and fuse must not blow.
if fuse blows, that line is shorted.
its that simple
but finding shorts I use a circuit breaker device
and ammeter, to find it, (ask if tools can be bought)
lacking tools, only inspecting ever inch of red wire is a cure.


Mar 02, 2016 | Isuzu Cars & Trucks

2 Answers

Eec engine fuse blowing. is the red injector wires supposed to be reading an engine ground in a continuity test with multimeter?

red wires are normally hot or power wires and if going to ground then that is a short that will blow fuses

Jun 07, 2015 | Cars & Trucks

1 Answer

Eec fuse blowed while driving and blows each time replace it

must have a short to earth ,would'nt advise using wire no matter what the situation,trace the wires and find a break or worn part , might be rubbing against a metal edge somewhere

Apr 02, 2014 | 1994 Ford Explorer Limited

1 Answer

Ford explorer fuses keeps popping for brake switch

To start with, it is impossible to look the wiring diagrams up or check to see what circuits the fuse protects if you do not mention WHICH fuse is blowing. It would also be very helpful to mention WHICH ENGINE and what type of TRANSMISSION your truck is equipped with because the wiring diagrams are different.

Also, WHAT grounds have continuity? Continuity to WHAT??? If you are trying to fix a fuse that keeps blowing, WHY are you checking GROUNDS??? Why do you have the brake switch off? It is not necessary to remove the brake switch to see if it is working.

I have no idea what "hot" you are talking about. The hot from the brake pedal switch? The two wires on the brake pedal switch on a 2000 Ford Explorer are LIGHT GREEN and LIGHT GREEN/RED...I have no clue what "blacks" you are talking about.

Try to make a little sense here and I will see if I can help you.

May 12, 2012 | 2000 Ford Explorer

1 Answer

PCM fuse keeps blowing

It's possible you ran the battery down, trying to start? Have to make sure battery has a full charge and battery connections all good. If battery is down, have to use a charger and get it charged, we can't test anything if battery is down.
I did look at power distribution wiring diagram for your vehicle, I found pcmB fuse--20 amp. Two fuse legs goes to pcm, the other goes to load side of fuel pump relay. If I had to guess, I'd say the fuel pump has a problem. If the wiring before the fuel pump relay or the pcm was the problem, then the fuse would blow as soon as soon as you plug it in. The fuse circuit shows to be hot all the time. Just my opinion. There might be other issues, but, I can't track it from where I am.

Aug 06, 2017 | 2005 GMC Yukon XL

1 Answer

92 ford explorer battery drains power while sitting I put a test light between pos post and pos cable while truck is turned off test light glow I pull the eec relay fuse and the light goes out can anyone...

You may have considered this ... arrange a volt/ohm meter like you did the light ... set it up for amps ... there should be some reading ... remove the fuses one at a time, until the meeter reads zero amps. When it gets to zero, you are almost home. Explore that circuit to find your trouble.

May 05, 2010 | 1991 Ford Explorer

1 Answer

EEC relay fuse keeps blowing id put a new fuse in the truck it would run for about 10 seconds then blow the fuse again.

There are 3 relays mounted below the fuse box .
The green I believe is fuel pump relay and the brown is EEC. The third relay is for the A/C WOT.
It is possible the wiring is shorted, check there, it is also possible you have a bad fuel pump.
Please let me know what you find.

Feb 07, 2010 | 1991 Ford Explorer

1 Answer

EEC fuse: 1992 ford explorer

sounds like you have a bad relay that is shorted out or you might have a bad fuel injector shorting out fossible fuel pump wireing short do some probing aroun with the multi meter try to find direct short , use the process of elimination .
now let me see does your truck start up and run then fuse blows? is the fuse the correct amperage check your owners manual to see how long does it run before blowing fuse ? when its running is it running smooth while is running?

Jul 03, 2008 | 1992 Ford Explorer

2 Answers

E.E.C fuse keeps blowing in 1991 Ford Explorer

sounds like you got a short try tracing harness to see if theres anything visible

May 26, 2008 | 1991 Ford Explorer

Not finding what you are looking for?
1992 Ford Explorer Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers


Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides